參數資料
型號: AD8605ACBZ-REEL7
廠商: Analog Devices Inc
文件頁數: 11/24頁
文件大?。?/td> 0K
描述: IC OPAMP GP R-R CMOS PREC 5WLCSP
產品培訓模塊: Op Amp Basics
產品變化通告: 8mm Carrier Tape Changes 28/Feb/2012
標準包裝: 1
系列: DigiTrim®
放大器類型: 通用
電路數: 1
輸出類型: 滿擺幅
轉換速率: 5 V/µs
增益帶寬積: 10MHz
電流 - 輸入偏壓: 0.2pA
電壓 - 輸入偏移: 80µV
電流 - 電源: 1mA
電流 - 輸出 / 通道: 80mA
電壓 - 電源,單路/雙路(±): 2.7 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 5-XFBGA,WLCSP
供應商設備封裝: 5-WLCSP
包裝: 標準包裝
產品目錄頁面: 767 (CN2011-ZH PDF)
其它名稱: AD8605ACBZ-REEL7DKR
Data Sheet
AD8605/AD8606/AD8608
Rev. N | Page 19 of 24
I-V CONVERSION APPLICATIONS
PHOTODIODE PREAMPLIFIER APPLICATIONS
The low offset voltage and input current of the AD8605 make
it an excellent choice for photodiode applications. In addition,
the low voltage and current noise make the amplifier ideal for
application circuits with high sensitivity.
RD
ID
CD
50pF
AD8605
VOUT
PHOTODIODE
VOS
RF
10M
CF
10pF
02731-
051
Figure 52. Equivalent Circuit for Photodiode Preamp
The input bias current of the amplifier contributes an error
term that is proportional to the value of RF.
The offset voltage causes a dark current induced by the shunt
resistance of the Diode RD. These error terms are combined at
the output of the amplifier. The error voltage is written as
B
F
D
F
OS
O
I
R
V
E
+
+
=
1
Typically, RF is smaller than RD, thus RF/RD can be ignored.
At room temperature, the AD8605 has an input bias current of
0.2 pA and an offset voltage of 100 V. Typical values of RD are
in the range of 1 G.
For the circuit shown in Figure 52, the output error voltage is
approximately 100 V at room temperature, increasing to about
1 mV at 85°C.
The maximum achievable signal bandwidth is
F
t
MAX
C
R
f
π
2
=
where ft is the unity gain frequency of the amplifier.
AUDIO AND PDA APPLICATIONS
The low distortion and wide dynamic range of the AD860x
make it a great choice for audio and PDA applications,
including microphone amplification and line output buffering.
Figure 53 shows a typical application circuit for headphone/
line-out amplification.
R1 and R2 are used to bias the input voltage at half the supply,
which maximizes the signal bandwidth range. C1 and C2 are
used to ac couple the input signal. C1, R1, and R2 form a high-
pass filter whose corner frequency is 1/[2π(R1||R2)C1].
The high output current of the AD8606 allows it to drive heavy
resistive loads.
The circuit in Figure 53 is tested to drive a 16 headphone. The
THD + N is maintained at approximately 60 dB throughout the
audio range.
5V
4
2
3
8
1
HEADPHONES
5V
4
6
5
8
7
C1
1F
V1
500mV
1/2
AD8606
C3
100F
1/2
AD8606
C4
100F
C2
1F
V2
500mV
02731-
052
R1
20k
R2
20k
R7
20k
R8
20k
R4
20
R3
1k
R6
20
R5
1k
Figure 53. Single-Supply Headphone/Speaker Amplifier
相關PDF資料
PDF描述
AD8605ARTZ-REEL7 IC OPAMP GP R-R CMOS LN SOT23-5
TMM-103-01-T-S CONN HEADER 3POS SNGL 2MM T/H
68021-108HLF CONN HEADER 8POS .100 R/A 30AU
TMM-104-01-T-S-SM CONN HEADER 4POS SNGL 2MM SMD
TSW-101-26-G-S CONN HEADER 1POS .100" SNGL GOLD
相關代理商/技術參數
參數描述
AD8605ART 制造商:Analog Devices 功能描述:OP AMP SGL GP R-R I/O 5.5V 5PIN SOT-23 - Bulk
AD8605ART-R2 制造商:Analog Devices 功能描述:OP Amp Single GP R-R I/O 5.5V 5-Pin SOT-23 T/R 制造商:Analog Devices 功能描述:IC OP-AMP SINGLE R/R
AD8605ART-REEL 功能描述:IC OPAMP GP R-R CMOS LN SOT23-5 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:DigiTrim® 標準包裝:160 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:10 V/µs 增益帶寬積:9MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:250µV 電流 - 電源:730µA 電流 - 輸出 / 通道:28mA 電壓 - 電源,單路/雙路(±):2.7 V ~ 5.5 V,±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC(0.154",3.90mm 寬) 供應商設備封裝:16-SOIC N 包裝:管件
AD8605ART-REEL7 功能描述:IC OPAMP GP R-R CMOS LN SOT23-5 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:DigiTrim® 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源,單路/雙路(±):2.7 V ~ 36 V,±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商設備封裝:8-SO 包裝:帶卷 (TR)
AD8605ARTZ 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision, Low Noise, CMOS, Rail-to-Rail, Input/Output Operational Amplifiers