- 您現在的位置：買賣IC網 > PDF目錄9101 > ADF4156BRUZ-RL (Analog Devices Inc)IC PLL FRAC-N FREQ SYNTH 16TSSOP PDF資料下載
參數資料
| 型號： | ADF4156BRUZ-RL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 5/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PLL FRAC-N FREQ SYNTH 16TSSOP |
| 產品變化通告： | Improve Phase Noise Performance |
| 設計資源： | Low-Noise Microwave fractional-N PLL using active loop filter and RF prescaler (CN0174) |
| 標準包裝： | 2,500 |
| 類型： | 分?jǐn)?shù) N 合成器（RF） |
| PLL： | 是 |
| 輸入： | CMOS，TTL |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:1 |
| 差分 - 輸入:輸出： | 是/無 |
| 頻率 - 最大： | 6.2GHz |
| 除法器/乘法器： | 是/是 |
| 電源電壓： | 2.7 V ~ 3.3 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 帶卷 (TR) |
Data Sheet
ADF4156
Rev. E | Page 13 of 24
MOD/R REGISTER, R2
With the control bits (Bits[2:0]) of Register R1 set to 010, the
on-chip MOD/R register is programmed. Figure 19 shows the
input data format for programming this register.
Noise and Spur Mode
The noise modes on the ADF4156 are controlled by DB30 and
DB29 in the MOD/R register. See Figure 19 for the truth table.
The noise modes allow the user to optimize a design either for
improved spurious performance or for improved phase noise
performance.
When the lowest spur setting is chosen, dither is enabled. This
randomizes the fractional quantization noise so that it resembles
white noise, rather than spurious noise. As a result, the part is
optimized for improved spurious performance. This operation
is typically used when the PLL closed-loop bandwidth is wide
for fast-locking applications. Wide loop bandwidth is defined as
a loop bandwidth greater than 1/10 of the RFOUT channel step
resolution (fRES). A wide loop filter does not attenuate the spurs
to the same level as a narrow loop bandwidth.
For best noise performance, use the lowest noise setting option.
As well as disabling the dither, using the lowest noise setting
ensures that the charge pump is operating in an optimum
region for noise performance. This setting is useful if a narrow
loop filter bandwidth is available. The synthesizer ensures
extremely low noise, and the filter attenuates the spurs. The
typical performance characteristics show the trade-offs in a
typical WCDMA setup for various noise and spur settings.
CSR Enable
Setting this bit to 1 enables cycle slip reduction, which can
improve lock times. Note that the signal at the phase frequency
detector (PFD) must have a 50% duty cycle for cycle slip
reduction to work. The charge-pump current setting must also
be set to a minimum value. See the Fast Lock Times section for
more information. Note that CSR cannot be used if the phase
detector polarity is set to negative.
Charge-Pump Current Setting
DB[27:24] set the charge-pump current setting. These bits
should be set to the charge-pump current as indicated by the
loop filter design (see Figure 19).
Prescaler (P/P + 1)
The dual-modulus prescaler (P/P + 1), along with the INT,
FRAC, and MOD counters, determines the overall division ratio
from the RFIN to the PFD input.
Operating at CML levels, the prescaler uses the clock from the
RF input stage and divides it down for the counters. The prescaler
is based on a synchronous 4/5 core. When it is set to 4/5, the
maximum RF frequency allowed is 3 GHz. Therefore, when
operating the ADF4156 with frequencies greater than 3 GHz,
the prescaler must be set to 8/9. The prescaler limits the INT
value as follows:
With P = 4/5, NMIN = 23
With P = 8/9, NMIN = 75
RDIV/2
Setting this bit to 1 inserts a divide-by-2 toggle flip-flop
between the R-counter and PFD, which extends the maximum
REFIN input rate.
Reference Doubler
Setting DB20 to 0 feeds the REFIN signal directly into the 5-bit
RF R-counter, disabling the doubler. Setting this bit to 1 multiplies
the REFIN frequency by a factor of 2 before feeding it into the 5-bit
R-counter. When the doubler is disabled, the REFIN falling edge
is the active edge at the PFD input to the fractional synthesizer.
When the doubler is enabled, both the rising and falling edges
of REFIN become active edges at the PFD input.
When the doubler is enabled and the lowest spur mode is chosen,
the in-band phase noise performance is sensitive to the REFIN
duty cycle. The phase noise degradation can be as much as 5 dB
for REFIN duty cycles that are outside a 45% to 55% range. The
phase noise is insensitive to the REFIN duty cycle when the device
is in the lowest noise mode and when the doubler is disabled.
The maximum allowable REFIN frequency when the doubler is
enabled is 30 MHz.
5-Bit R-Counter
The 5-bit R-counter allows the input reference frequency
(REFIN) to be divided down to produce the reference clock to
the phase frequency detector (PFD). Division ratios from
1 to 32 are allowed.
12-Bit Interpolator MOD Value
This programmable register sets the fractional modulus, which is
the ratio of the PFD frequency to the channel step resolution on
the RF output. Refer to the RF Synthesizer: A Worked Example
section for more information.
相關PDF資料 |
PDF描述 |
|---|---|
| SY100S838ZG TR | IC CLOCK GEN 3.3V/5V 20-SOIC |
| VI-24K-IV | CONVERTER MOD DC/DC 40V 150W |
| X9317TS8-2.7T1 | IC XDCP 100TAP 100K 3WIRE 8-SOIC |
| ADF4156BCPZ-RL | IC PLL FRAC-N FREQ SYNTH 20LFCSP |
| VI-24F-IV | CONVERTER MOD DC/DC 72V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF4156BRUZ-RL7 | 功能描述:IC PLL FRAC-N FREQ SYNTH 16TSSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
| ADF4156SP1BRUZ | 制造商:Analog Devices 功能描述: |
| ADF4157 | 制造商:AD 制造商全稱:Analog Devices 功能描述:High Resolution 6 GHz Fractional-N Frequency Synthesizer |
| ADF4157BCPZ | 功能描述:IC PLL FREQ SYNTH 6GHZ 20LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
| ADF4157BCPZ1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:High Resolution 6 GHz Fractional-N Frequency Synthesizer |
發布緊急采購，3分鐘左右您將得到回復。