參數資料
型號: AD8001ARZ-REEL
廠商: Analog Devices Inc
文件頁數: 4/17頁
文件大?。?/td> 0K
描述: IC OPAMP CF LP LDIST 70MA 8SOIC
標準包裝: 2,500
放大器類型: 電流反饋
電路數: 1
轉換速率: 1200 V/µs
-3db帶寬: 715MHz
電流 - 輸入偏壓: 5µA
電壓 - 輸入偏移: 2000µV
電流 - 電源: 5mA
電流 - 輸出 / 通道: 70mA
電壓 - 電源,單路/雙路(±): ±3 V ~ 6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 8-SO
包裝: 帶卷 (TR)
REV. D
AD8001
–11–
Printed Circuit Board Layout Considerations
As to be expected for a wideband amplifier, PC board parasitics
can affect the overall closed-loop performance. Of concern are
stray capacitances at the output and the inverting input nodes. If
a ground plane is to be used on the same side of the board as
the signal traces, a space (5 mm min) should be left around the
signal lines to minimize coupling. Additionally, signal lines
connecting the feedback and gain resistors should be short
enough so that their associated inductance does not cause high
frequency gain errors. Line lengths on the order of less than
5 mm are recommended. If long runs of coaxial cable are being
driven, dispersion and loss must be considered.
Power Supply Bypassing
Adequate power supply bypassing can be critical when optimiz-
ing the performance of a high frequency circuit. Inductance in
the power supply leads can form resonant circuits that produce
peaking in the amplifier’s response. In addition, if large current
transients must be delivered to the load, then bypass capacitors
(typically greater than 1
F) will be required to provide the best
settling time and lowest distortion. A parallel combination of
4.7
F and 0.1 F is recommended. Some brands of electrolytic
capacitors will require a small series damping resistor
≈4.7 for
optimum results.
DC Errors and Noise
There are three major noise and offset terms to consider in a
current feedback amplifier. For offset errors, refer to the equation
below. For noise error the terms are root-sum-squared to give a
net output error. In the circuit in Figure 7 they are input offset
(VIO), which appears at the output multiplied by the noise gain
of the circuit (1 + RF/RI), noninverting input current (IBN
× R
N)
also multiplied by the noise gain, and the inverting input current,
which when divided between RF and RI and subsequently
multiplied by the noise gain always appears at the output as
IBN
×RF. The input voltage noise of the AD8001 is a low 2 nV/
√Hz. At low gains though the inverting input current noise times
RF is the dominant noise source. Careful layout and device
matching contribute to better offset and drift specifications for
the AD8001 compared to many other current feedback ampli-
fiers. The typical performance curves in conjunction with the
following equations can be used to predict the performance of
the AD8001 in any application.
VV
R
IR
R
IR
OUT
IO
F
I
BN
N
F
I
BI
F
+
±×
×
+
±×
11
RF
RI
RN
IBN
VOUT
IBI
Figure 7. Output Offset Voltage
Driving Capacitive Loads
The AD8001 was designed primarily to drive nonreactive loads.
If driving loads with a capacitive component is desired, best
frequency response is obtained by the addition of a small series
resistance, as shown in Figure 8. The accompanying graph
shows the optimum value for RSERIES versus capacitive load. It is
worth noting that the frequency response of the circuit when
driving large capacitive loads will be dominated by the passive
roll-off of RSERIES and CL.
909
RSERIES
RL
500
IN
CL
Figure 8. Driving Capacitive Loads
40
0
25
30
10
5
20
15
20
10
CL – pF
G = +1
R
SERIES
Figure 9. Recommended RSERIES vs. Capacitive Load
相關PDF資料
PDF描述
PBC26DAGN CONN HEADER .100 DUAL STR 52POS
AD8231ACPZ-WP IC AMP INST R-R 7MHZ 16LFCSP
PEC33DAFN CONN HEADER .100 DUAL STR 66POS
69192-416HLF BERGSTIK II DR STRAIGHT RET
69192-416 BERGSTIK II DR STRAIGHT RET
相關代理商/技術參數
參數描述
AD8001ARZ-REEL7 功能描述:IC OPAMP CF LP LDIST 70MA 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:73 系列:Over-The-Top® 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.07 V/µs 增益帶寬積:200kHz -3db帶寬:- 電流 - 輸入偏壓:1nA 電壓 - 輸入偏移:285µV 電流 - 電源:50µA 電流 - 輸出 / 通道:25mA 電壓 - 電源,單路/雙路(±):2 V ~ 44 V,±1 V ~ 22 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-WFDFN 裸露焊盤 供應商設備封裝:16-DFN-EP(5x3) 包裝:管件
AD8001R-EB+22 制造商:AD 制造商全稱:Analog Devices 功能描述:800 MHz, 50 mW Current Feedback Amplifier
AD8001SMD 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Current-Feedback Operational Amplifier