- 您現在的位置：買賣IC網 > PDF目錄374017 > ADN2841ACP-48 (ANALOG DEVICES INC) Dual-Loop 50 Mbps.2.7 Gbps Laser Diode Driver PDF資料下載
參數資料
| 型號： | ADN2841ACP-48 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 其它接口 |
| 英文描述： | Dual-Loop 50 Mbps.2.7 Gbps Laser Diode Driver |
| 中文描述： | SPECIALTY INTERFACE CIRCUIT, QCC48 |
| 封裝： | MO-220-VKKD-2, LFCSP-48 |
| 文件頁數： | 7/12頁 |
| 文件大?。?/td> | 276K |
| 代理商： | ADN2841ACP-48 |
REV. 0
ADN2841
–7–
The second photodiode current is mirrored to IMPDMON2
for wavelength control purposes and is summed internally for
the power control loop.
For single MPD circuits the MPD2 pin
is tied to GND.
This enables the system designer to use the two currents to
control the wavelength of the laser diode using various optical
filtering techniques inside the laser module.
If the monitor current functions IMPDMON and IMPDMON2
are not required, the IMPD and IMPD2 pins can be grounded
and the monitor photodiode output can be connected di-
rectly to PSET.
IDTONE (48-PIN LFCSP ONLY)
The IDTONE pin is supplied for fiber identification/supervisory
channels or control purposes in WDM. This pin modulates the
optical one level over a possible range of 2% of minimum IMOD
to 10% of maximum IMOD. The level of modulation is set by
connecting an external current sink between the IDTONE pin and
ground. There is a gain of two from this pin to the IMOD current.
Figure 3 shows how an AD9850/AD9851 DDS may be used
with the ADN2841 to allow fiber identification.
Note that using IDTONE during transmission may cause opti-
cal eye degradation.
DATA, CLOCK INPUTS
Data and Clock inputs are ac-coupled (10 nF recommended)
and terminated via a 100
internal resistor between DATAP
and DATAN, and also between CLKP and CLKN pins. There
is a high-impedance circuit to set the common-mode voltage
that is designed to change over temperature. It is recommended
that ac coupling be used to eliminate the need for matching
between common-mode voltages.
Figure 4. AC Coupling of Data Inputs
CCBIAS
CCBIAS should be connected to the BIAS pin if the laser diode is
connected to the ADN2841 using a capacitor. CCBIAS is a
current sink to GND.
AUTOMATIC LASER SHUTDOWN
The ADN2841 ALS allows compliance to ITU-T-G958
(11/94), section 9.7.
When ALS is logic high, both bias and modulation currents are
turned off.
Correct operation of ALS can be confirmed by the fail alarm
being raised when ALS is asserted. Note this is the only time
that DEGRADE will be low while FAIL is high.
Figure 3. Circuitry to Allow Fiber Identification
REF CLOCK
20MHz–
180MHz
CLKIN
AD9850/AD9851
DDS
R
SET
I
OUT
50
1.25mA–20mA
I
OUT
50
LP FILTER
(DC-COUPLED)
AD8602
10kHz–1MHz
0.125mA–2mA
BC550
500
50 A–800 A
1000
1300
BC550
37.5 A–600 A
IDTONE
ADN2841
IMMON
CONTROLLER
1/2
AD8602
1/2
ADN2841
R = 2.5k , DATA
R = 3k , CLK
TO FLIP-FLOPS
400 A TYP
DATAP
DATAN
V
REG
R
50
50
相關PDF資料 |
PDF描述 |
|---|---|
| ADN2841ACP-48-RL | Dual-Loop 50 Mbps.2.7 Gbps Laser Diode Driver |
| ADN2843 | 10.709 Gbps Laser Diode Driver Chipset |
| ADN2843CHIPSET | 10.709 Gbps Laser Diode Driver Chipset |
| ADN2843CHIPSET-B | 10.709 Gbps Laser Diode Driver Chipset |
| ADN2847 | 3 V Dual-Loop 50 Mbps to 3.3 Gbps Laser Diode Driver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADN2841ACP-48-RL | 制造商:Analog Devices 功能描述:Laser Driver 2.7Gbps 1-CH 48-Pin LFCSP EP T/R |
| ADN2841ACPZ-32 | 功能描述:IC LSR DRVR 2.7GBPS 5.5V 32LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 激光驅動器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:激光二極管驅動器 數據速率:- 通道數:4 電源電壓:3.3V 電流 - 電源:- 電流 - 調制:- 電流 - 偏置:- 工作溫度:0°C ~ 70°C 封裝/外殼:40-TQFN 裸露焊盤 供應商設備封裝:40-TQFN EP 包裝:托盤 安裝類型:表面貼裝 |
| ADN2841ACPZ-32-RL | 功能描述:IC LSR DRVR 2.7GBPS 5.5V 32LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 激光驅動器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:激光二極管驅動器 數據速率:- 通道數:4 電源電壓:3.3V 電流 - 電源:- 電流 - 調制:- 電流 - 偏置:- 工作溫度:0°C ~ 70°C 封裝/外殼:40-TQFN 裸露焊盤 供應商設備封裝:40-TQFN EP 包裝:托盤 安裝類型:表面貼裝 |
| ADN2841ACPZ-32-RL7 | 功能描述:IC LSR DRVR 2.7GBPS 5.5V 32LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 激光驅動器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:激光二極管驅動器 數據速率:- 通道數:4 電源電壓:3.3V 電流 - 電源:- 電流 - 調制:- 電流 - 偏置:- 工作溫度:0°C ~ 70°C 封裝/外殼:40-TQFN 裸露焊盤 供應商設備封裝:40-TQFN EP 包裝:托盤 安裝類型:表面貼裝 |
| ADN2841ACPZ-48 | 功能描述:IC LSR DRVR 2.7GBPS 5.5V 48LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 激光驅動器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:激光二極管驅動器 數據速率:- 通道數:4 電源電壓:3.3V 電流 - 電源:- 電流 - 調制:- 電流 - 偏置:- 工作溫度:0°C ~ 70°C 封裝/外殼:40-TQFN 裸露焊盤 供應商設備封裝:40-TQFN EP 包裝:托盤 安裝類型:表面貼裝 |
發布緊急采購，3分鐘左右您將得到回復。