參數(shù)資料
型號: AM29BDD160GT54DPBE
廠商: ADVANCED MICRO DEVICES INC
元件分類: PROM
英文描述: 16 Megabit (1 M x 16-bit/512 K x 32-Bit), CMOS 2.5 Volt-only Burst Mode, Dual Boot, Simultaneous Read/Write Flash Memory
中文描述: 512K X 32 FLASH 2.7V PROM, 54 ns, PBGA80
封裝: 13 X 11 MM, 1 MM PITCH, BGA-80
文件頁數(shù): 48/80頁
文件大小: 3476K
代理商: AM29BDD160GT54DPBE
50
Am29BDD160G
RD(0) = Read Data DQ0 protection indicator bit. If pro-
tected, DQ0 = 1, if unprotected, DQ0 = 0.
RD(1) = Read Data DQ1 protection indicator bit. If pro-
tected, DQ1 = 1, if unprotected, DQ1 = 0.
SA = Sector Address where security command applies. Ad-
dress bits A18:A11 uniquely select any sector.
SL = Persistent Protection Mode Lock Address (A5–A0) is
(010X10)
WP = PPB Address (A5–A0) is (111X10)
X = Don’t care
PPMLB = Password Protection Mode Locking Bit
SPMLB = Persistent Protection Mode Locking Bit
1. 1. See Table 1 for description of bus operations.
2. 2.All values are in hexadecimal.
3. 3.Shaded cells in table denote read cycles. All other
cycles are writer operations.
4. During unlock cycles, (lower address bits are AAA or
555h as shown in the table) address bits higher that A11
(except where BA is required) and data bits higher than
DQ7 are dont’s cares.
5. The reset command returns the device to reading the
array.
6. The fourth cycle programs the addressed locking bit. The
fifth and sixth cycles are used to validate whether the bit
is fully programmed. If DQ0 (in the sixth cycle) reads 0,
the program command must be issued and verified
again.
7. Data is latched on the rising edge of WE#.
8. The entire four bus-cycle sequence must be entered for
each portion of the password. PWA (0-3) represent the
four addresses over which the password is stored. PWD
(0-3) represent the four word data that comprise the
password.
9. The fourth cycle erases all PPBs. The fifth and sixth
cycles are used to validate whether the bits are fully
erased. If DQ0 (in the sixed cycle) reads 1, the erase
command must be issued and verified again.
10. Before issuing the erase command, all PPBs should be
programmed in order to prevent over-erasure of PPBs.
11. In the fourth cycle, 00h indicates PPB set; 01h indicates:
PPB not set.
12. The status of additional PPBs and DYBs may be read
(following the fourth cycle) without reissuing the entire
command sequence
相關PDF資料
PDF描述
AM29BDD160GT65AKE 16 Megabit (1 M x 16-bit/512 K x 32-Bit), CMOS 2.5 Volt-only Burst Mode, Dual Boot, Simultaneous Read/Write Flash Memory
AM29BDD160GT65AKF 16 Megabit (1 M x 16-bit/512 K x 32-Bit), CMOS 2.5 Volt-only Burst Mode, Dual Boot, Simultaneous Read/Write Flash Memory
AM29BDD160GT65AKI 16 Megabit (1 M x 16-bit/512 K x 32-Bit), CMOS 2.5 Volt-only Burst Mode, Dual Boot, Simultaneous Read/Write Flash Memory
AM29BDD160GT65AKK 16 Megabit (1 M x 16-bit/512 K x 32-Bit), CMOS 2.5 Volt-only Burst Mode, Dual Boot, Simultaneous Read/Write Flash Memory
AM29BDD160GT65APBE 16 Megabit (1 M x 16-bit/512 K x 32-Bit), CMOS 2.5 Volt-only Burst Mode, Dual Boot, Simultaneous Read/Write Flash Memory
相關代理商/技術參數(shù)
參數(shù)描述
AM29BDS128HE9VKI 制造商:Advanced Micro Devices 功能描述:Flash Mem Parallel/Serial 1.8V 128M-Bit 8M x 16 50ns 80-Pin FBGA
AM29BDS643GT5KVAI 制造商:Spansion 功能描述:FLASH PARALLEL 1.8V 64MBIT 4MX16 55NS 44FBGA - Trays
AM29BL802CB-65RZET 制造商:Spansion 功能描述:
AM29C01WW WAF 制造商:Advanced Micro Devices 功能描述:
AM29C10API 制造商:Rochester Electronics LLC 功能描述:- Bulk