參數資料
型號: AD743JR-16
廠商: Analog Devices Inc
文件頁數: 2/12頁
文件大?。?/td> 0K
描述: IC OPAMP BIFET 4.5MHZ LN 16SOIC
標準包裝: 47
放大器類型: J-FET
電路數: 1
轉換速率: 2.8 V/µs
-3db帶寬: 4.5MHz
電流 - 輸入偏壓: 250pA
電壓 - 輸入偏移: 250µV
電流 - 電源: 8.1mA
電流 - 輸出 / 通道: 40mA
電壓 - 電源,單路/雙路(±): 9.6 V ~ 36 V,±4.8 V ~ 18 V
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 16-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 16-SOIC W
包裝: 管件
REV. E
–10–
AD743
AN INPUT IMPEDANCE COMPENSATED, SALLEN-KEY
FILTER
The simple high-pass filter of Figure 13 has an important source
of error which is often overlooked. Even 5 pF of input capacitance
in amplifier A will contribute an additional 1% of pass-band ampli-
tude error, as well as distortion, proportional to the C/V characteristics
of the input junction capacitance. The addition of the network
designated Z will balance the source impedance—as seen by
A—and thus eliminate these errors.
A
500k
1000pF
+VS
–VS
Z
1000pF
500k
Z
Figure 13. Input Impedance Compensated
Sallen-Key Filter
TWO HIGH PERFORMANCE ACCELEROMETER
AMPLIFIERS
Two of the most popular charge-out transducers are hydrophones
and accelerometers. Precision accelerometers are typically cali-
brated for a charge output (pC/g).
* Figures 14a and 14b show
two ways in which to configure the AD743 as a low noise charge
amplifier for use with a wide variety of piezoelectric accelerom-
eters. The input sensitivity of these circuits will be determined
by the value of capacitor C1 and is equal to
V
Q
C
OUT
=
1
The ratio of capacitor C1 to the internal capacitance (CT) of the
transducer determines the noise gain of this circuit (1 + CT/C1).
The amplifier’s voltage noise will appear at its output amplified
by this amount. The low frequency bandwidth of these circuits
will be dependent on the value of resistor R1. If a T network is
used, the effective value is R1(1 + R2/R3).
AD743
R2
9k
R1
110M
(5
22M )
OUTPUT
0.8mV/pC*
C1
1250pF
R3
1k
B AND K MODEL
4370 OR
EQUIVALENT
*pC = PICOCOULOMBS
g = EARTH’S GRAVITATIONAL CONSTANT
Figure 14a. Basic Accelerometer Circuit
AD743
R3
1k
R2
9k
R4
18M
R1
110M
(5
22M )
R5
18M
OUTPUT
0.8mV/pC
C1
1250pF
C3
2.2 F
C2
2.2 F
B AND K MODEL
4370 OR
EQUIVALENT
AD711
Figure 14b. Accelerometer Circuit Using a DC
Servo Amplifier
A dc servo loop (Figure 14b) can be used to assure a dc output
which is <10 mV, without the need for a large compensating
resistor when dealing with bias currents as large as 100 nA. For
optimal low frequency performance, the time constant of the
servo loop (R4C2 = R5C3) should be
Time Cons
R
C
tant
≥+
10 1 1
2
3
1
LOW NOISE HYDROPHONE AMPLIFIER
Hydrophones are usually calibrated in the voltage out mode.
The circuits of Figures 15a and 15b can be used to amplify the
output of a typical hydrophone. Figure 15a shows a typical
dc-coupled circuit. The optional resistor and capacitor serve
to counteract the dc offset caused by bias currents flowing through
resistor R1. Figure 15b, a variation of the original circuit, has a
low frequency cutoff determined by an RC time constant equal to
Time Cons
t
C
tan
=
××
1
2
100
π
R2
1900
R4*
108
R1
108
R3
100
OUTPUT
AD743
*OPTIONAL, SEE TEXT
INPUT SENSITIVITY = –179 dB re. 1V/ Pa**
**1V PER MICROPASCAL
B AND K TYPE 8100
HYDROPHONE
CT
C1*
Figure 15a. Basic Hydrophone Amplifier
相關PDF資料
PDF描述
AD744JRZ-REEL7 IC OPAMP BIFET 13MHZ PREC 8SOIC
AD745KR-16 IC OPAMP BIFET 20MHZ ULN 16SOIC
AD746JN IC OPAMP BIFET 13MHZ DUAL 8DIP
AD781JN IC AMP SAMPLE HOLD LP 5MA 8DIP
AD783JQ IC AMP SAMPLE HOLD LP 5MA 8CDIP
相關代理商/技術參數
參數描述
AD743JR-16-REEL 功能描述:IC OPAMP BIFET 4.5MHZ LN 16SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源,單路/雙路(±):4.5 V ~ 38 V,±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商設備封裝:8-SOIC 包裝:帶卷 (TR)
AD743JR-16-REEL7 功能描述:IC OPAMP BIFET 4.5MHZ LN 16SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源,單路/雙路(±):4.5 V ~ 38 V,±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商設備封裝:8-SOIC 包裝:帶卷 (TR)
AD743JRZ-16 功能描述:IC OPAMP BIFET 4.5MHZ LN 16SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源,單路/雙路(±):2.7 V ~ 12 V,±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT
AD743JRZ-16-REEL 功能描述:IC OPAMP BIFET 4.5MHZ LN 16SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:150 系列:- 放大器類型:音頻 電路數:2 輸出類型:- 轉換速率:5 V/µs 增益帶寬積:12MHz -3db帶寬:- 電流 - 輸入偏壓:100nA 電壓 - 輸入偏移:500µV 電流 - 電源:6mA 電流 - 輸出 / 通道:50mA 電壓 - 電源,單路/雙路(±):4 V ~ 32 V,±2 V ~ 16 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:8-TSSOP 包裝:管件
AD743JRZ-16-REEL7 功能描述:IC OPAMP BIFET 4.5MHZ LN 16SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源,單路/雙路(±):4.5 V ~ 38 V,±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商設備封裝:8-SOIC 包裝:帶卷 (TR)