- 您現在的位置：買賣IC網 > PDF目錄378281 > ADC10321 (National Semiconductor Corporation) 10-Bit, 20MSPS, 98mW A/D Converter with Internal Sample and Hold(10位20MSPS, 98 mW帶內部采樣和保持功能A/D轉換器) PDF資料下載
參數資料
| 型號： | ADC10321 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | 10-Bit, 20MSPS, 98mW A/D Converter with Internal Sample and Hold(10位20MSPS, 98 mW帶內部采樣和保持功能A/D轉換器) |
| 中文描述： | 10位，20MSPS，98mW的A / D轉換器內部采樣和保持（10位20MSPS，98毫瓦帶內部采樣和保持功能的A / D轉換器） |
| 文件頁數： | 15/16頁 |
| 文件大?。?/td> | 395K |
| 代理商： | ADC10321 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁
Applications Information
(Continued)
6.0 DYNAMIC PERFORMANCE
The ADC10321 is ac tested and its dynamic performance is
guaranteed. To meet the published specifications, the clock
source driving the CLK input must be free of jitter. For best
ac performance, isolating the ADC clock from any digital
circuitry should be done with adequate buffers, as with a
clock tree. See Figure 8
Meeting dynamic specifications is also dependent upon
keeping digital noise out of the input, as mentioned in Sec-
tions 1.0 and 5.0.
7.0 COMMON APPLICATION PITFALLS
Driving the inputs (analog or digital) beyond the power
supply rails.
For proper operation, all inputs should not go
more than 300mV beyond the supply pins. Exceeding these
limits on even a transient basis can cause faulty or erratic
operation. It is not uncommon for high speed digital circuits
(e.g., 74F and 74AC devices) to exhibit undershoot that goes
more than a volt below ground. A resistor of 50 to 100
in
series with the offending digital input will usually eliminate
the problem.
Care should be taken not to overdrive the inputs of the
ADC10321 (or any device) with a device that is powered
from supplies outside the range of the ADC10321 supply.
Such practice may lead to conversion inaccuracies and even
to device damage.
Attempting to drive a high capacitance digital data bus.
The more capacitance the output drivers has to charge for
each conversion, the more instantaneous digital current is
required from V
and DGND. These large charging current
spikes can couple into the analog section, degrading dy-
namic performance. Adequate bypassing and maintaining
separate analog and digital ground planes will reduce this
problem on the board. Buffering the digital data outputs (with
an 74F541, for example) may be necessary if the data bus to
be driven is heavily loaded. Dynamic performance can also
be improved by adding series resistors of 47
at each digital
output.
Driving the V
+ F pin or the V
F pin with devices
that can not source or sink the current required by the
ladder.
As mentioned in section 2.0, be careful to see that
any driving devices can source sufficient current into the
V
+ F pin and sink sufficient current from the V
F pin.
If these pins are not driven with devices than can handle the
required current, they will not be held stable and the con-
verter output will exhibit excessive noise.
Using a clock source with excessive jitter.
This will cause
the sampling interval to vary, causing excessive output noise
and a reduction in SNR performance. Simple gates with RC
timing is generally inadequate.
Using the same voltage source for V
and other digital
logic.
As mentioned in Section 3.0, V
should use the same
power source used by V
A
, but should be decoupled from V
A
.
DS100897-22
FIGURE 8. Isolating the ADC clock from digital
circuitry
A
www.national.com
15
相關PDF資料 |
PDF描述 |
|---|---|
| ADC1038CIWM | 10-Bit Serial I/O A/D Converter with Analog Multiplexer |
| ADC1038 | 10-Bit Serial I/O A/D Converter with Analog Multiplexer |
| ADC10461 | 10-Bit 600 ns A/D Converter with Input Multiplexer and Sample/Hold |
| ADC10461CIWM | 10-Bit 600 ns A/D Converter with Input Multiplexer and Sample/Hold |
| ADC10462CIWM | 10-Bit 600 ns A/D Converter with Input Multiplexer and Sample/Hold |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADC10321CIVT | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADC10321CIVT/NOPB | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADC10321EVAL | 功能描述:BOARD EVALUATION FOR ADC10321 RoHS:是 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像，彩色（RGB） 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| ADC1034 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:ADC1031/ADC1034/ADC1038 10-Bit Serial I/O A/D Converters with Analog Multiplexer and Track/Hold Function |
| ADC1034BIJ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog-to-Digital Converter， 10-Bit |
發布緊急采購，3分鐘左右您將得到回復。