VDD = +5 V ± 5%, V
參數資料
型號: AD7870KPZ-REEL
廠商: Analog Devices Inc
文件頁數: 25/28頁
文件大小: 0K
描述: IC ADC 12BIT SAMPLING 3V 28PLCC
標準包裝: 750
位數: 12
采樣率(每秒): 100k
數據接口: 串行,并聯
轉換器數目: 1
功率耗散(最大): 95mW
電壓電源: 雙 ±
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 28-LCC(J 形引線)
供應商設備封裝: 28-PLCC(11.51x11.51)
包裝: 帶卷 (TR)
輸入數目和類型: 1 個單端,雙極
AD7870/AD7875/AD7876
Rev. C | Page 6 of
28
TIMING CHARACTERISTICS
VDD = +5 V ± 5%, VSS = 5 V ± 5%, AGND = DGND = 0 V. See Figure 14, Figure 15, Figure 16, and Figure 17. Timing specifications are
sample tested at 25°C to ensure compliance, unless otherwise noted. All input signals are specified with tr = tf = 5 ns (10% to 90% of 5 V)
and timed from a voltage level of 1.6 V.
Table 3.
Parameter1
Limit at TMIN, TMAX
(J, K, L, A, B, C Versions)
Limit at TMIN, TMAX
(T Version)
Units
Conditions/Comments
t1
50
ns min
CONVST pulse width
t2
0
ns min
CS to RD setup time (Mode 1)
t32
60
75
ns min
RD pulse width
t4
0
ns min
CS to RD hold time (Mode 1)
t5
70
ns max
RD to INT delay
57
70
ns max
Data access time after RD
5
ns min
Bus relinquish time after RD
50
ns max
t8
0
ns min
HBEN to RD setup time
t9
0
ns min
HBEN to RD hold time
t10
100
ns min
SSTRB to SCLK falling edge setup time
t115
370
ns min
SCLK cycle time
t126
135
150
ns max
SCLK to valid data delay. CL = 35 pF
t13
20
ns min
SCLK rising edge to SSTRB
100
ns max
t14
10
ns min
Bus relinquish time after SCLK
100
ns max
t15
60
ns min
CS to RD setup time (Mode 2)
t16
120
ns max
CS to BUSY propagation delay
t17
200
ns min
Data setup time prior to BUSY
t18
0
ns min
CS to RD hold time (Mode 2)
t19
0
ns min
HBEN to CS setup time
t20
0
ns min
HBEN to CS hold time
1 Serial timing is measured with a 4.7 kΩ pull-up resistor on SDATA and SSTRB and a 2 kΩ pull-up on SCLK. The capacitance on all three outputs is 35 pF.
2 Timing specifications for t3, t6, and for the maximum limit at t7 are 100% production tested.
3 t6 is measured with the load circuits of Figure 4 and defined as the time required for an output to cross 0.8 V or 2.4 V.
4 t7 is defined as the time required for the data lines to change 0.5 V when loaded with the circuits of Figure 5.
5 SCLK mark/space ratio (measured from a voltage level of 1.6 V) is 40/60 to 60/40.
6 SDATA will drive higher capacitive loads but this will add to t12 since it increases the external RC time constant (4.7 kΩ||CL) and thus the time to reach 2.4 V.
相關PDF資料
PDF描述
MS3106R12-5P CONN PLUG 1POS STRAIGHT W/PINS
IDT72V221L15PF IC FIFO SYNC 1KX9 15NS 32QFP
AD7703CR-REEL IC ADC 20BIT LC2MOS MONO 20-SOIC
IDT72221L15PF IC FIFO SYNC 1KX9 15NS 32QFP
MS27466T23F55PB CONN RCPT 55POS WALL MT W/PINS
相關代理商/技術參數
參數描述
AD7870KPZ-REEL1 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS Complete, 12-Bit, 100 kHz, Sampling ADCs
AD7870LN 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS Complete, 12-Bit, 100 kHz, Sampling ADCs
AD7870LNZ 功能描述:IC ADC 12BIT SAMPLING 3V 24-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極
AD7870LNZ1 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS Complete, 12-Bit, 100 kHz, Sampling ADCs
AD7870LP 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS Complete, 12-Bit, 100 kHz, Sampling ADCs