參數資料
型號: ATMEGA3250-16AUR
廠商: Atmel
文件頁數: 45/85頁
文件大?。?/td> 0K
描述: MCU AVR 32K FLASH 16MHZ 100TQFP
產品培訓模塊: megaAVR Introduction
標準包裝: 1,500
系列: AVR® ATmega
核心處理器: AVR
芯體尺寸: 8-位
速度: 16MHz
連通性: SPI,UART/USART,USI
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 69
程序存儲器容量: 32KB(16K x 16)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 1K x 8
RAM 容量: 2K x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
數據轉換器: A/D 8x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 100-TQFP
包裝: 帶卷 (TR)
其它名稱: ATMEGA3250-16AUR-ND
2010-2011 Microchip Technology Inc.
Preliminary
DS41419C-page 267
PIC16(L)F1824/1828
25.5.3.3
7-bit Transmission with Address
Hold Enabled
Setting the AHEN bit of the SSP1CON3 register
enables additional clock stretching and interrupt gen-
eration after the 8th falling edge of a received match-
ing address. Once a matching address has been
clocked in, CKP is cleared and the SSP1IF interrupt is
set.
Figure 25-18 displays a standard waveform of a 7-bit
Address Slave Transmission with AHEN enabled.
1.
Bus starts Idle.
2.
Master sends Start condition; the S bit of
SSP1STAT is set; SSP1IF is set if interrupt on
Start detect is enabled.
3.
Master sends matching address with R/W bit
set. After the 8th falling edge of the SCL line the
CKP bit is cleared and SSP1IF interrupt is gen-
erated.
4.
Slave software clears SSP1IF.
5.
Slave software reads ACKTIM bit of SSP1CON3
register, and R/W and D/A of the SSP1STAT
register to determine the source of the interrupt.
6.
Slave reads the address value from the
SSP1BUF register clearing the BF bit.
7.
Slave software decides from this information if it
wishes to ACK or not ACK and sets ACKDT bit
of the SSP1CON2 register accordingly.
8.
Slave sets the CKP bit releasing SCL.
9.
Master clocks in the ACK value from the slave.
10. Slave hardware automatically clears the CKP bit
and sets SSP1IF after the ACK if the R/W bit is
set.
11. Slave software clears SSP1IF.
12. Slave loads value to transmit to the master into
SSP1BUF setting the BF bit.
13. Slave sets CKP bit releasing the clock.
14. Master clocks out the data from the slave and
sends an ACK value on the 9th SCL pulse.
15. Slave hardware copies the ACK value into the
ACKSTAT bit of the SSP1CON2 register.
16. Steps 10-15 are repeated for each byte transmit-
ted to the master from the slave.
17. If the master sends a not ACK the slave
releases the bus allowing the master to send a
Stop and end the communication.
Note: SSP1BUF cannot be loaded until after the
ACK.
Note: Master must send a not ACK on the last byte
to ensure that the slave releases the SCL
line to receive a Stop.
相關PDF資料
PDF描述
SC16C654BIB64,157 IC QUAD UART 64BYTE 64LQFP
SC16C554DBIA68,512 IC UART QUAD SOT188-2
MS3110E14-19S CONN RCPT 19POS WALL MNT W/SCKT
SCC68692E1A44,529 IC DUART 44PLCC
V24B5H150B CONVERTER MOD DC/DC 5V 150W
相關代理商/技術參數
參數描述
ATMEGA3250A 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Microcontroller with 16/32/64K Bytes In-System Programmable Flash
ATMEGA3250A-AN 功能描述:8位微控制器 -MCU AVR 32K FL 2K SRAM 1KB EE 20 MHZ GRN RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATmega3250A-ANR 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Atmel Microcontroller with 16/32/64KB In-System Programmable Flash
ATMEGA3250A-AU 功能描述:8位微控制器 -MCU AVR 32K FLSH 2K SRAM 1KB EE-20MHz IND RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATMEGA3250A-AUR 功能描述:8位微控制器 -MCU AVR 32K FL 2K SRAM 1KB EE 20MHz IND RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT