參數資料
型號: AD7477AARM
廠商: ANALOG DEVICES INC
元件分類: ADC
英文描述: Low-Power, 622Mbps Limiting Amplifiers with Chatter-Free Power Detect for LANs
中文描述: 1-CH 10-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO8
封裝: MO-187AA, MSOP-8
文件頁數: 12/20頁
文件大?。?/td> 360K
代理商: AD7477AARM
REV. D
–12–
AD7476/AD7477/AD7478
INPUT FREQUENCY – Hz
–50
10k
T
–55
–60
–65
–70
–75
100k
1M
–80
–85
–90
V
DD
= 2.35V
V
DD
= 2.7V
V
DD
= 5.25V
V
DD
= 4.75V
V
DD
= 3.6V
Figure 9. THD vs. Analog Input Frequency, f
S
= 993 kSPS
INPUT FREQUENCY – Hz
–72
10k
T
–74
–76
–78
–80
100k
1M
–82
–84
V
DD
= 2.35V
V
DD
= 2.7V
V
DD
= 5.25V
V
DD
= 4.75V
V
DD
= 3.6V
Figure 10. THD vs. Analog Input Frequency, f
S
= 605 kSPS
Digital Inputs
The digital inputs applied to the AD7476/AD7477/AD7478 are
not limited by the maximum ratings that limit the analog inputs.
Instead, the digital inputs applied can go to 7 V and are not
restricted by the V
DD
+ 0.3 V limit as on the analog inputs. For
example, if the AD7476/AD7477/AD7478 were operated with a
V
DD
of 3 V, then 5 V logic levels could be used on the digital
inputs. However, it is important to note that the data output on
SDATA will still have 3 V logic levels when V
DD
= 3 V. Another
advantage of SCLK and
CS
not being restricted by the V
DD
+
0.3 V limit is the fact that power supply sequencing issues are
avoided. If
CS
or SCLK is applied before V
DD
, there is no risk of
latch-up as there would be on the analog inputs if a signal greater
than 0.3 V was applied prior to V
DD
.
MODES OF OPERATION
The mode of operation of the AD7476/AD7477/AD7478 is
selected by controlling the (logic) state of the
CS
signal during a
conversion. There are two possible modes of operation, Normal
mode and Power-Down mode. The point at which
CS
is pulled
high after the conversion has been initiated will determine whether
or not the AD7476/AD7477/AD7478 will enter Power-Down
mode. Similarly, if already in power-down,
CS
can control
whether the device will return to normal operation or remain in
power-down. These modes of operation are designed to provide
flexible power management options. These options can be chosen
to optimize the power dissipation/throughput rate ratio for different
application requirements.
Normal Mode
This mode is intended for fastest throughput rate performance,
as the user does not have to worry about any power-up times
with the AD7476/AD7477/AD7478 remaining fully powered all
the time. Figure 11 shows the general diagram of the operation
of the AD7476/AD7477/AD7478 in this mode.
The conversion is initiated on the falling edge of
CS
as described
in the Serial Interface section. To ensure the part remains fully
powered up at all times,
CS
must remain low until at least 10
SCLK falling edges have elapsed after the falling edge of
CS
. If
CS
is brought high any time after the tenth SCLK falling edge,
but before the sixteenth SCLK falling edge, the part will remain
powered up but the conversion will be terminated and SDATA
will go back into three-state. Sixteen serial clock cycles are
required to complete the conversion and access the complete
4 LEADING ZEROS + CONVERSION RESULT
CS
SCLK
SDATA
1
10
16
Figure 11. Normal Mode Operation
1
10
16
2
THREE-STATE
CS
SCLK
SDATA
Figure 12. Entering Power-Down Mode
相關PDF資料
PDF描述
AD7477AARM-REEL 2.35 V to 5.25 V, 1 MSPS, 12-/10-/8-Bit ADCs in 6-Lead SC70
AD7477AARM-REEL7 +3.0V to +5.5V, 1.25Gbps/2.5Gbps Limiting Amplifiers
AD7477ART +3.0V to +5.5V, 1.25Gbps/2.5Gbps Limiting Amplifiers
AD7477ART-500RL7 622Mbps LAN/WAN Laser Driver with Automatic Power Control and Safety Shutdown
AD7477ART-REEL 622Mbps LAN/WAN Laser Driver with Automatic Power Control and Safety Shutdown
相關代理商/技術參數
參數描述
AD7477AARM-REEL 制造商:Analog Devices 功能描述:ADC SGL SAR 1MSPS 10-BIT SERL 8MSOP - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:10-BIT LOW POWER ADC IN USOIC PKG I.C - Tape and Reel
AD7477AARM-REEL7 制造商:Rochester Electronics LLC 功能描述:10-BIT LOW POWER ADC IN USOIC PKG I.C - Tape and Reel 制造商:Analog Devices 功能描述:
AD7477AARMZ 功能描述:IC ADC 10BIT 1MSPS 8-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率(每秒):20M 數據接口:并聯 轉換器數目:2 功率耗散(最大):155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP(7x7) 包裝:Digi-Reel® 輸入數目和類型:4 個單端,單極;2 個差分,單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
AD7477AARMZ-REEL 功能描述:IC ADC 10BIT 1MSPS 8-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
AD7477AARMZ-REEL7 功能描述:IC ADC 10BIT 1MSPS 8-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494