- 您現在的位置：買賣IC網 > PDF目錄376491 > AN8018SA (PANASONIC CORP) 1.8-volt 2-channel step-up, step-down, or inverting DC-DC converter control IC PDF資料下載
參數資料
| 型號： | AN8018SA |
| 廠商： | PANASONIC CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1.8-volt 2-channel step-up, step-down, or inverting DC-DC converter control IC |
| 中文描述： | 0.05 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.225 INCH, 0.65 MM PITCH, PLASTIC, SSOP-16 |
| 文件頁數： | 18/26頁 |
| 文件大?。?/td> | 268K |
| 代理商： | AN8018SA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
18
AN8018SA
Voltage Regulators
I
Application Notes (continued)
[7] Parallel synchronous operation of multiple ICs (continued)
2. About the operation of short-circuit protection at parallel synchronous operation
In the case of the operation in parallel, if the single output (or multiple outputs) of them is short-circuited and
the timer latch short circuit protection of the IC is operated, the output of other ICs will be also shut down, then
enter into latch mode.
In figure 8, if the IC-2 entered timer latch mode, Q1 turns on and the OSC terminal (pin 1) is fixed to
approximately 1.1 V and the oscillator stops.
Then channel 1 of IC-1 becomes low level than the DT1 terminal (pin 6) voltage or high-level voltage (0.9 V)
of the FB1 terminal set by terminal voltage, and then output 2 stops by PWM1 circuit of inside. The channel 2 stops
output 2 by oscillator high-level detection comparator.
And then, the IC-1 becomes short-circuit state and enters latch mode after a certain time.
It becomes the same operation in case of the IC-1 enters latch mode previously.
S.C.P.
IC-2 side
output short-circuited
1.19 V
DT1
FB1
Out1
OSC
Since the OSC terminal voltage
becomes higher than
the DT1 terminal voltage,
the Out1 becomes fully off state.
FB2
DT2
Out2
OSC
S.C.P.
1.19 V
Oscillator high-level
detection comparator
V
OSC
=
V
REF
V
CE(sat)
=
becomes approximately 1.1 V
Forced to be in off state
inside the IC
IC-1 latch
IC-2 latch
1
0.9 V
IC-1
1
1
IC-2
Q1
1
Channel 2 goes off
at high
The IC entering to the lach mode,
Q1 turns on and,
Figure 8. Operation of short-circuit protection at parallel synchronous operation
相關PDF資料 |
PDF描述 |
|---|---|
| AN8072 | Quad, 14-Bit nanoDAC® with 5ppm/°C On-Chip Reference; Package: MSOP; No of Pins: 10; Temperature Range: Industrial |
| AN8072N | Quad, 14-Bit nanoDAC® with 5ppm/°C On-Chip Reference; Package: MSOP; No of Pins: 10; Temperature Range: Industrial |
| AN8083 | Quad, 14-Bit nanoDAC® with 5ppm/°C On-Chip Reference; Package: MSOP; No of Pins: 10; Temperature Range: Industrial |
| AN8083S | Octal, 14-Bit D/A Converter with 5 ppm/°C On-Chip Reference in 14-Lead TSSOP; Package: TSSOP; No of Pins: 16; Temperature Range: Industrial |
| AN8086 | Low Voltage Operation IC for DC-DC Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AN8018SA-E1 | 功能描述:IC REG CTRLR BST INV PWM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| AN8018SA-E1V | 功能描述:IC REG CTRLR BST INV PWM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF) |
| AN8019 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| AN-8019 | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:Reliable USB Modem Design Using the Combination of an Integrated Load Switch and a Buck Converter |
| AN80196CA | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:ADVANCED 16-BIT CHMOS MICROCONTROLLER WITH INTEGRATED CAN 2.0 |
發布緊急采購，3分鐘左右您將得到回復。