參數資料
型號: AT32UC3C264C-A2UR
廠商: Atmel
文件頁數: 28/110頁
文件大?。?/td> 0K
描述: IC MCU AVR32 64K FLASH 64TQFP
產品培訓模塊: AVR® UC3 Introduction
標準包裝: 1
系列: AVR®32 UC3 C
核心處理器: AVR
芯體尺寸: 32-位
速度: 66MHz
連通性: CAN,以太網,I²C,IrDA,LIN,SPI,UART/USART,USB
外圍設備: 欠壓檢測/復位,DMA,I²S,POR,PWM,WDT
輸入/輸出數: 45
程序存儲器容量: 64KB(64K x 8)
程序存儲器類型: 閃存
RAM 容量: 16K x 8
電壓 - 電源 (Vcc/Vdd): 3 V ~ 5.5 V
數據轉換器: A/D 11x12b,D/A 2x12b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 64-TQFP
包裝: 標準包裝
其它名稱: AT32UC3C264C-A2URDKR
24
32117DS–AVR-01/12
AT32UC3C
3.4
I/O Line Considerations
3.4.1
JTAG pins
The JTAG is enabled if TCK is low while the RESET_N pin is released. The TCK, TMS, and TDI
pins have pull-up resistors when JTAG is enabled. The TCK pin always have pull-up enabled
during reset. The TDO pin is an output, driven at VDDIO1, and has no pull-up resistor. The
JTAG pins can be used as GPIO pins and muxed with peripherals when the JTAG is disabled.
Please refer to Section 3.2.4 for the JTAG port connections.
3.4.2
RESET_N pin
The RESET_N pin integrates a pull-up resistor to VDDIO1. As the product integrates a power-on
reset cell, the RESET_N pin can be left unconnected in case no reset from the system needs to
be applied to the product.
The RESET_N pin is also used for the aWire debug protocol. When the pin is used for debug-
ging, it must not be driven by external circuitry.
3.4.3
TWI pins
When these pins are used for TWI, the pins are open-drain outputs with slew-rate limitation and
inputs with inputs with spike-filtering. When used as GPIO-pins or used for other peripherals, the
pins have the same characteristics as GPIO pins.
3.4.4
GPIO pins
All I/O lines integrate programmable pull-up and pull-down resistors. Most I/O lines integrate
drive strength control, see Table 3-1
. Programming of this pull-up and pull-down resistor or this
drive strength is performed independently for each I/O line through the GPIO Controllers.
After reset, I/O lines default as inputs with pull-up/pull-down resistors disabled. After reset, out-
put drive strength is configured to the lowest value to reduce global EMI of the device.
When the I/O line is configured as analog function (ADC I/O, AC inputs, DAC I/O), the pull-up
and pull-down resistors are automatically disabled.
DP
USB Device Port Data +
Analog
VBUS
USB VBUS Monitor and OTG Negociation
Analog
Input
ID
ID Pin of the USB Bus
Input
VBOF
USB VBUS On/off: bus power control port
output
Table 3-7.
Signal Description List
Signal Name
Function
Type
Active
Level
Comments
相關PDF資料
PDF描述
LTC1756EGN#PBF IC SMART CARD INTERFACE 16SSOP
AT89C51IC2-RLRUL IC 8051 MCU 32K FLASH 44-VQFP
ATMEGA645V-8AUR MCU AVR 64KB FLASH 8MHZ 64TQFP
ATMEGA645-16AUR MCU AVR 64KB FLASH 16MHZ 64TQFP
ADV3003ACPZ IC EQUALZR HDMI/DVI TMDS 40LFCSP
相關代理商/技術參數
參數描述
AT32UC3C264C-A2UT 功能描述:32位微控制器 - MCU UC3C 64K FLASH 16K SRAM RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
AT32UC3C264C-Z2UR 功能描述:32位微控制器 - MCU 64KB Flash 64QFN (-40oC to 85oC) T&R RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
AT32UC3C264C-Z2UT 功能描述:32位微控制器 - MCU 64KB Flash 64QFN (-40oC to 85oC) TRAY RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
AT32UC3C264EGS-Z2ZR 制造商:Atmel Corporation 功能描述:32-BIT ATMEL? AVR? MCU - Tape and Reel
AT32UC3C-EK 功能描述:開發板和工具包 - AVR AVR32 Eval Kit for AT32UC3C Series RoHS:否 制造商:Arduino 產品:Evaluation Boards 工具用于評估:ATMega32U4 核心:AVR 接口類型:I2C, UART, USB 工作電源電壓:6 V to 20 V