參數資料
型號: ATSAM3N00AA-AU
廠商: Atmel
文件頁數: 14/60頁
文件大?。?/td> 0K
描述: IC MCU 16KB CORTEX-M3 48-LQFP
標準包裝: 1
系列: SAM3N
核心處理器: ARM? Cortex?-M3
芯體尺寸: 32-位
速度: 48MHz
連通性: I²C,IrDA,SPI,UART/USART
外圍設備: 欠壓檢測/復位,DMA,POR,PWM,WDT
輸入/輸出數: 34
程序存儲器容量: 16KB(16K x 8)
程序存儲器類型: 閃存
RAM 容量: 4K x 8
電壓 - 電源 (Vcc/Vdd): 1.62 V ~ 3.6 V
數據轉換器: A/D 8x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 48-LQFP
其它名稱: ATSAM3N00AA-AUDKR
21
11011BS–ATARM–22-Feb-12
SAM3N Summary
5.5.4
Low Power Mode Summary Table
The modes detailed above are the main low power modes. Each part can be set to on or off sep-
arately and wake up sources can be individually configured. Table 5-1 below shows a summary
of the configurations of the low power modes.
Notes:
1. When considering wake-up time, the time required to start the PLL is not taken into account. Once started, the device works
with the 4/8/12 MHz Fast RC oscillator. The user has to add the PLL start-up time if it is needed in the system. The wake-up
time is defined as the time taken for wake up until the first instruction is fetched.
2. The external loads on PIOs are not taken into account in the calculation.
3. Supply Monitor current consumption is not included.
4. Total Current consumption.
5. 5 A on VDDCORE, 15 A for total current consumption (using internal voltage regulator), 8 A for total current consumption
(without using internal voltage regulator).
6. Depends on MCK frequency.
7. In this mode the core is supplied and not clocked but some peripherals can be clocked.
Table 5-1.
Low Power Mode Configuration Summary
Mode
SUPC,
32 kHz
Oscillator
RTC RTT
Backup
Registers,
POR
(Backup
Region)
Regulator
Core
Memory
Peripherals
Mode Entry
Potential Wake Up
Sources
Core at
Wake Up
PIO State
while in Low
Power Mode
PIO State
at Wake Up
Consumption
Wake Up
Time
Backup
Mode
ON
OFF
(Not powered)
WFE
+SLEEPDEEP
bit = 1
WUP0-15 pins
BOD alarm
RTC alarm
RTT alarm
Reset
Previous
state saved
PIOA &
PIOB &
PIOC
Inputs with
pull ups
3 A typ(4)
< 0.1 ms
Wait
Mode
ON
Powered
(Not clocked)
WFE
+SLEEPDEEP
bit = 0
+LPM bit = 1
Any Event from: Fast
startup through
WUP0-15 pins
RTC alarm
RTT alarm
Clocked
back
Previous
state saved
Unchanged 5 A/15 A
< 10 s
Sleep
Mode
ON
Powered(7)
(Not clocked)
WFE or WFI
+SLEEPDEEP
bit = 0
+LPM bit = 0
Entry mode = WFI
Interrupt Only; Entry
mode = WFE Any
Enabled Interrupt
and/or Any Event
from: Fast start-up
through WUP0-15
pins
RTC alarm
RTT alarm
Clocked
back
Previous
state saved
Unchanged (6)
相關PDF資料
PDF描述
MC9S12XD256MAA IC MCU 256K FLASH 80-QFP
MC9S12XDT256VAA IC MCU 256K FLASH 80-QFP
MC9S12XA512CAL IC MCU 512K FLASH 112-LQFP
73S1217F-68IM/F/P IC SMART CARD READER PROG 68-QFN
MC56F8345VFGE IC DSP 16BIT 60MHZ 128-LQFP
相關代理商/技術參數
參數描述
ATSAM3N00AA-AUR 制造商:Atmel Corporation 功能描述:LQFP,GREEN,IND TEMP,MRL A,T&R - Tape and Reel 制造商:Atmel Corporation 功能描述:IC MCU 32BIT 16KB FLASH 48LQFP
ATSAM3N00AA-MU 功能描述:ARM微控制器 - MCU QFN,GREEN,IND TEMP,MRL A RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
ATSAM3N00AA-MUR 制造商:Atmel Corporation 功能描述:QFN,GREEN,IND TEMP,MRL A,T&R - Tape and Reel 制造商:Atmel Corporation 功能描述:IC MCU 32BIT 16KB FLASH 48QFN
ATSAM3N00BA-AU 功能描述:ARM微控制器 - MCU LQFP, Green, IND TEMP, MRL A RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
ATSAM3N00BA-AUR 制造商:Atmel Corporation 功能描述:LQFP,GREEN,IND TEMP,MRL A,T&R - Tape and Reel 制造商:Atmel Corporation 功能描述:IC MCU 32BIT 16KB FLASH 64LQFP