Revision 17 3-3 should be treated as a sensitive asynchronous signal. When defining pin placement and board layou" />
參數資料
型號： AGLN-NANO-KIT
廠商： Microsemi SoC
文件頁數： 10/150頁
文件大?。?/td> 0K
描述： KIT HARDWARE FOR AGLN-NANO
標準包裝： 1
系列： IGLOO nano
類型： FPGA
適用于相關產品： AGLN250
所含物品： 板，電纜，DVD，跳線，編程器
其它名稱： 1100-1136
IGLOO nano Low Power Flash FPGAs
Revision 17
3-3
should be treated as a sensitive asynchronous signal. When defining pin placement and board layout,
simultaneously switching outputs (SSOs) and their effects on sensitive asynchronous pins must be
considered.
Unused FF or I/O pins are tristated with weak pull-up. This default configuration applies to both
Flash*Freeze mode and normal operation mode. No user intervention is required.
Table 3-1 shows the Flash*Freeze pin location on the available packages for IGLOO nano devices. The
Flash*Freeze pin location is independent of device (except for a PQ208 package), allowing migration to
larger or smaller IGLOO nano devices while maintaining the same pin location on the board. Refer to the
"Flash*Freeze Technology and Low Power Modes" chapter of the IGLOO nano FPGA Fabric User’s
Guide for more information on I/O states during Flash*Freeze mode.
JTAG Pins
Low power flash devices have a separate bank for the dedicated JTAG pins. The JTAG pins can be run
at any voltage from 1.5 V to 3.3 V (nominal). VCC must also be powered for the JTAG state machine to
operate, even if the device is in bypass mode; VJTAG alone is insufficient. Both VJTAG and VCC to the
part must be supplied to allow JTAG signals to transition the device. Isolating the JTAG power supply in a
separate I/O bank gives greater flexibility in supply selection and simplifies power supply and PCB
design. If the JTAG interface is neither used nor planned for use, the VJTAG pin together with the TRST
pin could be tied to GND.
TCK
Test Clock
Test clock input for JTAG boundary scan, ISP, and UJTAG. The TCK pin does not have an internal
pull-up/-down resistor. If JTAG is not used, Microsemi recommends tying off TCK to GND through a
resistor placed close to the FPGA pin. This prevents JTAG operation in case TMS enters an undesired
state.
Note that to operate at all VJTAG voltages, 500
to 1 k will satisfy the requirements. Refer to Table 3-2
for more information.
Table 3-1 Flash*Freeze Pin Locations for IGLOO nano Devices
Package
Flash*Freeze Pin
CS81/UC81
H2
QN48
14
QN68
18
VQ100
27
UC36
E2
Table 3-2 Recommended Tie-Off Values for the TCK and TRST Pins
VJTAG
Tie-Off Resistance 1,2
VJTAG at 3.3 V
200
to 1 k
VJTAG at 2.5 V
200
to 1 k
VJTAG at 1.8 V
500
to 1 k
VJTAG at 1.5 V
500
to 1 k
Notes:
1. The TCK pin can be pulled-up or pulled-down.
2. The TRST pin is pulled-down.
3. Equivalent parallel resistance if more than one device is on the JTAG chain
相關PDF資料
PDF描述
GEC28DRAI CONN EDGECARD 56POS R/A .100 SLD
HK100515NJ-T INDUCTOR HI FREQ 15NH 5% 0402
0210390908 CABLE JUMPER 1MM .152M 21POS
GEC31DRAH CONN EDGECARD 62POS R/A .100 SLD
ESC12DRYN CONN EDGECARD 24POS DIP .100 SLD
相關代理商/技術參數
參數描述
AGLP030V2-CS201 功能描述:IC FPGA IGLOO PLUS 30K 201-CSP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - FPGA（現場可編程門陣列） 系列:IGLOO PLUS 標準包裝:152 系列:IGLOO PLUS LAB/CLB數:- 邏輯元件/單元數:792 RAM 位總計:- 輸入/輸出數:120 門數:30000 電源電壓:1.14 V ~ 1.575 V 安裝類型:表面貼裝 工作溫度:-40°C ~ 85°C 封裝/外殼:289-TFBGA，CSBGA 供應商設備封裝:289-CSP（14x14）
AGLP030V2-CS201I 功能描述:IC FPGA IGLOO PLUS 30K 201-CSP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - FPGA（現場可編程門陣列） 系列:IGLOO PLUS 標準包裝:152 系列:IGLOO PLUS LAB/CLB數:- 邏輯元件/單元數:792 RAM 位總計:- 輸入/輸出數:120 門數:30000 電源電壓:1.14 V ~ 1.575 V 安裝類型:表面貼裝 工作溫度:-40°C ~ 85°C 封裝/外殼:289-TFBGA，CSBGA 供應商設備封裝:289-CSP（14x14）
AGLP030-V2CS289 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOO PLUS Low-Power Flash FPGAs with FlashFreeze Technology
AGLP030V2-CS289 功能描述:IC FPGA IGLOO PLUS 30K 289-CSP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - FPGA（現場可編程門陣列） 系列:IGLOO PLUS 標準包裝:152 系列:IGLOO PLUS LAB/CLB數:- 邏輯元件/單元數:792 RAM 位總計:- 輸入/輸出數:120 門數:30000 電源電壓:1.14 V ~ 1.575 V 安裝類型:表面貼裝 工作溫度:-40°C ~ 85°C 封裝/外殼:289-TFBGA，CSBGA 供應商設備封裝:289-CSP（14x14）
AGLP030-V2CS289ES 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOO PLUS Low-Power Flash FPGAs with FlashFreeze Technology
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*