參數資料
型號： AD7715ARZ-5REEL
廠商： Analog Devices Inc
文件頁數： 7/40頁
文件大?。?/td> 0K
描述： IC ADC 16BIT 5V 16-SOIC
標準包裝： 1,000
位數： 16
采樣率（每秒）： 500
數據接口： DSP，MICROWIRE?，QSPI?，串行，SPI?
轉換器數目： 1
功率耗散（最大）： 9.5mW
電壓電源： 模擬和數字
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 16-SOIC（0.295"，7.50mm 寬）
供應商設備封裝： 16-SOIC W
包裝： 帶卷 (TR)
輸入數目和類型： 1 個差分，單極；1 個差分，雙極
配用： EVAL-AD7715-3EBZ-ND - BOARD EVALUATION FOR AD7715
AD7715
Rev. D | Page 15 of 40
Table 13.
MD1
MD0
Operating Mode
0
Normal mode. This operating mode is the default mode of operation of the device whereby the device is performing normal
conversions. The AD7705 is placed in this mode after power-on or reset.
0
1
Self-calibration. This is a one step calibration sequence and when complete the part returns to normal mode with MD1 and
MD0 returning to 0, 0. The DRDY output or DRDYbit goes high when calibration is initiated and returns low when this self-
calibration is complete and a new valid word is available in the data register. The zero-scale calibration is performed at the
selected gain on internally shorted (zeroed) inputs and the full-scale calibration is performed at the selected gain on an
internally generated VREF/selected gain.
1
0
Zero-scale system calibration. Zero-scale system calibration is performed at the selected gain on the input voltage provided
at the analog input during this calibration sequence. This input voltage should remain stable for the duration of the
calibration. The DRDY output or DRDY bit goes high when calibration is initiated and returns low when this zero-scale
calibration is complete and a new valid word is available in the data register. At the end of the calibration, the part returns to
normal mode with MD1 and MD0 returning to 0, 0.
1
Full-scale system calibration. Full-scale system calibration is performed at the selected gain on the input voltage provided at
the analog input during this calibration sequence. This input voltage should remain stable for the duration of the
calibration. The DRDY output or DRDY bit goes high when calibration is initiated and returns low when this full-scale
calibration is complete and a new valid word is available in the data register. At the end of the calibration, the part returns to
normal mode with MD1 and MD0 returning to 0, 0.
Table 14. Output Update Rates
FS1
FS0
Output Update Rate
3 dB Filter Cutoff
0
20 Hz
5.24 Hz
0
1
25 Hz
6.55 Hz
0
1
0
100 Hz
26.2 Hz
0
1
200 Hz
52.4 Hz
1
0
50 Hz
13.1 Hz
1
0
1
60 Hz
15.7 Hz (default status)
1
0
250 Hz
65.5 Hz
1
500 Hz
131 Hz
1 Assumes correct clock frequency at MCLK IN pin.
TEST REGISTER (RS1, RS0 = 1, 0)
The part contains a test register, which is used in testing the
device. The user is advised not to change the status of any of the
bits in this register from the default (power-on or reset) status
of all 0s as the part will be placed in one of its test modes and
will not operate correctly. If the part enters one of its test modes,
exercising RESET will exit the part from the mode. An alterna-
tive scheme for getting the part out of one of its test modes, is to
reset the interface by writing 32 successive 1s to the part and
then load all 0s to the test register.
DATA REGISTER (RS1, RS0 = 1, 1)
The data register on the part is a read-only 16-bit register
that contains the most up-to-date conversion result from the
AD7715. If the communications register data sets up the part
for a write operation to this register, a write operation must
actually take place to return the part to where it is expecting
a write operation to the communications register (the default
state of the interface). However, the 16 bits of data written to
the part will be ignored by the AD7715.
相關PDF資料
PDF描述
VI-B64-IX-B1 CONVERTER MOD DC/DC 48V 75W
VI-2V1-MX-S CONVERTER MOD DC/DC 12V 75W
LTC2351CUH-12#TRPBF IC ADC 12BIT 1.5MSPS 32-QFN
MS27473E8A35SD CONN PLUG 6POS STRAIGHT W/SCKT
AD7766BRUZ-2-RL7 IC ADC 24BIT 32KSPS SAR 16TSSOP
相關代理商/技術參數
參數描述
AD7715ARZ-5REEL1 制造商:AD 制造商全稱:Analog Devices 功能描述:3 V/5 V, 450 ??A 16-Bit, Sigma-Delta ADC
AD7716 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS 22-Bit Data Acquisition System
AD7716BP 制造商:Analog Devices 功能描述:ADC Single Delta-Sigma 570ksps 22-bit Serial 44-Pin PLCC 制造商:Rochester Electronics LLC 功能描述:4-CHNL S-D ADC - Bulk 制造商:Analog Devices 功能描述:IC SIGMA DELTA ADC
AD7716BP-REEL 制造商:Analog Devices 功能描述:ADC Single Delta-Sigma 570ksps 22-bit Serial 44-Pin PLCC T/R 制造商:Analog Devices 功能描述:ADC SGL DELTA-SIGMA 2.2KSPS 22-BIT SERL 44PLCC - Tape and Reel
AD7716BPZ 功能描述:IC ADC 22BIT SIGMA-DELTA 44-PLCC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*