- 您現在的位置：買賣IC網 > PDF目錄19485 > ADSP-2186MBSTZ-266 (Analog Devices Inc)IC DSP CONTROLLER 16BIT 100LQFP PDF資料下載
參數資料
| 型號： | ADSP-2186MBSTZ-266 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 4/40頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DSP CONTROLLER 16BIT 100LQFP |
| 標準包裝： | 1 |
| 系列： | ADSP-21xx |
| 類型： | 定點 |
| 接口： | 主機接口，串行端口 |
| 時鐘速率： | 66MHz |
| 非易失內存： | 外部 |
| 芯片上RAM： | 40kB |
| 電壓 - 輸入/輸出： | 3.30V |
| 電壓 - 核心： | 2.50V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-LQFP |
| 供應商設備封裝： | 100-LQFP（14x14） |
| 包裝： | 托盤 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
REV. 0
–12–
ADSP-2186M
Active Configuration
Active Configuration involves the use of a three-statable external
driver connected to the Mode C pin. A driver’s output enable
should be connected to the DSP’s
RESET signal such that it
only drives the PF2 pin when
RESET is active (low). When
RESET is deasserted, the driver should three-state, thus allow-
ing full use of the PF2 pin as either an input or output. To
minimize power consumption during power-down, configure
the programmable flag as an output when connected to a three-
stated buffer. This ensures that the pin will be held at a constant
level, and will not oscillate should the three-state driver’s level
hover around the logic switching point.
IACK Configuration
Mode D = 0 and in host mode:
IACK is an active, driven signal
and cannot be “wire OR’d.”
Mode D = 1 and in host mode:
IACK is an open drain and
requires an external pull-down, but multiple
IACK pins can be
“wire OR’d” together.
MEMORY ARCHITECTURE
The ADSP-2186M provides a variety of memory and peripheral
interface options. The key functional groups are Program Memory,
Data Memory, Byte Memory, and I/O. Refer to the following
figures and tables for PM and DM memory allocations in the
ADSP-2186M.
Program Memory
Program Memory (Full Memory Mode) is a 24-bit-wide
space for storing both instruction opcodes and data. The ADSP-
2186M has 8K words of Program Memory RAM on chip, and
the capability of accessing up to two 8K external memory over-
lay spaces using the external data bus.
Program Memory (Host Mode) allows access to all internal
memory. External overlay access is limited by a single external
address line (A0). External program execution is not available in
host mode due to a restricted data bus that is 16 bits wide only.
ACCESSIBLE WHEN
PMOVLAY = 0
0x0000 –
0x1FFF2
EXTERNAL
MEMORY
0x0000 –
0x1FFF2
RESERVED
ACCESSIBLE WHEN
PMOVLAY = 2
0x2000 –
0x3FFF2
0x2000 –
0x3FFF2
EXTERNAL
MEMORY
ACCESSIBLE WHEN
PMOVLAY = 1
PMOVLAY = 0
RESERVED
0x2000 –
0x3FFF
PM (MODE B = 0)
ALWAYS
ACCESSIBLE
AT ADDRESS
0x0000 – 0x1FFF
PM (MODE B = 1)1
RESERVED
NOTES:
1WHEN MODE B = 1, PMOVLAY MUST BE SET TO 0
2SEE TABLE III FOR PMOVLAY BITS
RESERVED
0x2000 –
0x3FFF
8K
INTERNAL
0x0000
8K EXTERNAL
PMOVLAY = 1, 2
0x1FFF
0x2000
PROGRAM MEMORY
MODE B = 0
ADDRESS
0x3FFF
8K EXTERNAL
PMOVLAY = 0
0x0000
RESERVED
0x1FFF
0x2000
PROGRAM MEMORY
MODE B = 1
ADDRESS
Figure 4. Program Memory
Table III. PMOVLAY Bits
PMOVLAY
Memory
A13
A12:0
0
Reserved
Not Applicable
1
External Overlay 1
0
13 LSBs of Address Between 0x2000 and 0x3FFF
2
External Overlay 2
1
13 LSBs of Address Between 0x2000 and 0x3FFF
相關PDF資料 |
PDF描述 |
|---|---|
| RYM40DTKT-S288 | CONN EDGECARD 80POS .156 EXTEND |
| XCR3064XL-7VQ100I | IC CPLD 64 MACROCELL HP 100-VQFP |
| TPSC155M050R1500 | CAP TANT 1.5UF 50V 20% 2312 |
| MAX6646MUA+T | IC SENSOR REMOTE SMBUS 8UMAX |
| ADSP-BF522BBCZ-4A | IC DSP CTRLR 400MHZ 208CSPBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADSP-2186MBSTZ266R | 功能描述:IC DSP CONTROLLER 16BIT 100LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:ADSP-21xx 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA |
| ADSP-2186MKCA-300 | 功能描述:IC DSP CONTROLLER 16BIT 144MBGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:ADSP-21xx 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI，以太網，RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA，F(xiàn)CBGA 供應商設備封裝:431-FCPBGA（20x20） 包裝:托盤 |
| ADSP-2186MKCAZ-300 | 功能描述:IC DSP CONTROLLER 16BIT 144MBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:ADSP-21xx 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI，以太網，RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA，F(xiàn)CBGA 供應商設備封裝:431-FCPBGA（20x20） 包裝:托盤 |
| ADSP-2186MKST-300 | 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 75MHz 75MIPS 100-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:75 MHZ 16-BIT DSP,2.5V,8K/8K 2.5V,LQFP - Bulk 制造商:Analog Devices 功能描述:DIGITAL SIGNAL PROCESSOR IC ((NW)) |
| ADSP-2186MKST-300R | 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 75MHz 75MIPS 100-Pin LQFP T/R |
發布緊急采購，3分鐘左右您將得到回復。