參數資料
| 型號： | AT88SC018-SU-CN |
| 廠商： | Atmel |
| 文件頁數： | 7/11頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CRYPTOCOMPANION RF/MEM 8SOIC |
| 產品培訓模塊： | CryptoAuthentication™ Introduction |
| 標準包裝： | 100 |
| 系列： | * |
CryptoCompanion
Chip
5
5277DS–CryptoCompanion–9/09
The system processor is expected to properly format commands for CryptoCompanion (which may include information
from the CRF chip), and then process the outputs of CryptoCompanion (which may include sending some of the
outputs to the CRF chip).
CryptoCompanion cannot directly communicate with CRF chips. Both CRF and CryptoCompanion are slave devices.
The bus master may use one or two busses to communicate with them. Separate TWI addresses must be used if both
chips are on the same bus.
1.4.
Memory Locking
When this initialization is complete the Lock command should be executed which limits access to the memory per the
restrictions listed later in this section. The system can determine the current lock value by using the
ReadManufacturingID command to read out the ManufacturingID value (MfrID) and the lock byte.
The table below describes the encoding of the least significant two bits of the Lock byte. On shipment from Atmel,
Lock[1:0] will have a value of either 10 or 00, depending on the part number ordered. An AT88SC018 in either of these
two states is considered ‘unlocked’. It is not possible to change from one of these unlocked states to the other.
After the Lock command has been executed, the Lock byte will have the value 0xFF. Subsequent changes to the Lock
byte are impossible.
Table 2.
Memory Locking
LockBit 1
Lock Bit 0 (LSB)
Meaning
1
Locked. ReadMemory & WriteMemory enabled, subject to the restrictions in this
section. WriteMemoryEncrypted and ReadMemoryDigest disabled.
1
0
Unlocked/Confidential. ReadMemoryDigest, WriteMemory and
WriteMemoryEncrypted enabled. ReadMemory disabled.
0
Unlocked. ReadMemory & WriteMemory enabled. WriteMemoryEncrypted and
ReadMemoryDigest disabled.
2.
AC & DC Characteristics
Table 3.
DC Characteristics
(1)
Applicable over recommended operating range from VCC = +2.7 to 3.6 V,
TAC = -40
o C to 85o C (unless otherwise noted)
Symbol
Parameter
Test Condition
Min
Typ
Max
Units
VCC
Supply Voltage
2.7
3.6
V
ICC
Supply Current
400kHz
5
mA
ISB
Standby Current
VIN = VCC or GND
15
μA
VIL
SDA Input Low Voltage
-0.3
VCC x 0.3
V
VIL
CLK Input Low Voltage
-0.3
VCC x 0.3
V
VIL
RST Input Low Voltage
-0.3
VCC x 0.3
V
VIL
PDN Input Low Voltage
-0.3
VCC x 0.3
V
VIH
SDA Input High Voltage
VCC x 0.7
5.25
V
VIH
SCL Input High Voltage
VCC x 0.7
5.25
V
VIH
RST Input High Voltage
VCC x 0.7
5.25
V
相關PDF資料 |
PDF描述 |
|---|---|
| LFEC3E-3FN256I | IC FPGA 3.1KLUTS 256FPBGA |
| LFXP3E-3T144C | IC FPGA 3.1KLUTS 100I/O 144-TQFP |
| RMC60DRES-S93 | CONN EDGECARD 120PS .100 EYELET |
| FMC10DRES-S93 | CONN EDGECARD 20POS .100 EYELET |
| EMC49DRTS-S93 | CONN EDGECARD 98POS DIP .100 SLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AT88SC018-SU-CN-T | 功能描述:電可擦除可編程只讀存儲器 CryMem Comp 8ld, Green RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| AT88SC0204C | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:CryptoMemory Specification For Standard Mode of Operation |
| AT88SC0204C_07 | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:CryptoMemory 2 Kbit |
| AT88SC0204C_09 | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:CryptoMemory 2 Kbit |
| AT88SC0204C-09CT-XX | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EEPROM |
發布緊急采購，3分鐘左右您將得到回復。