- 您現在的位置：買賣IC網 > PDF目錄9477 > AD7890ANZ-4 (Analog Devices Inc)IC DAS 12BIT 8CH 24-DIP PDF資料下載
參數資料
| 型號： | AD7890ANZ-4 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 6/28頁 |
| 文件大小： | 0K |
| 描述： | IC DAS 12BIT 8CH 24-DIP |
| 標準包裝： | 15 |
| 類型： | 數據采集系統（DAS） |
| 分辨率（位）： | 12 b |
| 采樣率（每秒）： | 117k |
| 數據接口： | 串行 |
| 電壓電源： | 單電源 |
| 電源電壓： | 5V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 24-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 24-PDIP |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD7890
Rev. C | Page 14 of 28
When using the device in the external-clocking mode, the
output register can be read at any time and the most up-to-date
conversion result is obtained. However, reading data from the
output register or writing data to the control register during
conversion or during the 500 ns prior to the next CONVST
results in reduced performance from the part. A read operation
to the output register has the most effect on performance with
the signal-to-noise ratio likely to degrade, especially when
higher serial clock rates are used while the code flicker from the
part also increases (see the Performance section).
Figure 7 shows the timing and control sequence required to
obtain optimum performance from the part in the external
clocking mode. In the sequence shown, conversion is initiated
on the rising edge of CONVST and new data is available in the
output register of the AD7890 5.9 μs later. Once the read
operation has taken place, a further 500 ns should be allowed
before the next rising edge of CONVST to optimize the settling
of the track/hold before the next conversion is initiated.
The diagram shows the read operation and the write operation
taking place in parallel. On the sixth falling edge of SCLK in the
write sequence the internal pulse is initiated. Assuming MUX OUT
is connected to SHA IN, 2 μs are required between this sixth
falling edge of SCLK and the rising edge of CONVST to allow
for the full acquisition time of the track/hold amplifier. With
the serial clock rate at its maximum of 10 MHz, the achievable
throughput rate for the part is 5.9 μs (conversion time) plus 0.6
μs (six serial clock pulses before internal pulse is initiated) plus
2 μs (acquisition time). This results in a minimum throughput
time of 8.5 μs (equivalent to a throughput rate of 117 kHz). If
the part is operated with a slower serial clock, it affects the
achievable throughput rate for optimum performance.
RFS
TFS
500ns MIN
CONVST
SCLK
NEXT CONVERSION
START COMMAND
CONVERSION IS
INITIATED AND
TRACK/HOLD GOES
INTO HOLD
CONVERSION
ENDS 5.9s
LATER
SERIAL READ
AND WRITE
OPERATIONS
READ AND WRITE
OPERATIONS SHOULD END
500ns PRIOR TO NEXT
RISING EDGE OF CONVST
tCONVERT
01
35
7-
00
7
Figure 7. External Clocking (Slave) Mode Timing Sequence for Optimum Performance
相關PDF資料 |
PDF描述 |
|---|---|
| AD7890ANZ-2 | IC DAS 12BIT 8CH 24-DIP |
| V110A5M200B3 | CONVERTER MOD DC/DC 5V 200W |
| V110A48M300BG2 | CONVERTER MOD DC/DC 48V 300W |
| SN74CB3T3245PW | IC SWITCH BUS FET HS 20-TSSOP |
| V110A48M300BF | CONVERTER MOD DC/DC 48V 300W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7890AR-10 | 功能描述:IC DAS 12BIT 8CH 24-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AD7890AR-10REEL | 功能描述:IC DAS 12BIT 8CH 24-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AD7890AR-2 | 功能描述:IC DAS 12BIT 8CH 24-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AD7890AR-2REEL | 制造商:Analog Devices 功能描述:ADC Single SAR 117ksps 12-bit Serial 24-Pin SOIC W T/R 制造商:Analog Devices 功能描述:ADC SGL SAR 117KSPS 12-BIT SERL 24SOIC W - Tape and Reel |
| AD7890AR-4 | 功能描述:IC DAS 12BIT 8CH 24-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
發布緊急采購，3分鐘左右您將得到回復。