- 您現在的位置：買賣IC網 > PDF目錄3836 > AT91M55800A-33CI SL383 (Atmel)IC ARM MCU 16BIT 176BGA PDF資料下載
參數資料
| 型號： | AT91M55800A-33CI SL383 |
| 廠商： | Atmel |
| 文件頁數： | 7/28頁 |
| 文件大小： | 0K |
| 描述： | IC ARM MCU 16BIT 176BGA |
| 標準包裝： | 1,000 |
| 系列： | AT91 |
| 核心處理器： | ARM7 |
| 芯體尺寸： | 16/32-位 |
| 速度： | 33MHz |
| 連通性： | EBI/EMI，SPI，UART/USART |
| 外圍設備： | POR，WDT |
| 輸入/輸出數： | 58 |
| 程序存儲器類型： | ROMless |
| RAM 容量： | 8K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2.7 V ~ 3.6 V |
| 數據轉換器： | A/D 8x10b; D/A 2x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 176-LFBGA |
| 包裝： | 帶卷 (TR) |
| 配用： | AT91EB55-ND - KIT EVAL FOR ARM AT91M55800A |
| 其它名稱： | AT91M55800A33CISL |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
15
1745FS–ATARM–18-Apr-06
AT91M55800A Summary
In order to benefit the most regarding the separation of NRST and NTRST during the Debug
phase of development, the user must independently manage both signals as shown in exam-
ple (1) of Figure 7-1 above. However, once Debug is completed, both signals are easily
managed together during production as shown in example (2) of Figure 7-1 above.
7.4.3
Watchdog Reset
The watchdog can be programmed to generate an internal reset. In this case, the reset has
the same effect as the NRST pin assertion, but the BMS and NTRI pins are not sampled. Boot
Mode and Tri-state Mode are not updated. If the NRST pin is asserted and the watchdog trig-
gers the internal reset, the NRST pin has priority.
7.5
Emulation Functions
7.5.1
Tri-state Mode
The AT91M55800A provides a Tri-state Mode, which is used for debug purposes. This
enables the connection of an emulator probe to an application board without having to desol-
der the device from the target board. In Tri-state Mode, all the output pin drivers of the
AT91M55800A microcontroller are disabled.
To enter Tri-state Mode, the NTRI pin must be held low during the last 10 clock cycles before
the rising edge of NRST. For normal operation the NTRI pin must be held high during reset, by
a resistor of up to 400K Ohm.
NTRI is multiplexed with I/O line PA18 and USART 1 serial data transmit line TXD1.
Standard RS232 drivers generally contain internal 400K Ohm pull-up resistors. If TXD1 is con-
nected to a device not including this pull-up, the user must make sure that a high level is tied
on NTRI while NRST is asserted.
7.5.2
JTAG/ICE Debug Mode
ARM Standard Embedded In-Circuit Emulation is supported via the JTAG/ICE port. It is con-
nected to a host computer via an external ICE Interface. The JTAG/ICE debug mode is
enabled when JTAGSEL is low.
In ICE Debug Mode the ARM Core responds with a non-JTAG chip ID which identifies the core
to the ICE system. This is not JTAG compliant.
7.5.3
IEEE 1149.1 JTAG Boundary-scan
JTAG Boundary-scan is enabled when JTAGSEL is high. The functions SAMPLE, EXTEST
and BYPASS are implemented. There is no JTAG chip ID. The Special Function module pro-
vides a chip ID which is independent of JTAG.
It is not possible to switch directly between JTAG and ICE operations. A chip reset must be
performed (NRST and NTRST) after JTAGSEL is changed.
7.6
Memory Controller
The ARM7TDMI processor address space is 4G bytes. The memory controller decodes the
internal 32-bit address bus and defines three address spaces:
Internal memories in the four lowest megabytes
Middle space reserved for the external devices (memory or peripherals) controlled by the
EBI
相關PDF資料 |
PDF描述 |
|---|---|
| AT91M42800A-33CI SL383 | IC ARM MCU 16BIT 144BGA |
| AT91M42800A-33AI SL383 | IC ARM MCU 16BIT 144TQFP |
| PIC16F84A-20/SS | IC MCU FLASH 1KX14 EE 20SSOP |
| PIC18F2510-I/SP | IC MCU FLASH 16KX16 28-DIP |
| PIC24FJ128GA308-I/PT | MCU 16BIT 128KB FLASH 80TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AT91M55800A-33CI-T | 功能描述:IC MCU 32BIT ROMLESS 176LFBGA 制造商:microchip technology 系列:AT91 包裝:帶卷（TR） 零件狀態:停產 核心處理器:ARM7? 核心尺寸:16/32-位 速度:33MHz 連接性:EBI/EMI，SPI，UART/USART 外設:POR，WDT I/O 數:58 程序存儲容量:- 程序存儲器類型:ROMless EEPROM 容量:- RAM 容量:8K x 8 電壓 - 電源（Vcc/Vdd）:2.7 V ~ 3.6 V 數據轉換器:A/D 8x10b；D/A 2x10b 振蕩器類型:內部 工作溫度:-40°C ~ 85°C（TA） 封裝/外殼:176-LFBGA 供應商器件封裝:176-LFBGA（11.2x11.2） 基本零件編號:AT91M55800 標準包裝:1,000 |
| AT91M55800A-33CJ | 功能描述:ARM微控制器 - MCU BGA IND TEMP RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| AT91M55800A-33CJ SL383 | 功能描述:IC ARM MCU 16BIT 176BGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:AT91 標準包裝:1,500 系列:AVR® ATtiny 核心處理器:AVR 芯體尺寸:8-位 速度:16MHz 連通性:I²C，LIN，SPI，UART/USART，USI 外圍設備:欠壓檢測/復位，POR，PWM，溫度傳感器，WDT 輸入/輸出數:16 程序存儲器容量:8KB（4K x 16） 程序存儲器類型:閃存 EEPROM 大小:512 x 8 RAM 容量:512 x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 11x10b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 包裝:帶卷 (TR) |
| AT91M55800A-33CJ-999 | 功能描述:ARM微控制器 - MCU BGA Ind. Temp RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| AT91M55800A-33CJ-T | 功能描述:IC MCU 32BIT ROMLESS 176LFBGA 制造商:microchip technology 系列:AT91 包裝:帶卷（TR） 零件狀態:停產 核心處理器:ARM7? 核心尺寸:16/32-位 速度:33MHz 連接性:EBI/EMI，SPI，UART/USART 外設:POR，WDT I/O 數:58 程序存儲容量:- 程序存儲器類型:ROMless EEPROM 容量:- RAM 容量:8K x 8 電壓 - 電源（Vcc/Vdd）:2.7 V ~ 3.6 V 數據轉換器:A/D 8x10b；D/A 2x10b 振蕩器類型:內部 工作溫度:-40°C ~ 85°C（TA） 封裝/外殼:176-LFBGA 供應商器件封裝:176-LFBGA（11.2x11.2） 基本零件編號:AT91M55800 標準包裝:1,000 |
發布緊急采購，3分鐘左右您將得到回復。