- 您現在的位置：買賣IC網 > PDF目錄10681 > AD7798BRUZ (Analog Devices Inc)IC ADC 16BIT SIG-DEL 3CH 16TSSOP PDF資料下載
參數資料
| 型號： | AD7798BRUZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 16BIT SIG-DEL 3CH 16TSSOP |
| 標準包裝： | 96 |
| 位數： | 16 |
| 采樣率（每秒）： | 470 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 2mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 3 個差分，單極；3 個差分，雙極 |
| 產品目錄頁面： | 779 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Data Sheet
AD7798/AD7799
Rev. B | Page 19 of 28
0
–20
–40
–60
–80
–100
0
3000
2500
2000
1500
1000
500
04856-015
FREQUENCY (Hz)
(dB)
Figure 14. Filter Profile with Update Rate = 242 Hz
0
–10
–20
–30
–40
–50
–60
0
10000
9000
8000
7000
6000
5000
4000
3000
2000
1000
04856-016
FREQUENCY (Hz)
(dB)
Figure 15. Filter Response with Update Rate = 470 Hz
DIGITAL INTERFACE
As previously outlined, the programmable functions of the
AD7798/AD7799 are controlled using a set of on-chip registers.
Data is written to these registers via the serial interface, which
also provides read access to the on-chip registers. All
communication with the part must start with a write to the
communication register. After power-on or reset, the device
expects a write to its communication register. The data written
to this register determines whether the next operation is a read
or write operation and to which register this operation occurs.
Therefore, write access to any register begins with a write
operation to the communication register, followed by a write to
the selected register. A read operation from any other register
(except when continuous-read mode is selected) starts with a
write to the communication register, followed by a read
operation from the selected register.
The serial interface of the AD7798/AD7799 consists of four
signals: CS, DIN, SCLK, and DOUT/RDY. The DIN line is used
to transfer data into the on-chip registers, and DOUT/RDY is
used for accessing data from the on-chip registers. SCLK is the
serial clock input for the device and all data transfers (either on
DIN or DOUT/RDY) occur with respect to the SCLK signal.
The DOUT/RDY pin operates as a data ready signal, with the
line going low when a new data-word is available in the output
register. It is reset high when a read operation from the data
register is complete. It also goes high prior to the updating of
the data register to indicate when not to read from the device to
ensure that a data read is not attempted while the register is
being updated. CS is used to select a device. It can be used to
decode the AD7798/AD7799 in systems where several
components are connected to the serial bus.
Figure 3 and Figure 4 show timing diagrams for interfacing to
the AD7798/AD7799, with CS being used to decode the part.
Figure 3 shows the timing for a read operation from the
AD7798/AD7799 output shift register, and Figure 4 shows the
timing for a write operation to the input shift register. It is
possible to read the same word from the data register several
times, even though the DOUT/RDY line returns high after the
first read operation. However, care must be taken to ensure that
the read operations are complete before the next output update
occurs. In continuous-read mode, the data register can only be
read once.
The serial interface can operate in 3-wire mode by tying CS low.
In this case, the SCLK, DIN, and DOUT/RDY lines are used to
communicate with the AD7798/AD7799. The end of the con-
version can be monitored using the RDY bit in the status regis-
ter. This scheme is suitable for interfacing to microcontrollers.
If CS is required as a decoding signal, it can be generated from a
port pin. For microcontroller interfaces, it is recommended that
SCLK idles high between data transfers.
The AD7798/AD7799 can be operated with CS being used as a
frame-synchronization signal. This scheme is useful for DSP
interfaces. In this case, the first bit (MSB) is effectively clocked
out by CS, because CS normally occurs after the falling edge of
SCLK in DSPs. The SCLK can continue to run between data
transfers, provided that the timing numbers are obeyed.
The serial interface can be reset by writing a series of 1s on the
DIN input. If a Logic 1 is written to the AD7798/AD7799 line
for at least 32 serial clock cycles, the serial interface is reset.
This ensures that the interface can be reset to a known state if
the interface is lost due to a software error or a glitch in the
system. Reset returns the interface to the state in which it is
expecting a write to the communication register. This opera-
tion resets the contents of all registers to their power-on
values. Following a reset, the user should allow a period of
500 microseconds before addressing the serial interface.
The AD7798/AD7799 can be configured to continuously
convert or to perform a single conversion (See Figure 16
through Figure 18).
相關PDF資料 |
PDF描述 |
|---|---|
| VI-22T-MY-B1 | CONVERTER MOD DC/DC 6.5V 50W |
| AD9281ARSZ | IC ADC 8BIT DUAL CMOS 28-SSOP |
| AD8564ARZ-REEL7 | IC COMPARATOR QUAD 7NS 16SOIC TR |
| AD8561AR | IC COMPARATOR SNGL 7NS 8-SOIC |
| AD7274BUJZ-500RL7 | IC ADC 12BIT 3MSPS TSOT23-8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7798BRUZ-REEL | 功能描述:IC ADC 16BIT 3CH LP 16-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7799 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, 24-Bit/16-Bit Sigma-Delta ADC with In-Amp |
| AD7799BRU | 功能描述:IC ADC 24BIT 3CH LP 16-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7799BRU-REEL | 功能描述:IC ADC 24BIT 3CH LP 16-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7799BRUZ | 功能描述:IC ADC 24BIT SIG-DEL 3CH 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
發布緊急采購，3分鐘左右您將得到回復。