- 您現在的位置：買賣IC網 > PDF目錄373898 > AD7391ARU-REEL (ANALOG DEVICES INC) 3 V Serial-Input Micropower 10-Bit and 12-Bit DACs PDF資料下載
參數資料
| 型號： | AD7391ARU-REEL |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | DAC |
| 英文描述： | 3 V Serial-Input Micropower 10-Bit and 12-Bit DACs |
| 中文描述： | SERIAL INPUT LOADING, 70 us SETTLING TIME, 10-BIT DAC, PDSO8 |
| 封裝： | 1.10 MM HEIGHT, TSSOP-8 |
| 文件頁數： | 10/12頁 |
| 文件大?。?/td> | 199K |
| 代理商： | AD7391ARU-REEL |
REV. A
AD7390/AD7391
–10–
UNIPOLAR OUTPUT OPERATION
This is the basic mode of operation for the AD7390. As shown
in Figure 10, the AD7390 has been designed to drive loads as
low as 5 k
in parallel with 100 pF. The code table for this
operation is shown in Table IV.
AD7390
0.1 F
CLK
SDI
CLR
V
OUT
REF
V
DD
GND
R
10 F
6
7
5
1
4
2
3
LD
2.7V TO 5.5V
R
5k
C
100pF
C
RS
EXT
REF
0.01 F
Figure 10. AD7390 Unipolar Output Operation
Table IV. AD7390 Unipolar Code Table
Hexadecimal
Number
in DAC Register
Decimal
Number
in DAC Register
Output
Voltage (V)
V
REF
= 2.5 V
2.4994
1.2506
1.2500
1.2494
0
FFF
801
800
7FF
000
4095
2049
2048
2047
0
The circuit can be configured with an external reference plus
power supply, or powered from a single dedicated regulator or
reference, depending on the application performance requirements.
BIPOLAR OUTPUT OPERATION
Although the AD7391 has been designed for single-supply opera-
tion, the output can be easily configured for bipolar operation.
A typical circuit is shown in Figure 11. This circuit uses a clean
regulated 5 V supply for power, which also provides the circuit
’
s
reference voltage. Since the AD7391 output span swings from
ground to very near 5 V, it is necessary to choose an external
amplifier with a common-mode input voltage range that extends
to its positive supply rail. The micropower consumption OP196 has
been designed just for this purpose and results in only 50 micro-
amps of maximum current consumption. Connection of the equally
valued 470 k
resistors results in a differential amplifier mode
of operation with a voltage gain of two, which results in a circuit
output span of ten volts, that is, 25 V to 15 V. As the DAC is
programmed with zero-code 000
H
to midscale 200
H
to full-scale
3FF
H
, the circuit output voltage V
O
is set at 25 V, 0 V and 15 V
(minus 1 LSB). The output voltage V
O
is coded in offset binary
according to Equation 4.
V
D
O
=
×
512
1
5
–
(4)
where
D
is the decimal code loaded in the AD7391 DAC register.
Note that the LSB step size is 10/1024 = 10 mV. This circuit has
been optimized for micropower consumption including the 470 k
gain setting resistors, which should have low temperature coeffi-
cients to maintain accuracy and matching (preferably the same
material, such as metal film). If better stability is required, the power
supply could be substituted with a precision reference voltage such
as the low dropout REF195, which can easily supply the circuit
’
s
162
μ
A of current, and still provide additional power for the
load connected to V
O
. The micropower REF195 is guaranteed
to source 10 mA output drive current, but only consumes 50
μ
A
internally. If higher resolution is required, the AD7390 can be
used with the addition of two more bits of data inserted into the
software coding, which would result in a 2.5 mV LSB step size.
Table V shows examples of nominal output voltages V
O
provided
by the Bipolar Operation circuit application.
C
I
SY
< 162 A
BIPOLAR
OUTPUT
SWING
–
5V
V
O
+5V
–
5V
V
OUT
AD7391
V
DD
REF
GND
+5V
< 100 A
470k
470k
< 50 A
OP196
DIGITAL INTERFACE CIRCUITRY OMITTED FOR CLARITY
Figure 11. Bipolar Output Operation
Table V. Bipolar Code Table
Hexadecimal
Number
in DAC Register
Decimal
Number
in DAC Register
Analog
Output
Voltage (V)
3FF
201
200
1FF
000
1023
513
512
511
0
4.9902
0.0097
0.0000
–
0.0097
–
5.0000
MICROCOMPUTER INTERFACES
The AD7390 serial data input provides an easy interface to a
variety of single-chip microcomputers (
μ
Cs). Many
μ
Cs have a
built-in serial data capability which can be used for communi-
cating with the DAC. In cases where no serial port is provided,
or it is being used for some other purpose (such as an RS-232
communications interface), the AD7390/AD7391 can easily be
addressed in software.
Twelve data bits are required to load a value into the AD7390.
If more than 12 bits are transmitted before the load
LD
input
goes high, the extra (i.e., the most-significant) bits are ignored.
This feature is valuable because most
μ
Cs only transmit data
in 8-bit increments. Thus, the
μ
C sends 16 bits to the DAC
instead of 12 bits. The AD7390 will only respond to the last
12 bits clocked into the SDI input, however, so the serial-data
interface is not affected.
Ten data bits are required to load a value into the AD7391. If
more than 10 bits are transmitted before load
LD
returns high,
the extra bits are ignored.
相關PDF資料 |
PDF描述 |
|---|---|
| AD7391ARU | +3 Volt Serial-Input Micropower 10-Bit & 12-Bit DACs |
| AD7390AN | 3 V Serial-Input Micropower 10-Bit and 12-Bit DACs |
| AD7390AR | 3 V Serial-Input Micropower 10-Bit and 12-Bit DACs |
| AD7390AR-REEL7 | 3 V Serial-Input Micropower 10-Bit and 12-Bit DACs |
| AD7391AN | +3.3V, 622Mbps SDH/SONET Laser Driver with Current Monitors and APC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7391ARUZ | 功能描述:IC DAC 10BIT SRL 8TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:* |
| AD7391ARUZ-REEL | 功能描述:IC DAC 10BIT SRL 8TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD7391ARZ | 功能描述:IC DAC 10BIT 3V SRL-IN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF) |
| AD7391ARZ | 制造商:Analog Devices 功能描述:IC 10-BIT MICROPOWER DAC |
| AD7391ARZ-REEL | 功能描述:IC DAC 10BIT 3V SRL-IN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。