參數資料
型號: AD7541AKPZ
廠商: Analog Devices Inc
文件頁數: 4/8頁
文件大?。?/td> 0K
描述: IC DAC 12BIT MULT MONO 20PLCC
產品培訓模塊: Data Converter Fundamentals
DAC Architectures
標準包裝: 49
設置時間: 600ns
位數: 12
數據接口: 并聯
轉換器數目: 1
電壓電源: 單電源
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 20-LCC(J 形引線)
供應商設備封裝: 20-PLCC(9x9)
包裝: 管件
輸出數目和類型: 2 電流,單極;2 電流,雙極
采樣率(每秒): *
AD7541A
–4–
REV. B
GENERAL CIRCUIT INFORMATION
The simplified D/A circuit is shown in Figure 1. An inverted
R-2R ladder structure is used—that is, the binarily weighted
currents are switched between the OUT1 and OUT2 bus lines,
thus maintaining a constant current in each ladder leg indepen-
dent of the switch state.
10k
10k
10k
20k
20k
20k
20k
20k
S1
S2
S3
S12
VREF
OUT2
OUT1
RFEEDBACK
BIT 12 (LSB)
BIT 3
BIT 2
BIT 1 (MSB)
DIGITAL INPUTS (DTL/TTL/CMOS COMPATIBLE)
LOGIC: A SWITCH IS CLOSED TO IOUT1 FOR
ITS DIGITAL INPUT IN A "HIGH" STATE.
10k
Figure 1. Functional Diagram (Inputs HIGH)
The input resistance at VREF (Figure 1) is always equal to RLDR
(RLDR is the R/2R ladder characteristic resistance and is equal to
value “R”). Since RIN at the VREF pin is constant, the reference
terminal can be driven by a reference voltage or a reference
current, ac or dc, of positive or negative polarity. (If a current
source is used, a low temperature coefficient external RFB is
recommended to define scale factor.)
EQUIVALENT CIRCUIT ANALYSIS
The equivalent circuits for all digital inputs LOW and all digital
inputs HIGH are shown in Figures 2 and 3. In Figure 2 with all
digital inputs LOW, the reference current is switched to OUT2.
The current source ILEAKAGE is composed of surface and junc-
tion leakages to the substrate, while the I/4096 current source
represents a constant 1-bit current drain through the termina-
tion resistor on the R-2R ladder. The ON capacitance of the
output N-channel switch is 200 pF, as shown on the OUT2
terminal. The OFF switch capacitance is 70 pF, as shown on
the OUT1 terminal. Analysis of the circuit for all digital inputs
HIGH, as shown in Figure 3 is similar to Figure 2; however, the
ON switches are now on terminal OUT1, hence the 200 pF at
that terminal.
ILEAKAGE
70pF
R
ILEAKAGE
200pF
I/4096
IREF
R
15k
VREF
RFB
OUT1
OUT2
Figure 2. DAC Equivalent Circuit All Digital Inputs LOW
ILEAKAGE
70pF
R
ILEAKAGE
200pF
I/4096
IREF
R
15k
VREF
RFB
OUT2
OUT1
Figure 3. DAC Equivalent Circuit All Digital Inputs HIGH
APPLICATIONS
UNIPOLAR BINARY OPERATION
(2-QUADRANT MULTIPLICATION)
Figure 4 shows the analog circuit connections required for uni-
polar binary (2-quadrant multiplication) operation. With a dc
reference voltage or current (positive or negative polarity) ap-
plied at Pin 17, the circuit is a unipolar D/A converter. With an
ac reference voltage or current, the circuit provides 2-quadrant
multiplication (digitally controlled attenuation). The input/
output relationship is shown in Table II.
R1 provides full-scale trim capability [i.e., load the DAC register
to 1111 1111 1111, adjust R1 for VOUT = –VREF (4095/4096)].
Alternatively, Full Scale can be adjusted by omitting R1 and R2
and trimming the reference voltage magnitude.
C1 phase compensation (10 pF to 25 pF) may be required for
stability when using high speed amplifiers. (C1 is used to cancel
the pole formed by the DAC internal feedback resistance and
output capacitance at OUT1).
Amplifier A1 should be selected or trimmed to provide VOS
10% of the voltage resolution at VOUT. Additionally, the ampli-
fier should exhibit a bias current which is low over the tempera-
ture range of interest (bias current causes output offset at VOUT
equal to IB times the DAC feedback resistance, nominally 11 k
).
The AD544L is a high speed implanted FET input op amp with
low factory-trimmed VOS.
18
16
1
2
3
17
AD7541A
VDD
RFB
VDD
VREF
PINS 4–15
DGND
OUT1
OUT2
R1
*
VIN
BIT 1 – BIT 12
DIGITAL
GROUND
ANALOG
COMMON
R2
*
C1
33pF
AD544L
(SEE TEXT)
VOUT
*REFER TO TABLE 1
Figure 4. Unipolar Binary Operation
Table I. Recommended Trim Resistor Values vs. Grades
Trim
Resistor
JN/AQ/SD
KN/BQ/TD
R1
100
100
R2
47
33
Table II. Unipolar Binary Code Table for Circuit of Figure 4
Binary Number in DAC
MSB
LSB
Analog Output, VOUT
1 1 1 1
–VIN
4095
4096
1 0 0 0
0 0 0 0
–VIN
2048
4096
= –1/2 VIN
0 0 0 0
0 0 0 1
–VIN
1
4096
0 0 0 0
0 Volts
相關PDF資料
PDF描述
MAX4374FESD+T IC AMP CURRENT SENSE 14-SOIC
MAX4374HESD+T IC AMP CURRENT SENSE 14-SOIC
MAX4374TESD+T IC AMP CURRENT SENSE 14-SOIC
MAX4375TEUB+T IC AMP CURRENT SENSE 10-UMAX
VE-244-IV-F3 CONVERTER MOD DC/DC 48V 150W
相關代理商/技術參數
參數描述
AD7541AKPZ-REEL 功能描述:IC DAC 12BIT MULT MONO 20PLCC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散(最大):55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流,單極;1 電流,雙極 采樣率(每秒):*
AD7541AKR 功能描述:IC DAC 12BIT MULT MONO 18-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散(最大):55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流,單極;1 電流,雙極 采樣率(每秒):*
AD7541AKR-REEL 制造商:Analog Devices 功能描述:DAC 1-CH R-2R 12-bit 18-Pin SOIC W T/R
AD7541AKR-REEL7 制造商:Analog Devices 功能描述:DAC 1-CH R-2R 12-bit 18-Pin SOIC W T/R
AD7541AKRZ 功能描述:IC DAC 12BIT MULT MONO 18-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散(最大):- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬) 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓,單極 采樣率(每秒):* 產品目錄頁面:1398 (CN2011-ZH PDF)