- 您現在的位置：買賣IC網 > PDF目錄5741 > AD8054ARU (Analog Devices Inc)IC OPAMP VF R-R QUAD LP 14TSSOP PDF資料下載
參數資料
| 型號： | AD8054ARU |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 14/25頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP VF R-R QUAD LP 14TSSOP |
| 標準包裝： | 96 |
| 放大器類型： | 電壓反饋 |
| 電路數： | 4 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 190 V/µs |
| -3db帶寬： | 160MHz |
| 電流 - 輸入偏壓： | 2µA |
| 電壓 - 輸入偏移： | 1800µV |
| 電流 - 電源： | 2.875mA |
| 電流 - 輸出 / 通道： | 30mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 12 V，±1.5 V ~ 6 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 14-TSSOP |
| 包裝： | 管件 |
AD8051/AD8052/AD8054
Rev. J | Page 20 of 24
SYNC STRIPPER
Synchronizing pulses are sometimes carried on video signals so
as not to require a separate channel to carry the synchronizing
information. However, for some functions, such as analog-to-
digital conversion, it is not desirable to have the sync pulses on
the video signal. These pulses reduce the dynamic range of the
video signal and do not provide any useful information for such
a function.
A sync stripper removes the synchronizing pulses from a video
signal while passing all the useful video information. Figure 51
shows a practical single-supply circuit that uses only a single
AD8051. It is capable of directly driving a reverse terminated
video line.
AD8051
0.1F
10F
+
100
TO A/D
3V OR 5V
VBLANK
GROUND
0.4V
VIDEO WITH SYNC
GROUND
VIDEO WITHOUT SYNC
R2
1k
R1
1k
VIN
3
2
7
4
6
0.8V
(OR 2 × VBLANK)
0
106
2-
051
Figure 51. Sync Stripper
The video signal plus sync is applied to the noninverting input
with the proper termination. The amplifier gain is set to 2 via
the two 1 kΩ resistors in the feedback circuit. A bias voltage
must be applied to R1 so that the input signal has the sync
pulses stripped at the proper level.
The blanking level of the input video pulse is the desired place to
remove the sync information. This level is multiplied by 2 by the
amplifier. This level must be at ground at the output for the sync
stripping action to take place. Since the gain of the amplifier from
the input of R1 to the output is 1, a voltage equal to 2 × VBLANK
must be applied to make the blanking level come out at ground.
SINGLE-SUPPLY COMPOSITE VIDEO LINE DRIVER
Many composite video signals have their blanking level at
ground and have video information that is both positive and
negative. Such signals require dual-supply amplifiers to pass
them. However, by ac level shifting, a single-supply amplifier
can be used to pass these signals. The following complications
can arise from such techniques.
Signals of bounded peak-to-peak amplitude that vary in duty
cycle require larger dynamic swing capacity than their (bounded)
peak-to-peak amplitude after they are ac-coupled. As a worst
case, the dynamic signal swing will approach twice the peak-to-
peak value. The two conditions that define the maximum
dynamic swing requirements are a signal that is mostly low but
goes high with a duty cycle that is a small fraction of a percent,
and the other extreme defined by the opposite condition.
The worst case of composite video is not quite this demanding.
One bounding condition is a signal that is mostly black for an
entire frame but has a white (full amplitude) minimum width
spike at least once in a frame.
The other extreme is for a full white video signal. The blanking
intervals and sync tips of such a signal have negative-going
excursions in compliance with the composite video specifications.
The combination of horizontal and vertical blanking intervals
limit such a signal to being at the highest (white) level for a
maximum of about 75% of the time.
As a result of the duty cycles between the two extremes
previously presented, a 1 V p-p composite video signal that is
multiplied by a gain of 2 requires about 3.2 V p-p of dynamic
voltage swing at the output for an op amp to pass a composite
video signal of arbitrarily varying duty cycle without distortion.
Some circuits use a sync tip clamp to hold the sync tips at a
relatively constant level to lower the amount of dynamic signal
swing required. However, these circuits can have artifacts, such
as sync tip compression, unless they are driven by a source with
a very low output impedance. The AD8051/AD8052/AD8054
have adequate signal swing when running on a single 5 V
supply to handle an ac-coupled composite video signal.
The input to the circuit in Figure 52 is a standard composite
(1 V p-p) video signal that has the blanking level at ground. The
input network level shifts the video signal by means of ac coupling.
The noninverting input of the op amp is biased to half of the
supply voltage.
The feedback circuit provides unity gain for the dc-biasing of
the input and provides a gain of 2 for any signals that are in the
video bandwidth. The output is ac-coupled and terminated to
drive the line.
The capacitor values were selected for providing minimum tilt
or field time distortion of the video signal. These values would
be required for video that is considered to be studio or broadcast
quality. However, if a lower consumer grade of video, sometimes
referred to as consumer video, is all that is desired, the values
and the cost of the capacitors can be reduced by as much as a
factor of five with minimum visible degradation in the picture.
AD8051
5V
+
10F
4.99k
220F
+
1000F
0.1F
10k
+
47F
4.99k
0.1F
10F
+
COMPOSITE
VIDEO
IN
3
2
7
4
6
RG
1k
RF
1k
RT
75
RL
75
VOUT
RBT
75
0
10
62
-05
2
Figure 52. Single-Supply Composite Video Line Driver
相關PDF資料 |
PDF描述 |
|---|---|
| RL0402FR-070R18L | RES .18 OHM 1/16W 1% 0402 SMD |
| AD8002AR | IC OPAMP CF DUAL LP LDIST 8SOIC |
| LT2179CS#TRPBF | IC OPAMP MICROPOWER QUAD 14SOIC |
| RL0402FR-070R12L | RES .12 OHM 1/16W 1% 0402 SMD |
| LT2179CS#TR | IC OPAMP PREC QUAD MCRPWR 14SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8054ARU-EBZ | 功能描述:BOARD EVAL FOR AD8054ARU RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| AD8054ARUR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| AD8054ARU-REEL | 制造商:Analog Devices 功能描述:OP Amp Quad Volt Fdbk R-R O/P 制造商:Analog Devices 功能描述:OP Amp Quad Volt Fdbk R-R O/P ±6V/12V 14-Pin TSSOP T/R |
| AD8054ARU-REEL7 | 制造商:Analog Devices 功能描述:OP Amp Quad Volt Fdbk R-R O/P 制造商:Analog Devices 功能描述:OP Amp Quad Volt Fdbk R-R O/P ±6V/12V 14-Pin TSSOP T/R 制造商:Rochester Electronics LLC 功能描述:QUAD HI SPEED LOW COST R-TO-R AMPLIFIER - Tape and Reel |
| AD8054ARUZ | 功能描述:IC OPAMP VF R-R QUAD LP 14TSSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
發布緊急采購，3分鐘左右您將得到回復。