參數資料
型號： ATR0621N-7FQY
廠商： ATMEL CORP
元件分類： 無繩電話/電話
英文描述： TELECOM, CELLULAR, BASEBAND CIRCUIT, PBGA100
封裝： 9 X 9 MM, 0.80 MM PITCH, ROHS COMPLIANT, LFBGA-100
文件頁數： 6/31頁
文件大?。?/td> 477K
代理商： ATR0621N-7FQY
14
4890C–GPS–10/06
ATR0621
The following settings apply if GPSMODE configuration is not enabled, that is, GPSMODE = 0
(ROM-Defaults):
3.3.4
USB Power Mode
For correct response to the USB host queries, the device has to know its power mode. This is
configured via GPSMODE7. If set to bus powered, an upper current limit of 100 mA is reported
to the USB host; that is, the device classifies itself as a “l(fā)ow-power bus-powered function” with
no more than one USB power unit load.
3.3.5
Active Antenna Supervisor
The two pins P0/NANTSHORT and P15/ANTON plus one pin of P25/NAADET0/MISO or
P14/NAADET1 are always initialized as general purpose I/Os and used as follows:
P15/ANTON is an output which can be used to switch on and off antenna power supply.
Input P0/NANTSHORT will indicate an antenna short circuit, i.e. zero DC voltage at the
antenna, to the firmware. If the antenna is switched off by output P15/ANTON, it is assumed
that also input P0/NANTSHORT will signal zero DC voltage, i.e. switch to its active low state.
Input P25/NAADET0/MISO or P14/NAADET1 will indicate a DC current into the antenna. In
case of short circuit, both P0 and P25/P14 will be active, i.e. at low level. If the antenna is
switched off by output P15/ANTON, it is assumed that also input P25/NAADET0/MISO will
signal zero DC current, i.e. switch to its active low state. Which pin is used as NAADET (P14
or P25) depends on the settings of GPSMODE11 and GPSMODE10 (see Table 3-14 on
Table 3-11.
Serial I/O Default Setting if GPSMODE Configuration is Deselected
(GPSMODE0 = 0)
USB
NMEA
USART1
NMEA
USART2
UBX
Baud rate (kBaud)
57.6
Input protocol
UBX, NMEA
UBX, NMEA, RTCM
Output protocol
NMEA
UBX
Messages
GGA, RMC, GSA, GSV
NAV: SOL, SVINFO
MON: EXCEPT
Information
messages (UBX INF
or NMEA TXT)
User Notice, Warning,
Error
User, Notice, Warning,
Error
User, Notice, Warning,
Error
Table 3-12.
USB Power Modes
GPSMODE7 (Reset = PU) Description
0
USB device is bus-powered (maximum current limit 100 mA)
1(1)
USB device is self-powered (default ROM value)
Note:
1. Leave open
相關PDF資料
PDF描述
ATR0621P1-7FQY TELECOM, CELLULAR, BASEBAND CIRCUIT, PBGA100
ATR2805SF/CH 1-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE
ATS650LSH-I2 SPECIALTY ANALOG CIRCUIT
ATT-0293-83-SMA-02 0 MHz - 4000 MHz RF/MICROWAVE FIXED ATTENUATOR
ATT-0640-10-29M-02 0 MHz - 40000 MHz RF/MICROWAVE FIXED ATTENUATOR
相關代理商/技術參數
參數描述
ATR0621P_08 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:GPS Baseband GPS Baseband
ATR0621P1 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:GPS Baseband Processor
ATR0621P1-7FHW 制造商:Atmel Corporation 功能描述:
ATR0621P1-7FQY 制造商:Atmel Corporation 功能描述:
ATR0621P-7FHW 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:GPS Baseband GPS Baseband
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*