- 您現在的位置：買賣IC網 > PDF目錄8583 > AD813ARZ-14 (Analog Devices Inc)IC TRPL VIDEO AMP SNGL LP 14SOIC PDF資料下載
參數資料
| 型號： | AD813ARZ-14 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 9/19頁 |
| 文件大小： | 0K |
| 描述： | IC TRPL VIDEO AMP SNGL LP 14SOIC |
| 標準包裝： | 56 |
| 應用： | 電流反饋 |
| 電路數： | 3 |
| -3db帶寬： | 100MHz |
| 轉換速率： | 250 V/µs |
| 電流 - 電源： | 4.5mA |
| 電流 - 輸出 / 通道： | 50mA |
| 電壓 - 電源，單路/雙路(±)： | 2.4 V ~ 36 V，±1.2 V ~ 18 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 14-SOICN |
| 包裝： | 管件 |
| 產品目錄頁面： | 764 (CN2011-ZH PDF) |
AD813
REV. B
–17–
Disable Mode Operation
Pulling the voltage on any one of the Disable pins about 2.5 V
down from the positive supply will put the corresponding ampli-
fier into a disabled, powered down, state. In this condition, the
amplifier’s quiescent supply current drops to about 0.5 mA, its
output becomes a high impedance, and there is a high level of
isolation from input to output. In the case of the gain of two
line driver for example, the impedance at the output node will
be about the same as for a 1.4 k
resistor (the feedback plus
gain resistors) in parallel with a 12.5 pF capacitor and the input
to output isolation will be about 65 dB at 1 MHz.
Leaving the Disable pin disconnected (floating) will leave the
corresponding amplifier operational, in the enabled state. The
input impedance of the disable pins is about 35 k
in parallel
with a few pF. When grounded, about 50
A flows out of a
disable pin on
±5 V supplies.
Input voltages greater than about 1.5 V peak-to-peak will defeat
the isolation. In addition, large signals (greater than 3 V peak-
to-peak) applied to the output node will cause the output im-
pedance to drop significantly.
When the Disable pins are driven by complementary output
CMOS logic (such as the 74HC04), the disable time is about
80 ns (until the output goes high impedance) and the enable
time is about 100 ns (to low impedance output) on
±15 V sup-
plies. When operated on
±15 V supplies, the disable pins
should be driven by open drain logic. In this case, pull-up resis-
tors from the disable pins to the plus supply will ensure mini-
mum switching time.
75
VOUT
75
CABLE
1
VIN1
84
+5V
464
590
7
4
5
6
SELECT1
2
VIN2
84
464
590
14
12
13
SELECT2
VIN3
84
3
464
590
8
10
9
SELECT3
11
–5V
Figure 55. A Fast Switching 3:1 Video Mux
(Supply Bypassing Not Shown)
Operation Using a Single Supply
The AD813 will operate with total supply voltages from 36 V
down to 2.4 V. With proper biasing (see Figure 52) it can
make an outstanding single supply video amplifier. Since the
input and output voltage ranges extend to within 1 V of the
supply rails, it will handle a 1.3 V peak-to-peak signal on a
single 3.3 V supply, or a 3 V peak-to-peak signal on a single
5 V supply. The small signal 0.1 dB bandwidths will exceed
10 MHz in either case, and the large signal bandwidths will
exceed 6 MHz.
The capacitively coupled cable driver in Figure 52 will achieve
outstanding differential gain and phase errors of 0.05% and 0.05
degrees respectively on a single 5 V supply. Resistor R2, in this
circuit, is selected to optimize the differential gain and phase by
biasing the amplifier in its most linear region.
75
AD813
4
11
VIN
R2
12.4k
VOUT
75
+5V
75
CABLE
C2
1 F
R1
9k
C1
2 F
C3
30 F
619
R3
1k
COUT
47 F
Figure 52. Biasing for Single Supply Operation
1
10
1000
100
FREQUENCY – MHz
–0.5
–3.0
0.5
0
–1.0
–1.5
–2.0
–2.5
CLOSED-LOOP
GAIN
–
dB
0
–90
–180
–270
PHASE
SHIFT
–
Degrees
–3.5
GAIN
PHASE
VS = 5V
G = +2
RF = 619
RL = 150
Figure 53. Closed-Loop Gain and Phase vs. Frequency,
Circuit of Figure 52
10
100
0%
500mV
1V
500mV
50ns
90
VIN
VOUT
Figure 54. Pulse Response for the Circuit of Figure 52
with +VS = 5 V
相關PDF資料 |
PDF描述 |
|---|---|
| VI-21J-IV-F1 | CONVERTER MOD DC/DC 36V 150W |
| VE-B62-MU | CONVERTER MOD DC/DC 15V 200W |
| VE-23R-IV-F2 | CONVERTER MOD DC/DC 7.5V 150W |
| VE-B61-MU | CONVERTER MOD DC/DC 12V 200W |
| VI-21H-IV-F2 | CONVERTER MOD DC/DC 52V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD813ARZ-14-REEL | 功能描述:IC OPAMP TRIPLE VIDEO LP 14SOIC RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
| AD813ARZ-14-REEL7 | 功能描述:IC OPAMP TRIPLE VIDEO LP 14SOIC RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
| AD814 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SILICON DUAL DIFFERNTIAL AMPLIFIER TRANSISTORS |
| AD8141 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Cost, Triple Differential Drivers |
| AD8141ACPZ-R2 | 制造商:Analog Devices 功能描述:LOW COST CAT5 DRIVER - Tape and Reel 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:VIDEO AMP TRIPLE 275MHZ LFCSP-24 |
發布緊急采購，3分鐘左右您將得到回復。