參數資料
型號: AD8208WBRZ
廠商: Analog Devices Inc
文件頁數: 6/20頁
文件大?。?/td> 0K
描述: IC AMP DIFF PREC 8SOIC
標準包裝: 98
放大器類型: 差分
電路數: 1
轉換速率: 1 V/µs
增益帶寬積: 70kHz
電流 - 輸入偏壓: 50nA
電壓 - 輸入偏移: 2000µV
電流 - 電源: 1.6mA
電壓 - 電源,單路/雙路(±): 4.5 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 8-SO
包裝: 管件
AD8208
Data Sheet
Rev. C | Page 14 of 20
Internal Signal Overload Considerations
When configuring the gain for values other than 20, the maximum
input voltage with respect to the supply voltage and ground must
be considered because either the preamplifier or the output buffer
reaches its full-scale output (VS 0.1 V) with large differential
input voltages. The input of the AD8208 is limited to (VS 0.1) ÷
10 for overall gains of ≤10 because the preamplifier, with its
fixed gain of 10 V/V, reaches its full-scale output before the
output buffer. For gains greater than 10, the swing at the buffer
output reaches its full scale first and then limits the AD8208
input to (VS 0.1) ÷ G, where G is the overall gain.
LOW-PASS FILTERING
In many transducer applications, it is necessary to filter the signal
to remove spurious high frequency components, including noise,
or to extract the mean value of a fluctuating signal with a peak-
to-average ratio (PAR) greater than unity. For example, a full-wave
rectified sinusoid has a PAR of 1.57, a raised cosine has a PAR
of 2, and a half-wave sinusoid has a PAR of 3.14. Signals with
large spikes may have PARs of 10 or more.
When implementing a filter, the PAR should be considered so
that the output of the AD8208 preamplifier (A1) does not clip
before A2; otherwise, the nonlinearity would be averaged and
appear as an error at the output. To avoid this error, both amplifiers
should clip at the same time. This condition is achieved when the
PAR is no greater than the gain of the second amplifier (2 for
the default configuration). For example, if a PAR of 5 is expected,
the gain of A2 should be increased to 5.
Low-pass filters can be implemented in several ways by using
the features provided by the AD8208. In the simplest case, a
single-pole filter (20 dB/decade) is formed when the output
of A1 is connected to the input of A2 via the internal 100 k
resistor by tying Pin 3 to Pin 4 and adding a capacitor from this
node to ground, as shown in Figure 33. If a resistor is added
across the capacitor to lower the gain, the corner frequency
increases; therefore, gain should be calculated using the parallel
sum of the resistor and 100 k.
GND
NC
–IN
+IN
A1
VS
A2
OUT
AD8208
VDIFF
VCM
CF
NC = NO CONNECT
08714-
032
OUTPUT
fC =
1
2
πC105
C IN FARADS
5V
+
+
Figure 33. Single-Pole, Low-Pass Filter Using the Internal 100 k Resistor
If the gain is raised using a resistor, as shown in Figure 31, the
corner frequency is lowered by the same factor as the gain is raised.
Therefore, using a resistor of 200 k (for which the gain would
be doubled), results in a corner frequency scaled to 0.796 Hz F
(0.039 F for a 20 Hz corner frequency).
GND
NC
–IN
+IN
A1
VS
A2
OUT
AD8208
5V
VDIFF
VCM
C
NC = NO CONNECT
08714-
033
OUTPUT
fC(Hz) = 1/C(F)
255k
+
+
Figure 34. Two-Pole, Low-Pass Filter
A two-pole filter with a roll-off of 40 dB/decade can be
implemented using the connections shown in Figure 34. This
configuration is a Sallen-Key form based on a ×2 amplifier. It is
useful to remember that a two-pole filter with a corner frequency
of f2 and a single-pole filter with a corner frequency of f1 have
the same attenuation, that is, 40 log (f2/f1), as shown in Figure 35.
Using the standard resistor value shown in Figure 34 and capacitors
of equal values, the corner frequency is conveniently scaled to
1 Hz F (0.05 F for a 20 Hz corner frequency). A maximal flat
response occurs when the resistor is lowered to 196 k, scaling
the corner frequency to 1.145 Hz F. The output offset is raised
by approximately 5 mV (equivalent to 250 V at the input pins).
40log (f2/f1)
f1
A
TTE
N
U
A
TION
f2
f22/f1
FREQUENCY
A 1-POLE FILTER, CORNER f1, AND
A 2-POLE FILTER, CORNER f2, HAVE
THE SAME ATTENUATION –40log (f2/f1)
AT FREQUENCY f22/f1
20dB/DECADE
40dB/DECADE
08714-
034
Figure 35. Comparative Responses of Single-Pole and Two-Pole Low-Pass Filters
相關PDF資料
PDF描述
DCM-7 FUSE 7A 600V FST MIDGET UL CSA
AD8054ARUZ-REEL IC OPAMP VF R-R QUAD LP 14TSSOP
TSW-140-08-L-D-RA CONN HEADER 80POS .100 DL R/A AU
LTC6410IUD-6#TRPBF IC AMP DIFF IF 16-QFN
TSW-136-08-G-D CONN HEADER 72POS .100" DL GOLD
相關代理商/技術參數
參數描述
AD8208WBRZ-R7 功能描述:IC AMP DIFF PREC 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源,單路/雙路(±):1.8 V ~ 5.25 V,±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件
AD8208WBRZ-RL 功能描述:IC AMP DIFF PREC 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源,單路/雙路(±):1.8 V ~ 5.25 V,±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件
AD8208WHRMZ 功能描述:Differential Amplifier 1 Circuit 8-MSOP 制造商:analog devices inc. 系列:- 包裝:管件 零件狀態:有效 放大器類型:差分 電路數:1 輸出類型:- 壓擺率:1 V/μs 增益帶寬積:70kHz -3db 帶寬:- 電流 - 輸入偏置:50nA 電壓 - 輸入失調:2mV 電流 - 電源:1.6mA 電流 - 輸出/通道:- 電壓 - 電源,單/雙(±):4.5 V ~ 5.5 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬) 供應商器件封裝:8-MSOP 標準包裝:50
AD8208WHRMZ-RL 功能描述:Differential Amplifier 1 Circuit 8-MSOP 制造商:analog devices inc. 系列:- 包裝:帶卷(TR) 零件狀態:在售 放大器類型:差分 電路數:1 輸出類型:- 壓擺率:1 V/μs 增益帶寬積:70kHz -3db 帶寬:- 電流 - 輸入偏置:50nA 電壓 - 輸入失調:2mV 電流 - 電源:1.6mA 電流 - 輸出/通道:- 電壓 - 電源,單/雙(±):4.5 V ~ 5.5 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬) 供應商器件封裝:8-MSOP 標準包裝:3,000
AD8208WHRZ 功能描述:Differential Amplifier 1 Circuit 8-SOIC 制造商:analog devices inc. 系列:- 包裝:管件 零件狀態:有效 放大器類型:差分 電路數:1 輸出類型:- 壓擺率:1 V/μs 增益帶寬積:70kHz -3db 帶寬:- 電流 - 輸入偏置:50nA 電壓 - 輸入失調:2mV 電流 - 電源:1.6mA 電流 - 輸出/通道:- 電壓 - 電源,單/雙(±):4.5 V ~ 5.5 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商器件封裝:8-SOIC 標準包裝:98