- 您現在的位置：買賣IC網 > PDF目錄295067 > AP2014SG-13 (DIODES INC) PDF資料下載
參數資料
| 型號： | AP2014SG-13 |
| 廠商： | DIODES INC |
| 元件分類： | 穩壓器 |
| 中文描述： | SWITCHING CONTROLLER, 230 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | GREEN, SOP-8 |
| 文件頁數： | 7/14頁 |
| 文件大小： | 264K |
| 代理商： | AP2014SG-13 |
AP2014/A
SYNCHRONOUS PWM CONTROLLER
AP2014/A Rev. 5
2 of 14
FEBRUARY 2009
Diodes Incorporated
Pin Assignment
1
2
3
4
8
7
6
5
FB
Vc
LDrv
HDrv
VCC
SS
Comp
GND
( Top View )
SOP-8L
Pin Descriptions
Pin Name
Pin No.
Description
FB
1
This pin is connected directly to the output of the switching regulator via resistor
divider to provide feedback to the Error amplifier.
Vcc
2
This pin provides biasing for the internal blocks of the IC as well as power for the
low side driver. A minimum of 1uF, high frequency capacitor must be connected
from this pin to ground to provide peak drive current capability.
LDrv
3
Output driver for the synchronous power MOSFET.
GND
4
This pin serves as the ground pin and must be connected directly to the ground
plane. A high frequency capacitor (0.1 to 1uF) must be connected from V5 and
V12 pins to this pin for noise free operation.
HDrv
5
Output driver for the high side power MOSFET.
Vc
6
This pin is connected to a voltage that must be at least 4V higher than the bus
voltage of the switcher (assuming 5V threshold MOSFET) and powers the high
side output driver. A minimum of 1uF, high frequency capacitor must be
connected from this pin to ground to provide peak drive current capability.
Comp
7
Compensation pin of the error amplifier. An external resistor and capacitor
network is typically connected from this pin to ground to provide loop
compensation.
SS
8
This pin provides soft-start for the switching regulator. An internal current source
charges an external capacitor that is connected from this pin to ground which
ramps up the output of the switching regulator, preventing it from overshooting as
well as limiting the input current. The converter can be shutdown by pulling this
pin below 0.5V.
相關PDF資料 |
PDF描述 |
|---|---|
| AP2112K-2.5TRG1 | 2.5 V FIXED POSITIVE LDO REGULATOR, 0.4 V DROPOUT, PDSO5 |
| AP2112R5-1.8TRG1 | 1.8 V FIXED POSITIVE LDO REGULATOR, 0.7 V DROPOUT, PDSO5 |
| AP2112R5A-2.6TRG1 | 2.6 V FIXED POSITIVE LDO REGULATOR, 0.4 V DROPOUT, PDSO5 |
| AP2115R5-1.8TRG1 | 1.8 V FIXED POSITIVE LDO REGULATOR, 0.75 V DROPOUT, PDSO5 |
| AP2120N-1.5TRG1 | 1.5 V FIXED POSITIVE LDO REGULATOR, 0.6 V DROPOUT, PDSO3 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AP2014SL-13 | 功能描述:電流型 PWM 控制器 SW REG CNTL BUCK BI 200K 3A 20V 1.25V RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| AP2014SL-U | 功能描述:電流型 PWM 控制器 SW REG CNTL BUCK BI 200K 3A 20V 1.25V RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| AP2014SM | 制造商:DIODES 制造商全稱:Diodes Incorporated 功能描述:SYNCHRONOUS PWM DC-DC BUCK CONTROLLER |
| AP2014SM-13 | 制造商:DIODES 制造商全稱:Diodes Incorporated 功能描述:SYNCHRONOUS PWM DC-DC BUCK CONTROLLER |
| AP2014SM-7 | 制造商:DIODES 制造商全稱:Diodes Incorporated 功能描述:SYNCHRONOUS PWM DC-DC BUCK CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。