參數資料
型號: AT17LV010A-10JU
廠商: Atmel
文件頁數: 14/18頁
文件大小: 0K
描述: IC CONFIG SEEPROM 1M 3.3V 20PLCC
標準包裝: 50
可編程類型: 串行 EEPROM
存儲容量: 1Mb
電源電壓: 3 V ~ 3.6 V,4.5 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
封裝/外殼: 20-LCC(J 形引線)
供應商設備封裝: 20-PLCC
包裝: 管件
產品目錄頁面: 609 (CN2011-ZH PDF)
配用: ATDH2225-ND - CABLE ISP FOR AT17
ATDH2200E-ND - CONFIGURATOR PROGRAM BOARD KIT
5
2322G–CNFG–03/06
AT17LV65A/128A/256A/512A/002A
4.1
DATA
Three-state DATA output for configuration. Open-collector bi-directional pin for programming.
4.2
DCLK
Clock output or clock input. Rising edges on DCLK increment the internal address counter and
present the next bit of data to the DATA pin. The counter is incremented only if the RESET/OE
input is held High, the nCS input is held Low, and all configuration data has not been transferred
to the target device (otherwise, as the master device, the DCLK pin drives Low).
4.3
WP1
WRITE PROTECT (1). This pin is used to protect portions of memory during programming, and
it is disabled by default due to internal pull-down resistor. This input pin is not used during FPGA
loading operations. This pin is only available on AT17LV512A/010A/002A devices.
4.4
RESET/OE
Output Enable (active High) and RESET (active Low) when SER_EN is High. A Low logic level
resets the address counter. A High logic level (with nCS Low) enables DATA and permits the
address counter to count. In the mode, if this pin is Low (reset), the internal oscillator becomes
inactive and DCLK drives Low. The logic polarity of this input is programmable and must be pro-
grammed active High (RESET active Low) by the user during programming for Altera
applications.
4.5
WP
Write protect (WP) input (when nCS is Low) during programming only (SER_EN Low). When
WP is Low, the entire memory can be written. When WP is enabled (High), the lowest block of
the memory cannot be written. This pin is only available on AT17LV65A/128A/256A devices.
4.6
nCS
Chip Select input (active Low). A Low input (with OE High) allows DCLK to increment the
address counter and enables DATA to drive out. If the AT17A series is reset with nCS Low, the
device initializes as the first (and master) device in a daisy-chain. If the AT17A series is reset
with nCS High, the device initializes as a subsequent AT17A series device in the chain.
4.7
GND
Ground pin. A 0.2 F decoupling capacitor between V
CC and GND is recommended.
4.8
nCASC
Cascade Select Output (active Low). This output goes Low when the address counter has
reached its maximum value. In a daisy-chain of AT17A series devices, the nCASC pin of one
device is usually connected to the nCS input pin of the next device in the chain, which permits
DCLK from the master configurator to clock data from a subsequent AT17A series device in the
chain. This feature is not available on the AT17LV65A device.
4.9
A2
Device selection input, A2. This is used to enable (or select) the device during programming
(i.e., when SER_EN is Low). A2 has an internal pull-down resistor.
相關PDF資料
PDF描述
BP5277-33 IC BUCK CONVERTER MOD 3.3V SIP3
ADM1172-2AUJZ-RL7 IC CTRLR HOTSWAP 16.5V TSOT-23-8
AT17LV512-10JU IC SRL CONFG EEPROM 512K 20-PLCC
1250F10 BATTERY PK S-HD 15.0V DSIZE ZINC
AT17LV512-10CU IC SRL CONFIG EEPROM 512K 8-LAP
相關代理商/技術參數
參數描述
AT17LV010A-10NC 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV010A-10NI 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV010A-10PC 功能描述:FPGA-配置存儲器 1M-BIT CONFIG EEPROM ALTERA PINOUT-10MHZ RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20
AT17LV010A-10PI 功能描述:FPGA-配置存儲器 2M bit FPGA RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20
AT17LV010A-10PU 功能描述:FPGA-配置存儲器 1M-BIT CONFIG EEPROM ALTERA PINOUT-1M-BIT RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20