參數資料
型號： AD8138SRMZ-EP-R7
廠商： Analog Devices Inc
文件頁數： 14/25頁
文件大小： 0K
描述： IC ADC DRIVER DIFF 8MSOP
設計資源： DC-Coupled, Single-Ended-to-Differential Conversion Using AD8138 and AD7352 (CN0040)
DC-Coupled, Single-Ended-to-Differential Conversion Using AD8138 and AD7356 (CN0041)
DC-Coupled, Single-Ended-to-Differential Conversion Using AD8138 and AD7357 (CN0061)
標準包裝： 1
類型： ADC 驅動器
應用： 數據采集
安裝類型： 表面貼裝
封裝/外殼： 8-TSSOP，8-MSOP（0.118"，3.00mm 寬）
供應商設備封裝： 8-MSOP
包裝： 標準包裝
其它名稱： AD8138SRMZ-EP-R7DKR
AD8138
Rev. F | Page 20 of 24
BALANCED TRANSFORMER DRIVER
Transformers are among the oldest devices used to perform a
single-ended-to-differential conversion (and vice versa). Trans-
formers can also perform the additional functions of galvanic
isolation, step-up or step-down of voltages, and impedance
transformation. For these reasons, transformers always find
uses in certain applications.
However, when driving the transformer in a single-ended
manner, there is an imbalance at the output due to the parasitics
inherent in the transformer. The primary (or driven) side of the
transformer has one side at dc potential (usually ground), while
the other side is driven. This can cause problems in systems that
require good balance of the transformer’s differential output
signals.
If the interwinding capacitance (CSTRAY) is assumed to be
uniformly distributed, a signal from the driving source couples
to the secondary output terminal that is closest to the primary’s
driven side. On the other hand, no signal is coupled to the
opposite terminal of the secondary because its nearest primary
terminal is not driven (see Figure 43). The exact amount of this
imbalance depends on the particular parasitics of the trans-
former, but is mostly a problem at higher frequencies.
The balance of a differential circuit can be measured by
connecting an equal-valued resistive voltage divider across the
differential outputs and then measuring the center point of the
circuit with respect to ground. Since the two differential outputs
are supposed to be of equal amplitude, but 180° opposite phase,
there should be no signal present for perfectly balanced outputs.
The circuit in Figure 43 shows a Mini-Circuits T1-6T
transformer connected with its primary driven single-endedly
and the secondary connected with a precision voltage divider
across its terminals. The voltage divider is made up of two
500 Ω, 0.005% precision resistors. The voltage VUNBAL, which is
also equal to the ac common-mode voltage, is a measure of how
closely the outputs are balanced.
Figure 45 compares the transformer being driven single-
endedly by a signal generator and being driven differentially
using an AD8138. The top signal trace of Figure 45 shows the
balance of the single-ended configuration, while the bottom
shows the differentially driven balance response. The 100 MHz
balance is 35 dB better when using the AD8138.
The well-balanced outputs of the AD8138 provide a drive signal
to each of the transformer’s primary inputs that are of equal
amplitude and 180° out of phase. Therefore, depending on how
the polarity of the secondary is connected, the signals that
conduct across the interwinding capacitance either both assist
the transformer’s secondary signal equally, or both buck the
secondary signals. In either case, the parasitic effect is
symmetrical and provides a well-balanced transformer output
(see Figure 45).
PRIMARY
CSTRAY
52.3
SECONDARY VDIFF
500
0.005%
500
0.005%
VUNBAL
SIGNALIS COUPLED
ON THIS SIDE VIA CSTRAY
NO SIGNAL IS COUPLED
ON THIS SIDE
01
07
3-
0
42
Figure 43. Transformer Single-Ended-to-Differential Converter Is Inherently
Imbalanced
VDIFF
VUNBAL
AD8138
+IN
–IN
OUT+
OUT–
499
49.9
500
0.005%
500
0.005%
CSTRAY
01
07
3-
0
43
Figure 44. AD8138 Forms a Balanced Transformer Driver
FREQUENCY (MHz)
0
O
UT
P
UT
BAL
ANCE
E
RRO
R
(
d
B) –20
–40
–60
–80
–100
0.3
1
10
100
500
VUNBAL, DIFFERENTIAL DRIVE
VUNBAL, FOR TRANSFORMER
WITH SINGLE-ENDED DRIVE
0
10
73
-04
4
Figure 45. Output Balance Error for Circuits of Figure 43 and Figure 44
相關PDF資料
PDF描述
LTC2610IGN#PBF IC DAC R-R 14-BIT OCTAL 16-SSOP
SY88893VKG TR IC POST AMP PECL LP LIMIT 10MSOP
LTC6405IMS8E#TRPBF IC AMP/DVR DIFF R-R 5V 8-MSOP
AD5044BRUZ-REEL7 IC DAC QUAD 14BIT SPI 16TSSOP
SY88973BLMG TR IC CML POST AMP 3.2GBPS 16-MLF
相關代理商/技術參數
參數描述
AD8139 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Noise, Rail-to-Rail, Differential ADC Driver
AD8139_07 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Noise, Rail-to-Rail, Differential ADC Driver
AD8139ACP 制造商:Analog Devices 功能描述:ULTRA LOW NOISE FULLY DIFFERENTIAL ADC DRIVER - Bulk
AD8139ACP-EBZ 功能描述:BOARD EVAL FOR AD8139ACP RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:-
AD8139ACP-R2 制造商:Analog Devices 功能描述:SP Amp DIFF AMP Single R-R O/P ±6V/12V 8-Pin LFCSP EP T/R 制造商:Rochester Electronics LLC 功能描述:HIGH PERFORMANCE LOW NOISE ADC DRIVER - Bulk
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*