參數資料
型號： AT91SAM7S512-AU-999
廠商： Atmel
文件頁數： 17/50頁
文件大?。?/td> 0K
描述： IC MCU ARM7 512KB FLASH 64LQFP
標準包裝： 3,000
系列： SAM7S
核心處理器： ARM7
芯體尺寸： 16/32-位
速度： 55MHz
連通性： I²C，SPI，SSC，UART/USART，USB
外圍設備： 欠壓檢測/復位，DMA，POR，PWM，WDT
輸入/輸出數： 32
程序存儲器容量： 512KB（512K x 8）
程序存儲器類型： 閃存
RAM 容量： 64K x 8
電壓 - 電源 (Vcc/Vdd)： 1.65 V ~ 1.95 V
數據轉換器： A/D 8x10b
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 64-LQFP
包裝： 帶卷 (TR)
配用： AT91SAM-ICE-ND - EMULATOR FOR AT91 ARM7/ARM9
AT91SAM7S-EK-ND - KIT EVAL FOR ARM AT91SAM7S
24
SAM7S Series [DATASHEET]
6175KS–ATARM–25-Oct-12
The 8 NVM bits are software programmable through the EFC User Interface. The command “Set Lock Bit” enables the
protection. The command “Clear Lock Bit” unlocks the lock region.
Asserting the ERASE pin clears the lock bits, thus unlocking the entire Flash.
8.8.3.6 SAM7S161/16
The Embedded Flash Controller manages 8 lock bits to protect 8 regions of the flash against inadvertent flash erasing or
programming commands. The SAM7S161/16 contains 8 lock regions and each lock region contains 32 pages of 64
bytes. Each lock region has a size of 2 Kbytes.
If a locked-region’s erase or program command occurs, the command is aborted and the LOCKE bit in the MC_FSR
register rises and the interrupt line rises if the LOCKE bit has been written at 1 in the MC_FMR register.
The 8 NVM bits are software programmable through the EFC User Interface. The command “Set Lock Bit” enables the
protection. The command “Clear Lock Bit” unlocks the lock region.
Asserting the ERASE pin clears the lock bits, thus unlocking the entire Flash.
Table 8-1 summarizes the configuration of the eight devices.
8.8.4
Security Bit Feature
The SAM7S Series features a security bit, based on a specific NVM Bit. When the security is enabled, any access to the
Flash, either through the ICE interface or through the Fast Flash Programming Interface, is forbidden. This ensures the
confidentiality of the code programmed in the Flash.
This security bit can only be enabled, through the Command “Set Security Bit” of the EFC User Interface. Disabling the
security bit can only be achieved by asserting the ERASE pin at 1, and after a full flash erase is performed. When the
security bit is deactivated, all accesses to the flash are permitted.
It is important to note that the assertion of the ERASE pin should always be longer than 50 ms.
As the ERASE pin integrates a permanent pull-down, it can be left unconnected during normal operation. However, it is
safer to connect it directly to GND for the final application.
8.8.5
Non-volatile Brownout Detector Control
Two general purpose NVM (GPNVM) bits are used for controlling the brownout detector (BOD), so that even after a
power loss, the brownout detector operations remain in their state.
These two GPNVM bits can be cleared or set respectively through the commands “Clear General-purpose NVM Bit” and
“Set General-purpose NVM Bit” of the EFC User Interface.
GPNVM Bit 0 is used as a brownout detector enable bit. Setting the GPNVM Bit 0 enables the BOD, clearing it
disables the BOD. Asserting ERASE clears the GPNVM Bit 0 and thus disables the brownout detector by default.
The GPNVM Bit 1 is used as a brownout reset enable signal for the reset controller. Setting the GPNVM Bit 1
enables the brownout reset when a brownout is detected, Clearing the GPNVM Bit 1 disables the brownout reset.
Asserting ERASE disables the brownout reset by default.
Table 8-1.
Flash Configuration Summary
Device
Number of Lock Bits
Number of Pages in the Lock Region
Page Size
SAM7S512
32
64
256 bytes
SAM7S256
16
64
256 bytes
SAM7S128
8
64
256 bytes
SAM7S64
16
32
128 bytes
SAM7S321/32
8
32
128 bytes
SAM7S161/16
8
32
64 bytes
相關PDF資料
PDF描述
DSPIC30F4012-30I/SP IC DSPIC MCU/DSP 48K 28DIP
AT91SAM7XC128-CU-999 IC MCU ARM7 128KB FLASH 100TFBGA
AT91SAM7X128-CU-999 IC MCU ARM7 128KB FLASH 100TFBGA
PIC24HJ128GP506-I/PT IC PIC MCU FLASH 128KB 64TQFP
AT91SAM7SE32-CU-999 IC MCU ARM7 32KB FLASH 144LFBGA
相關代理商/技術參數
參數描述
AT91SAM7S512B-AU 功能描述:ARM微控制器 - MCU GREEN IND TEMP MRL B RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
AT91SAM7S512B-AU-999 功能描述:ARM微控制器 - MCU GREEN IND TEMP MRL B RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
AT91SAM7S512B-MU 功能描述:ARM微控制器 - MCU GREEN IND TEMP MRLB RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
AT91SAM7S512B-MU-999 功能描述:ARM微控制器 - MCU GREEN IND TEMP MRLB RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
AT91SAM7S512-MU 功能描述:ARM微控制器 - MCU 512kB Flash 64kB SRAM 55MHz 4 PWM RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*