- 您現在的位置：買賣IC網 > PDF目錄5727 > AD8330ACPZ-R2 (Analog Devices Inc)IC AMP VGA 150MHZ LN LP 16LFCSP PDF資料下載
參數資料
| 型號： | AD8330ACPZ-R2 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 18/32頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP VGA 150MHZ LN LP 16LFCSP |
| 標準包裝： | 250 |
| 放大器類型： | 可變增益 |
| 電路數： | 1 |
| 輸出類型： | 差分，滿擺幅 |
| 轉換速率： | 1500 V/µs |
| -3db帶寬： | 150MHz |
| 電流 - 輸入偏壓： | 100nA |
| 電流 - 電源： | 20mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 16-LFCSP-VQ |
| 包裝： | 帶卷 (TR) |
| 配用： | AD8330-EVALZ-ND - BOARD EVAL FOR AD8330 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Data Sheet
AD8330
Rev. F | Page 25 of 32
APPLICATIONS INFORMATION
The versatility of the AD8330, its very constant ac response over
a wide range of gains, the large signal dynamic range, output
swing, single supply operation, and low power consumption
commend this VGA to a diverse variety of applications. Only a
few can be described here, including the most basic uses and some
unusual ones.
ADC DRIVING
The AD8330 is well-suited to drive a high speed converter.
There are many high speed converters available, but to illustrate
the general features, the example in this data sheet uses one of
the least expensive, the AD9214. This is available in three
grades for operation at 65 MHz, 80 MHz, and 105 MHz; the
AD9214BRS-80 is a good complement to the general capabili-
ties of this VGA.
Figure 63 shows the connections to drive an ADC. A 3.3 V
supply is used for both parts. The ADC requires that its input
pins be positioned at one third of the supply, or 1.1 V. Given
that the default output level of the VGA is one-half the supply
or 1.65 V, a small correction is introduced by the 8 kΩ resistor
from CNTR to ground. The ADC specifications require that the
common-mode input be within ±0.2 V of the nominal 1.1 V;
variations of up to ±20% in the AD8330 on-chip resistors change
this voltage by only ±70 mV. With the connections shown in
Figure 63, the AD9214 is able to receive an input of 2 V p-p; the
peak output of the AD8330 can be reduced if desired by adding
a resistor
from VMAG to ground. An overrange condition is signaled by a
high state on Pin OR of the AD9214. DFS/GAIN is unconnected
in this example producing an offset-binary output. To provide a
twos complement output, it should be connected to the REF pin.
For ADCs running at sampling rates substantially below the
bandwidth of the AD8330, an intervening noise filter is
recommended to limit the noise bandwidth. A one-pole filter
can easily be created with a single differential capacitor between
the OPHI and OPLO outputs. For a corner frequency of fC, the
capacitor should have a value of
CFILT = 1/942 fC
(26)
For example, a 10 MHz corner requires about 100 pF.
SIMPLE AGC AMPLIFIER
Figure 64 illustrates the use of the inverted gain mode and the
offset gain range (0.2 V < VDBS < 1.7 V) in supporting a low cost
AGC loop. Q1 is used as a detector. When OPHI is sufficiently
higher than CNTR, due to the signal swing, it conducts and
charges C1. This raises VDBS and rapidly lowers the gain. Note
that MODE is grounded (see Figure 48). The minimum voltage
needed across R1 to set up the full gain is 0.2 V because CMGN
is dc open-circuited (this does not alter VMAG) and the maxi-
mum voltage is 1.7 V.
COMM
OPHI
INLO
OPLO
INHI
VPSI
VPSO
CMOP
MODE
VDBS
CMGN
OFST
CNTR
ENBL
VPOS
BIAS AND
V-REF
CM MODE AND
OFFSET CONTROL
OUTPUT
STAGES
OUTPUT
CONTROL
VGA CORE
AD9214BRS-80
DAT
A
O
UT
P
UT
S
D0
D1
D2
D3
D4
D5
D6
D7
D8
D9
DGND
CLK
AGND
CLOCK
REF
0.1F
REFSENSE
NC
ANALOG GROUND
AIN
DFS/GAIN
PWRDN
DIGITAL
GROUND
GAIN BIAS,
VDBS, 0V–1.5V
NC
INPUT,
±2V MAX
0.1F
10
GAIN INTERFACE
CHPF
8k
0.1F
AVDD
OR
DrVDD
3.3
OVER-
RANGE
3.3
0.1F
VS, 3.3V
03217-
064
VMAG
Figure 63. Driving an Analog-to-Digital Converter (Preliminary)
相關PDF資料 |
PDF描述 |
|---|---|
| LT1168AIS8#TRPBF | IC AMP INSTR PROG PREC LP 8SOIC |
| DF3-8P-2DS | CONN HEADER 8POS 2MM RT ANG TIN |
| LT1168AIS8#TR | IC AMP INSTR PROG PREC LP 8SOIC |
| OP497FSZ-REEL | IC OPAMP GP 500KHZ QUAD 16SOIC |
| OP293ES-REEL | IC OPAMP GP 35KHZ DUAL 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8330ACPZ-R7 | 功能描述:IC AMP VGA 150MHZ LN LP 16LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| AD8330ACPZ-RL | 功能描述:IC AMP VGA 150MHZ LN LP 16LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:150 系列:- 放大器類型:音頻 電路數:2 輸出類型:- 轉換速率:5 V/µs 增益帶寬積:12MHz -3db帶寬:- 電流 - 輸入偏壓:100nA 電壓 - 輸入偏移:500µV 電流 - 電源:6mA 電流 - 輸出 / 通道:50mA 電壓 - 電源，單路/雙路(±):4 V ~ 32 V，±2 V ~ 16 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| AD8330ARQ | 制造商:Analog Devices 功能描述:SP Amp Variable Gain Amp Single R-R O/P 6V 16-Pin QSOP Tube 制造商:Rochester Electronics LLC 功能描述:QSOP SINGLE VGA - Bulk 制造商:Analog Devices 功能描述:IC AMP DIFFERENTIAL |
| AD8330ARQ-REEL | 制造商:Analog Devices 功能描述:SP Amp Variable Gain Amp Single R-R O/P 6V 16-Pin QSOP T/R |
| AD8330ARQ-REEL7 | 制造商:Analog Devices 功能描述:SP Amp Variable Gain Amp Single R-R O/P 6V 16-Pin QSOP T/R |
發布緊急采購，3分鐘左右您將得到回復。