參數資料
型號： AT17LV002-10JU
廠商： Atmel
文件頁數： 24/26頁
文件大?。?/td> 0K
描述： IC SRL CONFIG EEPROM 2M 20-PLCC
標準包裝： 50
可編程類型： 串行 EEPROM
存儲容量： 2Mb
電源電壓： 3 V ~ 3.6 V，4.5 V ~ 5.5 V
工作溫度： -40°C ~ 85°C
封裝/外殼： 20-LCC（J 形引線）
供應商設備封裝： 20-PLCC
包裝： 管件
產品目錄頁面： 609 (CN2011-ZH PDF)
配用： ATDH2225-ND - CABLE ISP FOR AT17
ATDH2200E-ND - CONFIGURATOR PROGRAM BOARD KIT
7
2321I–CNFG–2/08
AT17LV65/128/256/512/010/002/040
4.1
DATA
Three-state DATA output for configuration. Open-collector bi-directional pin for programming.
4.2
CLK
Clock input. Used to increment the internal address and bit counter for reading and
programming.
4.3
WP1
WRITE PROTECT (1). Used to protect portions of memory during programming. Disabled
by default due to internal pull-down resistor. This input pin is not used during FPGA loading
operations. This pin is only available on AT17LV512/010/002 devices.
4.4
RESET/OE
Output Enable (active High) and RESET (active Low) when SER_EN is High. A Low level on
RESET/OE resets both the address and bit counters. A High level (with CE Low) enables the
data output driver. The logic polarity of this input is programmable as either RESET/OE or
RESET/OE. For most applications, RESET should be programmed active Low. This document
describes the pin as RESET/OE.
4.5
WP
Write protect (WP) input (when CE is Low) during programming only (SER_EN Low). When WP
is Low, the entire memory can be written. When WP is enabled (High), the lowest block of the
memory cannot be written. This pin is only available on AT17LV65/128/256 devices.
4.6
WP2
WRITE PROTECT (2). Used to protect portions of memory during programming. Disabled
by default due to internal pull-down resistor. This input pin is not used during FPGA loading
operations. This pin is only available on AT17LV512/010 devices.
4.7
CE
Chip Enable input (active Low). A Low level (with OE High) allows CLK to increment the address
counter and enables the data output driver. A High level on CE disables both the address and bit
counters and forces the device into a low-power standby mode. Note that this pin will not
enable/disable the device in the Two-Wire Serial Programming mode (SER_EN Low).
4.8
GND
Ground pin. A 0.2 F decoupling capacitor between V
CC and GND is recommended.
4.9
CEO
Chip Enable Output (active Low). This output goes Low when the address counter has reached
its maximum value. In a daisy chain of AT17LV series devices, the CEO pin of one device must
be connected to the CE input of the next device in the chain. It will stay Low as long as CE is
Low and OE is High. It will then follow CE until OE goes Low; thereafter, CEO will stay High until
the entire EEPROM is read again. This CEO feature is not available on the AT17LV65 device.
相關PDF資料
PDF描述
AT17LV002A-10JU IC SRL CONFIG EEPROM 2M 20-PLCC
RS1KB-13-F DIODE FAST REC 800V 1A SMB
T95R336K035LABS CAP TANT 33UF 35V 10% 2824
AT17LV010-10JU IC SRL CONFIG EEPROM 1M 20-PLCC
AT17LV010-10CU IC SRL CONFIG EEPROM 1M 8-LAP
相關代理商/技術參數
參數描述
AT17LV002-10NC 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV002-10NI 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV002-10PC 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV002-10PI 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV002-10SC 功能描述:FPGA-配置存儲器 Serial EEPROM RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*