- 您現在的位置：買賣IC網 > PDF目錄378405 > AND8067 (ON SEMICONDUCTOR) NL27WZ04 Dual Gate Inverter Oscillator Increases the Brightness of LEDs While Reducing Power Consumption PDF資料下載
參數資料
| 型號： | AND8067 |
| 廠商： | ON SEMICONDUCTOR |
| 英文描述： | NL27WZ04 Dual Gate Inverter Oscillator Increases the Brightness of LEDs While Reducing Power Consumption |
| 中文描述： | NL27WZ04雙門變頻振蕩器的提高，同時降低功耗的LED亮度 |
| 文件頁數： | 2/8頁 |
| 文件大小： | 62K |
| 代理商： | AND8067 |
AND8067/D
http://onsemi.com
2
Agilent Technologies HLMP subminiature LED lamps [3].
For example, the pulsed emerald green LED will have a light
output approximately 30% brighter then the equivalent DC
drive circuit at a peak pulsed current of 30 mA. Note that the
pulsed circuit does not always produce a brighter LED. The
pulsed emerald green LED has a brighter light output at peak
currents greater than 10 mA; however, the DC circuit
produces a brighter LED for peak currents less than 10 mA.
Figure 2. LED Efficiency – Pulsed vs. DC Operation
LED Drive Techniques
DC Method
Single LEDs are often driven using either a high side or
low side switch. The conventional LED interface circuit
consists of an open collector/drain driver to sink the LED
current as shown in Figure 3. The brightness of the LED is
proportional to the current (I
f
) through the diode. The
current through the LED for a current sinking configuration
is calculated using V
CC
, V
f
, R, and the voltage drop across
the driver (V
Switch
) as shown below.
VCC
Vf
If
VSwitch
R
Figure 3. Conventional Open Collector DC LED Circuit
V
CC
R
LED
ON/OFF
I
f
AC Method
The second method to drive LEDs uses a pulsating square
wave voltage. The suggested frequency and duty cycle
varies for different LEDs; however, the typical frequency
used is 1 kHz with a 10 to 30% duty cycle. Pulsing LEDs is
the standard method used with multiplexed displays when a
single driver circuit is interfaced to multiple LEDs. The
current through a pulsed current sourcing driver such as the
oscillator circuit shown in Figure 1 is calculated as shown
below.
If
VOH
Vf
R
Duty Cycle
(current sourcing driver)
The equation for a current sinking AC driver is similar to
the DC method, except that the duty cycle is used to reduce
the current consumption.
If
VCC
Vf
VSwitch
R
Duty Cycle
(current sinking driver)
Dual Gate Inverter Oscillator Circuit
The LED oscillator circuit, shown in Figure 1 is derived
from the conventional two–inverter oscillator shown in
Figure 4. The conventional oscillator is often denoted as an
astable multivibrator and has a duty cycle of approximately
50%. In contrast, the LED oscillator circuit has two RC time
constants so that both the duty cycle and frequency can be
adjusted. R
2
and C
2
control the “ON” time of the LED pulse,
while R
1
and C
1
control the “OFF” time.
Figure 4. Conventional Inverter Oscillator
U
1A
U
1B
R
1
C
1
R
2
fOscillation
1
2.3R1C1
(R2
10R1)
The LED oscillator with the NL27WZ04 duel gate
inverter and the given RC values is stable and does not have
the oscillation start–up problem that often occurs with the
conventional two inverter oscillator. In order to ensure
oscillation at power–up, R
4
was added in parallel with C
2
to
provide a DC path through the capacitor. The parallel
impedance combination of R
4
and C
2
is effectively equal to
the impedance of C
2
at the oscillation frequency; therefore,
R
4
does not effect the oscillation frequency.
The NL27WZ04 dual inverter is a standard buffered
inverter that produces either a “high” (i.e. V
cc
) or a “l(fā)ow”
相關PDF資料 |
PDF描述 |
|---|---|
| AND8079 | A Low Cost DDR Memory Power Supply Using the NCP1571 Synchronous Buck Converter and a LM358 Based Linear Voltage Regulator |
| AND8079D | A Low Cost DDR Memory Power Supply Using the NCP1571 Synchronous Buck Converter and a LM358 Based Linear Voltage Regulator |
| AND8085 | An Introduction to FST |
| AND8085D | An Introduction to FST |
| AND8090 | AC Characteristics of ECL Devices |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AND8079 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:A Low Cost DDR Memory Power Supply Using the NCP1571 Synchronous Buck Converter and a LM358 Based Linear Voltage Regulator |
| AND8079D | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:A Low Cost DDR Memory Power Supply Using the NCP1571 Synchronous Buck Converter and a LM358 Based Linear Voltage Regulator |
| AND8085 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:An Introduction to FST |
| AND8085D | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:An Introduction to FST |
| AND8090 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:AC Characteristics of ECL Devices |
發布緊急采購，3分鐘左右您將得到回復。