- 您現在的位置：買賣IC網 > PDF目錄3803 > ATMEGA48-20AU (Atmel)IC AVR MCU 4K 20MHZ 5V 32TQFP PDF資料下載
參數資料
| 型號： | ATMEGA48-20AU |
| 廠商： | Atmel |
| 文件頁數： | 17/36頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AVR MCU 4K 20MHZ 5V 32TQFP |
| 產品培訓模塊： | MCU Product Line Introduction megaAVR Introduction |
| 標準包裝： | 250 |
| 系列： | AVR® ATmega |
| 核心處理器： | AVR |
| 芯體尺寸： | 8-位 |
| 速度： | 20MHz |
| 連通性： | I²C，SPI，UART/USART |
| 外圍設備： | 欠壓檢測/復位，POR，PWM，WDT |
| 輸入/輸出數： | 23 |
| 程序存儲器容量： | 4KB（2K x 16） |
| 程序存儲器類型： | 閃存 |
| EEPROM 大?。?/td> | 256 x 8 |
| RAM 容量： | 512 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2.7 V ~ 5.5 V |
| 數據轉換器： | A/D 8x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 32-TQFP |
| 包裝： | 托盤 |
| 產品目錄頁面： | 613 (CN2011-ZH PDF) |
| 配用： | ATSTK600-RC29-ND - STK600 ROUTING CARD AVR ATSTK600-TQFP32-ND - STK600 SOCKET/ADAPTER 32-TQFP ATSTK600-DIP40-ND - STK600 SOCKET/ADAPTER 40-PDIP ATAVRDRAGON-ND - KIT DRAGON FLASH MEM AVR ATAVRISP2-ND - PROGRAMMER AVR IN SYSTEM ATJTAGICE2-ND - AVR ON-CHIP D-BUG SYSTEM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
24
2545TS–AVR–05/11
ATmega48/88/168
11.1.4
Rev A
Part may hang in reset
Wrong values read after erase only operation
Watchdog timer interrupt disabled
Start-up time with crystal oscillator is higher than expected
High power consumption in power-down with external clock
Asynchronous oscillator does not stop in power-down
Interrupts may be lost when writing the timer registers in the asynchronous timer
1.
Part may hang in reset
Some parts may get stuck in a reset state when a reset signal is applied when the internal
reset state-machine is in a specific state. The internal reset state-machine is in this state for
approximately 10ns immediately before the part wakes up after a reset, and in a 10ns win-
dow when altering the system clock prescaler. The problem is most often seen during In-
System Programming of the device. There are theoretical possibilities of this happening also
in run-mode. The following three cases can trigger the device to get stuck in a reset-state:
- Two succeeding resets are applied where the second reset occurs in the 10ns window
before the device is out of the reset-state caused by the first reset.
- A reset is applied in a 10ns window while the system clock prescaler value is updated by
software.
- Leaving SPI-programming mode generates an internal reset signal that can trigger this
case.
The two first cases can occur during normal operating mode, while the last case occurs only
during programming of the device.
Problem fix/workaround
The first case can be avoided during run-mode by ensuring that only one reset source is
active. If an external reset push button is used, the reset start-up time should be selected
such that the reset line is fully debounced during the start-up time.
The second case can be avoided by not using the system clock prescaler.
The third case occurs during In-System programming only. It is most frequently seen when
using the internal RC at maximum frequency.
If the device gets stuck in the reset-state, turn power off, then on again to get the device out
of this state.
2.
Wrong values read after erase only operation
At supply voltages below 2.7V, an EEPROM location that is erased by the Erase Only oper-
ation may read as programmed (0x00).
Problem fix/workaround
If it is necessary to read an EEPROM location after Erase Only, use an Atomic Write opera-
tion with 0xFF as data in order to erase a location. In any case, the Write Only operation can
be used as intended. Thus no special considerations are needed as long as the erased loca-
tion is not read before it is programmed.
相關PDF資料 |
PDF描述 |
|---|---|
| ATTINY2313-20MU | IC MCU AVR 2K FLASH 20-QFN |
| AT89LP4052-20XU | IC 8051 MCU FLASH 4K 20TSSOP |
| AT89LP4052-20PU | IC 8051 MCU FLASH 4K 20DIP |
| ATMEGA168V-10MQR | MCU AVR 16KB FLASH 10MHZ 32QFN |
| ATTINY2313-20SU | IC MCU AVR 2K FLASH 20SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ATMEGA48-20AU/B | 制造商:Atmel Corporation 功能描述: |
| ATMEGA48-20AUR | 功能描述:8位微控制器 -MCU AVR 4KB FL 256B EE 512B EE 20MHZ IND RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| ATMEGA4820MI | 制造商:Atmel Corporation 功能描述:MCU 8-Bit ATmega AVR RISC 4KB Flash 3.3V/5V 32-Pin MLF EP |
| ATmega48-20MI | 功能描述:8位微控制器 -MCU AVR 4K FLSH 256B EE 512B SRAM ADC 5V RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| ATMEGA48-20MJ | 功能描述:IC AVR MCU 4K 5V 20MHZ 32-QFN RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:AVR® ATmega 標準包裝:9 系列:87C 核心處理器:8051 芯體尺寸:8-位 速度:40/20MHz 連通性:UART/USART 外圍設備:POR，WDT 輸入/輸出數:32 程序存儲器容量:32KB（32K x 8） 程序存儲器類型:OTP EEPROM 大小:- RAM 容量:256 x 8 電壓 - 電源 (Vcc/Vdd):4.5 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:0°C ~ 70°C 封裝/外殼:40-DIP（0.600"，15.24mm） 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。