- 您現在的位置：買賣IC網 > PDF目錄5436 > AD8657ACPZ-RL (Analog Devices Inc)IC OPAMP R-R 18V 200KHZ 8LFCSP PDF資料下載
參數資料
| 型號： | AD8657ACPZ-RL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 9/24頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP R-R 18V 200KHZ 8LFCSP |
| 標準包裝： | 5,000 |
| 放大器類型： | 通用 |
| 電路數： | 2 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 0.07 V/µs |
| 增益帶寬積： | 200kHz |
| 電流 - 輸入偏壓： | 5pA |
| 電壓 - 輸入偏移： | 350µV |
| 電流 - 電源： | 18µA |
| 電流 - 輸出 / 通道： | 12mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 18 V，±1.35 V ~ 9 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-WFDFN 裸露焊盤，CSP |
| 供應商設備封裝： | 8-LFCSP-WD（3x3） |
| 包裝： | 帶卷 (TR) |
AD8657
Rev. A | Page 17 of 24
APPLICATIONS INFORMATION
The AD8657 is a low power, rail-to-rail input and output
precision CMOS amplifier that operates over a wide supply
voltage range of 2.7 V to 18 V. This amplifier uses the Analog
Devices DigiTrim technique to achieve a higher degree of
precision than is available from other CMOS amplifiers. The
DigiTrim technique is a method of trimming the offset voltage
of an amplifier after assembly. The advantage of postpackage
trimming is that it corrects any shifts in offset voltage caused by
mechanical stresses of assembly.
The AD8657 also employs unique input and output stages to
achieve a rail-to-rail input and output range with a very low
supply current.
INPUT STAGE
Figure 63 shows the simplified schematic of the AD8657. The
input stage comprises two differential transistor pairs, an NMOS
pair (M1, M2) and a PMOS pair (M3, M4). The input common-
mode voltage determines which differential pair turns on and is
more active than the other.
The PMOS differential pair is active when the input voltage
approaches and reaches the lower supply rail. The NMOS pair
is needed for input voltages up to and including the upper supply
rail. This topology allows the amplifier to maintain a wide
dynamic input voltage range and to maximize signal swing to
both supply rails.
For the majority of the input common-mode voltage range, the
PMOS differential pair is active. Differential pairs commonly
exhibit different offset voltages. The handoff from one pair to the
other creates a step-like characteristic that is visible in the VOS vs.
to-rail amplifiers that use the dual differential pair topology.
Therefore, always choose a common-mode voltage that does not
include the region of handoff from one input differential pair to
the other.
Additional steps in the VOS vs. VCM curves are also visible as the
input common-mode voltage approaches the power supply rails.
These changes are a result of the load transistors (M8, M9, M14,
and M15) running out of headroom. As the load transistors are
forced into the triode region of operation, the mismatch of their
drain impedances contributes to the offset voltage of the amplifier.
This problem is exacerbated at high temperatures due to the
decrease in the threshold voltage of the input transistors (see
Figure 9, Figure 10, Figure 12, and Figure 13 for typical perfor-
mance data).
Current Source I1 drives the PMOS transistor pair. As the input
common-mode voltage approaches the upper rail, I1 is steered
away from the PMOS differential pair through the M5 transistor.
The bias voltage, VB1, controls the point where this transfer occurs.
M5 diverts the tail current into a current mirror consisting of the
M6 and M7 transistors. The output of the current mirror then
drives the NMOS pair. Note that the activation of this current
mirror causes a slight increase in supply current at high common-
mode voltages (see Figure 23 and Figure 26 for more details).
The AD8657 achieves its high performance by using low voltage
MOS devices for its differential inputs. These low voltage MOS
devices offer excellent noise and bandwidth per unit of current.
Each differential input pair is protected by proprietary regulation
circuitry (not shown in the simplified schematic). The regula-
tion circuitry consists of a combination of active devices that
maintain the proper voltages across the input pairs during normal
operation and passive clamping devices that protect the amplifier
during fast transients. However, these passive clamping devices
begin to forward bias as the common-mode voltage approaches
either power supply rail. This causes an increase in the input
bias current (see Figure 15 and Figure 18).
The input devices are also protected from large differential
input voltages by clamp diodes (D1 and D2). These diodes are
buffered from the inputs with two 10 k resistors (R1 and R2).
The differential diodes turn on whenever the differential voltage
exceeds approximately 600 mV; in this condition, the differential
input resistance drops to 20 k.
OUTPUT STAGE
The AD8657 features a complementary output stage consisting
of the M16 and M17 transistors. These transistors are configured
in Class AB topology and are biased by the voltage source, VB2.
This topology allows the output voltage to go within millivolts
of the supply rails, achieving a rail-to-rail output swing. The output
voltage is limited by the output impedance of the transistors, which
are low RON MOS devices. The output voltage swing is a function
of the load current and can be estimated using the output voltage to
the supply rail vs. load current diagrams (see Figure 16, Figure 17,
Figure 19, and Figure 20).
相關PDF資料 |
PDF描述 |
|---|---|
| TSW-116-06-S-D | CONN HEADER 32POS .100" DL GOLD |
| CRCW12064R99FKEA | RES 4.99 OHM 1/4W 1% 1206 SMD |
| TSW-117-06-S-D | CONN HEADER 34POS .100" DL GOLD |
| LT1722CS5#TRPBF | IC OPAMP PREC 200MHZ TSOT-23-5 |
| SC-4 | FUSE 4A 600V T-LAG CLASS G |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8657ARMZ | 功能描述:IC OP AMP RRIO 200KHZ 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT |
| AD8657ARMZ_PROMO | 制造商:Analog Devices 功能描述:IC OP AMP RRIO 200KHZ MSOP |
| AD8657ARMZ-R7 | 功能描述:IC OP AMP RRIO 200KHZ 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:帶卷 (TR) |
| AD8657ARMZ-RL | 功能描述:IC OP AMP RRIO 200KHZ 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:帶卷 (TR) |
| AD8659ACPZ-R7 | 功能描述:IC OPAMP RRIO 18V CMOS 16LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。