- 您現在的位置：買賣IC網 > PDF目錄295113 > ATR2805SF/CH 1-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | ATR2805SF/CH |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 10/12頁 |
| 文件大?。?/td> | 116K |
| 代理商： | ATR2805SF/CH |
7
ATR2815S
TABLE III. Electrical Performance Characteristics - Continued.
Test
Symbol
Conditions
-55
°C ≤ T
C
≤ +125°C
VIN = 28 V dc ±5%, CL = 0 unless
otherwise specified
Group A
Subgroups
Device
types
Limits
Unit
Min
Max
Switching
frequency
4/
FS
IOUT = 2500 mA
4,5,6
01
500
600
KHz
Sync frequency range
Fsync
IOUT = 2500 mA
4,5,6
01
500
700
KHz
Output response to step
transient load changes 7/
VOTLOAD
1000 mA to/from 2000 mA
4,5,6
01
-1000
+1000
mV pk
167 mA to/from 1000 mA
4,5,6
-1000
+1000
4
100
Recovery time step
transient load changes 7/
8/
TTLOAD
1000 mA to/from 2000 mA
5,6
01
200
s
4
100
167 mA to 1000 mA
5,6
200
Output response to
transient step line changes
5/ 9/
VOTLINE
Input step 16 V to/from
40 V dc, IOUT = 2000 mA
4,5,6
01
±1500
mV pk
Recovery time transient
step line changes
5/ 8/ 9/
TTLINE
Input step 16 V to/from
40 V dc, IOUT = 2500 mA
4,5,6
01
10
ms
Turn on overshoot
VTonos
IOUT = 0 and 2000 mA
4,5,6
01
1000
mV pk
Turn on delay 10/
TonD
IOUT = 0 and 2000 mA
4,5,6
01
25
ms
Load fault recovery 5/ 10/
TrLF
4,5,6
01
25
ms
Notes:
1/
Parameter guaranteed by line and load regulation tests.
2/
Up to 90 percent of full power is available from either output provided the total output does not exceed 30 watts.
3/
Bandwidth guaranteed by design. Tested for 20 KHz to 2 MHz.
4/
Load current split equally between +VOUT and -VOUT.
5/
3 watt load on output under test. 3 watt to 27 watt load change on other output.
6/
Capacitive load may be any value from 0 to the maximum limit without compromising dc performance. A capacitive load in excess of the
maximum limit will not disturb loop stability but may interfere with the operation of the load fault detection circuitry, appearing as a short circuit
during turn on.
7/
Parameter shall be tested as part of design characterization and after design or process changes. Thereafter parameters shall be guaranteed to the
limits specified in Table III.
8/
An overload is that condition with a load in excess of the rated load but less than that necessary to trigger the short circuit protection and is the
condition of maximum power dissipation.
9/
Load step transition time between 2 and 10 microseconds.
10/
Recovery time is measured from the initiation of the transient to where VOUT has returned to within ±1 percent of VOUT at 50 percent load.
11/
Input step transition time between 2 and 10 microseconds.
12/
Turn on delay time measurement is for either a step application of power at the input or the removal of a ground signal from the inhibit pin (pin 2)
while power is applied to the input.
相關PDF資料 |
PDF描述 |
|---|---|
| ATS650LSH-I2 | SPECIALTY ANALOG CIRCUIT |
| ATT-0293-83-SMA-02 | 0 MHz - 4000 MHz RF/MICROWAVE FIXED ATTENUATOR |
| ATT-0640-10-29M-02 | 0 MHz - 40000 MHz RF/MICROWAVE FIXED ATTENUATOR |
| ATT-550F-00-35M-02 | 0 MHz - 26500 MHz RF/MICROWAVE FIXED ATTENUATOR |
| ATTL7583BAJ-DT | SPECIALTY TELECOM CIRCUIT, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ATR2805T | 制造商:IRF 制造商全稱:International Rectifier 功能描述:ADVANCED ANALOG HYBRID-HIGH RELIABILITY DC/DC CONVERTERS |
| ATR2805T/CH | 制造商:IRF 制造商全稱:International Rectifier 功能描述:ADVANCED ANALOG HYBRID-HIGH RELIABILITY DC/DC CONVERTERS |
| ATR2805T/ES | 制造商:IRF 制造商全稱:International Rectifier 功能描述:ADVANCED ANALOG HYBRID-HIGH RELIABILITY DC/DC CONVERTERS |
| ATR2805T/HB | 制造商:IRF 制造商全稱:International Rectifier 功能描述:ADVANCED ANALOG HYBRID-HIGH RELIABILITY DC/DC CONVERTERS |
| ATR2805TF | 制造商:IRF 制造商全稱:International Rectifier 功能描述:ADVANCED ANALOG HYBRID-HIGH RELIABILITY DC/DC CONVERTERS |
發布緊急采購，3分鐘左右您將得到回復。