- 您現在的位置：買賣IC網 > PDF目錄10685 > AD7780BRUZ (Analog Devices Inc)IC ADC 24BIT 1CH LP SD 16TSSOP PDF資料下載
參數資料
| 型號： | AD7780BRUZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 14/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 24BIT 1CH LP SD 16TSSOP |
| 產品培訓模塊： | Weigh Scale Introduction |
| 標準包裝： | 96 |
| 位數： | 24 |
| 采樣率（每秒）： | 16.7 |
| 數據接口： | 串行，SPI? |
| 轉換器數目： | 1 |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個差分，雙極 |
| 產品目錄頁面： | 779 (CN2011-ZH PDF) |
AD7780
Rev. A | Page 7 of 16
PIN CONFIGURATIONS AND FUNCTION DESCRIPTIONS
AD7780
TOP VIEW
(Not to Scale)
NC = NO CONNECT
1
2
3
4
5
6
7
8
SCLK
DOUT/RDY
NC
AIN(–)
AIN(+)
GAIN
NC
REFIN(+)
16
15
14
13
12
11
10
9
FILTER
PDRST
DVDD
BPDSW
REFIN(–)
GND
AVDD
NC
0
794
5-
0
07
SCLK 1
DOUT/RDY 2
NC 3
GAIN 4
FILTER
14
PDRST
13
DVDD
12
AVDD
11
AIN(+) 5
GND
10
AIN(–) 6
BPDSW
9
REFIN(+) 7
REFIN(–)
8
AD7780
TOP VIEW
(Not to Scale)
NC = NO CONNECT
0
79
45
-0
06
Figure 6. SOIC Pin Configuration
Figure 7. TSSOP Pin Configuration
Table 6. Pin Function Descriptions
Pin No.
SOIC
TSSOP
Mnemonic
Description
1
2
SCLK
Serial Clock Input. This serial clock input is for data transfers from the ADC. The SCLK pin has a Schmitt-
triggered input. The serial clock can be active only when transferring data from the AD7780. The data
from the AD7780 can be read as a continuous 32-bit word. Alternatively, SCLK can be noncontinuous
during the data transfer, with the information being transmitted from the ADC in smaller data batches.
2
3
DOUT/RDY
Serial Data Output/Data Ready Output. DOUT/RDY serves a dual purpose: as a data ready pin, going low to
indicate the completion of a conversion, and as a serial data output pin to access the data register of the
ADC. Eight status bits accompany each data read (see
). The DOUT/
RDY falling edge can be used
as an interrupt to a processor, indicating that new data is available. If the data is not read after the conver-
sion, the pin goes high before the next update occurs. The serial interface is reset each time that a conversion is
available. Therefore, the user must ensure that any conversions being transmitted are completed before
the next conversion is available.
3
1, 4, 16
NC
No Connect. This pin can be left floating.
4
5
GAIN
Gain Select Pin. When GAIN is low, the gain is set to 128. When GAIN is high, the gain is set to 1.
5
6
AIN(+)
Analog Input. AIN(+) is the positive terminal of the differential analog input pair, AIN(+)/AIN().
6
7
AIN()
Analog Input. AIN() is the negative terminal of the differential analog input pair, AIN(+)/AIN().
7
8
REFIN(+)
Positive Reference Input. An external reference can be applied between REFIN(+) and REFIN(). The nomi-
nal reference voltage (REFIN(+) REFIN()) is 5 V, but the part can function with a reference of 0.5 V to AVDD.
8
9
REFIN()
Negative Reference Input.
9
10
BPDSW
Bridge Power-Down Switch to GND. When PDRST is high, the bridge power-down switch is closed. When
PDRST is low, the switch is opened.
10
11
GND
Ground Reference Point.
11
12
AVDD
Supply Voltage, 2.7 V to 5.25 V.
12
13
DVDD
Digital Interface Supply Voltage. The logic levels for the serial interface pins and the digital control pins
are related to this supply, which is between 2.7 V and 5.25 V. The DVDD voltage is independent of the
voltage on AVDD; therefore, AVDD can equal 5 V with DVDD at 3 V or vice versa.
13
14
PDRST
Power-Down/Reset. When this pin is low, the ADC is placed in power-down mode, and the low-side power
switch is opened. All the logic on the chip is reset, and the DOUT/RDY pin is tristated. When PDRST is high,
the ADC is taken out of power-down mode. The on-chip clock powers up and settles, and the ADC
continuously converts. In addition, the low-side power switch is closed. The internal clock requires
approximately 1 ms to power up.
14
15
FILTER
Filter Select. When FILTER is low, the fast settling filter is selected. The update rate is set to 16.7 Hz, which
gives a filter settling time of 120 ms. When FILTER is high, the high rejection filter is selected. The update
rate is set to 10 Hz, which gives a filter settling time of 300 ms. With this filter, the stop-band (higher than
fADC) attenuation is better than 45 dB.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1445IS | IC COMP W/REF LOWPWR QUAD 16SOIC |
| LTC1444IS | IC COMP W/REF LOWPWR QUAD 16SOIC |
| LTC2366CTS8#TRMPBF | IC ADC 12BIT 3MSPS TSOT23-8 |
| DS90LV031ATMTC/NOPB | IC LINE DRIVER QUAD CMOS 16TSSOP |
| LTC1444IN#PBF | IC COMP W/REF LOWPWR QUAD 16-DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7780BRUZ-REEL | 功能描述:IC ADC 24BIT 1CH LP SD 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| AD7780BRZ | 功能描述:IC ADC 24BIT 1CH LP SD 14SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| AD7780BRZ | 制造商:Analog Devices 功能描述:IC ADC 24BIT 16.7HZ SOIC-14 |
| AD7780BRZ-REEL | 功能描述:IC ADC 24BIT 1CH LP SD 14SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| AD7781 | 制造商:AD 制造商全稱:Analog Devices 功能描述:20-Bit, Pin-Programmable, Low Power Sigma-Delta ADC |
發布緊急采購，3分鐘左右您將得到回復。