- 您現在的位置：買賣IC網 > PDF目錄20636 > ADP5022ACBZ-1-R7 (Analog Devices Inc)IC REG TRPL BCK/LINEAR 16WLCSP PDF資料下載
參數資料
| 型號： | ADP5022ACBZ-1-R7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 1/28頁 |
| 文件大?。?/td> | 1071K |
| 描述： | IC REG TRPL BCK/LINEAR 16WLCSP |
| 產品變化通告： | 8mm Carrier Tape Changes 28/Feb/2012 |
| 標準包裝： | 1 |
| 拓?fù)洌?/td> | 降壓（降壓）同步（2），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 3 |
| 頻率 - 開關： | 3MHz |
| 電壓/電流 - 輸出 1： | 3.3V，600mA |
| 電壓/電流 - 輸出 2： | 1.5V，600mA |
| 電壓/電流 - 輸出 3： | 1.8V，150mA |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 是 |
| 電源電壓： | 2.3 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-WFBGA，WLCSP |
| 供應商設備封裝： | 16-WLCSP |
| 包裝： | 標準包裝 |
| 其它名稱： | ADP5022ACBZ-1-R7DKR |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Dual 3 MHz, 600 mA Buck
Regulator with 150 mA LDO
ADP5022
Rev. C
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registered trademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.461.3113 ?0092010 Analog Devices, Inc. All rights reserved.
FEATURES
Input voltage range: 2.4 V to 5.5 V
Tiny 16-ball, 2 mm ?2 mm WLCSP package
Overcurrent and thermal protection
Soft start
Factory programmable undervoltage lockout on VDDA
system supply of either 2.2 V or 3.9 V
Factory programmable default output voltages for all
3 channels
Buck1 and Buck2 key specifications
Current mode architecture for excellent transient response
3 MHz operating frequency
Uses tiny multilayer inductors and capacitors
Forced PWM and auto PWM/PSM modes
Out-of-phase operation for reduced input filtering
100% duty cycle low dropout mode
24 糀 typical quiescent current per channel, no switching
LDO key specifications
Stable with 1 糉 ceramic output capacitors
High PSRR
60 dB up to 10 KHz
Low output noise
65 糣 rms output noise at VOUT3 = 3.3 V
Low dropout voltage: 150 mV @ 150 mA load
11 糀 typical ground current at no load
APPLICATIONS
USB devices
Handheld products
Multivoltage power for processors, ASICS, FPGAs,
and RF chipsets
GENERAL DESCRIPTION
The ADP5022 is a micro power management unit (micro PMU)
that combines two high performance buck regulators and a low
dropout regulator (LDO) in a tiny 16-ball 2.08 mm ?2.08 mm
WLCSP to meet demanding performance and board space
requirements.
The high switching frequency of the buck regulators enables
tiny multilayer external components and minimizes the board
space required. When the MODE pin is set high, the buck reg-
ulators operate in forced PWM mode. When the MODE pin is
set low, the buck regulators automatically switch operating
modes, depending on the load current level. At higher output
loads, the buck regulators operate in PWM mode. When the
load current falls below a predefined threshold, the regulators
operate in power save mode (PSM), improving the light-load
efficiency.
The two bucks operate out-of-phase to reduce the input
capacitor requirement and noise.
The low quiescent current, low dropout voltage, and wide input
voltage range of the ADP5022 LDO extends the battery life of
portable devices. The LDO maintains power supply rejection
greater than 60 dB for frequencies as high as 10 kHz while
operating with a low headroom voltage.
Each regulator in the ADP5022 has a dedicated, independent
enable pin. A high voltage level applied to the enable pin activates
the respective regulator. The default output voltages are factory
programmable and can be set to a wide range of options.
C2
4.7礔
C3
4.7礔
VIN1
VIN3
EN1
ON
OFF
PWM
PWM/PSM
V
IN
= 2.4V
TO 5.5V
SW1
VOUT1
PGND1
MODE
C4
10礔
C6
1礔
V
OUT1
@
600mA
L1
1礖
L2
1礖
EN_BK1
BUCK1
MODE
C1
1礔
VIN2
EN2
VDDA
ON
OFF
SW2
VOUT2
VOUT3
AGND
PGND2
C5
10礔
V
OUT2
@
600mA
EN_BK2
BUCK2
MODE
EN3
ON
OFF
V
OUT3
@
150mA
EN_LDO1
LDO1
ADP5022
C1
L1
COUT_1 COUT_2
COUT_3
C2
C4
C3
4.7mm
5.0mm
Figure 1. Typical Applications Circuit
Figure 2. Typical PCB Layout
相關PDF資料 |
PDF描述 |
|---|---|
| F950J686MAAAQ2 | CAP TANT 68UF 6.3V 20% 1206 |
| LQW18AN56NJ00D | INDUCTOR 56NH 360MA 0603 |
| GBM08DCCS | CONN EDGECARD 16POS R/A .156 SLD |
| TH3C476K010C0800 | CAP TANT 47UF 10V 10% 2312 |
| VI-J6H-EW-B1 | CONVERTER MOD DC/DC 52V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADP5022ACBZ-1-R7 | 制造商:Analog Devices 功能描述:DUAL BUCK REGULATOR W/LDO IC |
| ADP5022ACBZ-2-R7 | 功能描述:IC REG TRPL BCK/LINEAR 16WLCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| ADP5022ACBZ-3-R7 | 制造商:Analog Devices 功能描述:DUAL 500MA BUCK + 150MA LDO - Tape and Reel |
| ADP5022ACBZ-4-R7 | 功能描述:IC REG TRPL BCK/LINEAR 16WLCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| ADP5022ACBZ-6-R7 | 功能描述:IC REG TRPL BCK/LINEAR 16WLCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
發布緊急采購，3分鐘左右您將得到回復。