參數資料
型號: ATMEGA168-20PI
廠商: Atmel
文件頁數: 19/36頁
文件大?。?/td> 0K
描述: IC AVR MCU 16K 20MHZ 28DIP
產品培訓模塊: megaAVR Introduction
標準包裝: 14
系列: AVR® ATmega
核心處理器: AVR
芯體尺寸: 8-位
速度: 20MHz
連通性: I²C,SPI,UART/USART
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 23
程序存儲器容量: 16KB(8K x 16)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 512 x 8
RAM 容量: 1K x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
數據轉換器: A/D 6x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 28-DIP(0.300",7.62mm)
包裝: 管件
26
2545TS–AVR–05/11
ATmega48/88/168
11.2
Errata Atmel ATmega88
The revision letter in this section refers to the revision of the ATmega88 device.
11.2.1
Rev. D
Interrupts may be lost when writing the timer registers in the asynchronous timer
1.
Interrupts may be lost when writing the timer registers in the asynchronous timer
The interrupt will be lost if a timer register that is synchronous timer clock is written when the
asynchronous Timer/Counter register (TCNTx) is 0x00.
Problem fix/workaround
Always check that the asynchronous Timer/Counter register neither have the value 0xFF nor
0x00 before writing to the asynchronous Timer Control Register (TCCRx), asynchronous
Timer Counter Register (TCNTx), or asynchronous Output Compare Register (OCRx).
11.2.2
Rev. B/C
Not sampled.
11.2.3
Rev. A
Writing to EEPROM does not work at low operating voltages
Part may hang in reset
Interrupts may be lost when writing the timer registers in the asynchronous timer
1.
Writing to EEPROM does not work at low operating voltages
Writing to the EEPROM does not work at low voltages.
Problem fix/workaround
Do not write the EEPROM at voltages below 4.5 Volts.
This will be corrected in rev. B.
2.
Part may hang in reset
Some parts may get stuck in a reset state when a reset signal is applied when the internal
reset state-machine is in a specific state. The internal reset state-machine is in this state for
approximately 10ns immediately before the part wakes up after a reset, and in a 10ns win-
dow when altering the system clock prescaler. The problem is most often seen during In-
System Programming of the device. There are theoretical possibilities of this happening also
in run-mode. The following three cases can trigger the device to get stuck in a reset-state:
- Two succeeding resets are applied where the second reset occurs in the 10ns window
before the device is out of the reset-state caused by the first reset.
- A reset is applied in a 10ns window while the system clock prescaler value is updated by
software.
- Leaving SPI-programming mode generates an internal reset signal that can trigger this
case.
The two first cases can occur during normal operating mode, while the last case occurs only
during programming of the device.
相關PDF資料
PDF描述
ATMEGA165V-8MI IC AVR MCU 16K 8MHZ 64-QFN
ATMEGA165-16MI IC AVR MCU 16K 16MHZ 64-QFN
ATMEGA168V-10AI IC AVR MCU 16K 10MHZ 32TQFP
ATMEGA168-20AI IC AVR MCU 16K 20MHZ 32TQFP
PIC16C71-20/SO IC MCU OTP 1KX14 A/D 18SOIC
相關代理商/技術參數
參數描述
ATMEGA168-20PJ 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Microcontroller with 8K Bytes In-System Programmable Flash
ATmega168-20PU 功能描述:8位微控制器 -MCU 16kB Flash 0.5kB EEPROM 23 I/O Pins RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATMEGA168A 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Atmel Microcontroller with 4/8/16/32K Bytes In-System Programmable Flash
ATMEGA168A-AU 功能描述:8位微控制器 -MCU AVR 16KB FL 512B EE 1KB SRAM-20MHz RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATMEGA168A-AUR 功能描述:8位微控制器 -MCU AVR 16KB FL 512B EE 1KB SRAM-20MHz RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT