- 您現在的位置：買賣IC網 > PDF目錄166229 > AS2700AT-5.0 5 V FIXED POSITIVE LDO REGULATOR, 0.5 V DROPOUT, PSSO2 PDF資料下載
參數資料
| 型號： | AS2700AT-5.0 |
| 元件分類： | 固定正電壓單路輸出LDO穩壓器 |
| 英文描述： | 5 V FIXED POSITIVE LDO REGULATOR, 0.5 V DROPOUT, PSSO2 |
| 封裝： | TO-263, 3 PIN |
| 文件頁數： | 3/9頁 |
| 文件大?。?/td> | 145K |
| 代理商： | AS2700AT-5.0 |
Rev. 10/11/00
AS2700/01/02
ELECTRICAL CHARACTERISTICS at VIN = VO + 5V, IO = 700mA, CO = 22 F, unless otherwise specified. Limits in
Boldface type apply over the entire operating temperature range. All other specifications are TA = 25
°C.
Parameter
Conditions
Typ.
AS2700/01/02A
Min
Max
AS2700/01/02B
Min
Max
Units
Error Comparator
Output Leakage Current
VOH = 30V
0.01
1.00
2.00
1.00
2.00
A
Output Low Voltage
VIN = 4.5V
IOL = 400A
150
250
400
250
400
mV
Upper Threshold Voltage
(Note 8)
60
40
25
40
25
mV
Lower Threshold Voltage
(Note 8)
75
95
140
95
140
mV
Hysteresis
(Note 8)
15
mV
Shutdown Input
Input Logic Voltage
Low (Regulator ON)
High (Regulator OFF)
2.0
0.7
2.0
0.7
V
Shutdown Pin Input Current
VS = 2.4V
VS = 30V
30
450
50
100
600
750
90
150
800
1000
A
Regulator Output Current In
Shutdown
3
10
20
15
25
A
Note 1: Output or reference voltage temperature coefficients defined as the worst case voltage change divided by the total temperature range.
Note 2: Unless otherwise specified all limits are guaranteed for Tj = 25
°C, VIN = 6V, IL = 100A and CL = 1F. Additional conditions for the 8-pin versions are
feedback tied to 5V tap and output tied to output sense (VOUT = 5V) and VSHUTDOWN
≤ 0.8V.
Note 3: Regulation is measured at constant junction temperature, using pulse testing with a low duty cycle. Changes in output voltage due to heating effects are
covered under the specification for thermal regulation.
Note 4: Line regulation for the AS2700/01/02 is tested at 150
°C for IL = 1 mA. For IL = 100A and TJ = 125°C, line regulation is guaranteed by design to 0.2%. See
typical performance characteristics for line regulation versus temperature and load current.
Note 5: Dropout voltage is defined as the input to output differential at which the output voltage drops 100 mV below its nominal value measured at 1V differential at
very low values of programmed output voltage, the minimum input supply voltage of 2V ( 2.3V over temperature) must be taken into account.
Note 6: VREF
≤VOUT ≤ (Vin - 1V), 2.3 ≤Vin≤30V, 100A≤IL≤ 250 mA, TJ ≤ TJMAX.
Note 7: Comparator thresholds are expressed in terms of a voltage differential at the feedback terminal below the nominal reference voltage measured at 6V input. To
express these thresholds in terms of output voltage change, multiply by the error amplifier gain = VOUT/VREF = (R1 + R2)/R2. For example, at a programmed output
voltage of 5V, the Error output is guaranteed to go low when the output drops by 95 mV x 5V/1.235 = 384 mV. Thresholds remain constant as a percent of VOUT as
VOUT is varied, with the dropout warning occurring at typically 5% below nominal, 7.5% guaranteed.
Note 8: VSHUTDOWN
≥ 2V, VIN ≤ 30V, VOUT =0, Feedback pin tied to 5V Tap.
Note 9: The junction -to-ambient thermal resistance of the TO-92 package is 180
°C/ W with 0.4” leads and 160°C/ W with 0.25” leads to a PC board.
The thermal resistance of the 8-Pin DIP package is 105
°C/W junction-to-ambient when soldered directly to a PC board. Junction-to-ambient thermal resistance for the
SOIC (S) package is 160
°C/W.
FEEDBACK
INPUT
OUTPUT
UNREGULATED DC
SHUTDOWN
GROUND
ERROR
______
5V TAP
SENSE
5V @ 700mA
MAX
TO CMOS OR
TTL
REFERENCE
ERROR DETECTION
COMPARATOR
ERROR
AMPLIFIER
1.23V
FROM
CMOS OR
TTL
+
60 mV
..
60k
330k
180k
..
1 F
_
AS2700/01/02 Block Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| AS2700AU-5.0 | 5 V FIXED POSITIVE LDO REGULATOR, 0.5 V DROPOUT, PSFM3 |
| AS2700T | 1.235 V-30 V ADJUSTABLE POSITIVE LDO REGULATOR, 0.5 V DROPOUT, PSSO5 |
| AS2700U | 1.235 V-30 V ADJUSTABLE POSITIVE LDO REGULATOR, 0.5 V DROPOUT, PSFM5 |
| AS273-G5-LPL | SPECIALTY ANALOG CIRCUIT, PBCY3 |
| AS2732T-3.3 | 3.3 V FIXED POSITIVE LDO REGULATOR, 0.6 V DROPOUT, PSSO2 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AS2701 | 制造商:ACC SILICONES 功能描述:ADHESIVE, SILICONE, TC FAST CURE, 264ML |
| AS2701A | 制造商:AMSCO 制造商全稱:austriamicrosystems AG 功能描述:AS-Interface Slave IC |
| AS2701AT | 制造商:AMSCO 制造商全稱:austriamicrosystems AG 功能描述:AS-Interface Slave IC |
| AS2702 | 制造商:AMSCO 制造商全稱:austriamicrosystems AG 功能描述:AS-Interface Slave IC |
| AS2702/SOIC16-SAMPLE | 制造商:AMS 功能描述:AS Series 22.5 to 34 V Surface Mount AS-Interface Slave SOIC-16 |
發布緊急采購，3分鐘左右您將得到回復。