- 您現在的位置：買賣IC網 > PDF目錄295161 > BQ4285Q (TEXAS INSTRUMENTS INC) 1 TIMER(S), REAL TIME CLOCK, PQCC28 PDF資料下載
參數資料
| 型號： | BQ4285Q |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | XO, clock |
| 英文描述： | 1 TIMER(S), REAL TIME CLOCK, PQCC28 |
| 封裝： | PLASTIC, LCC-28 |
| 文件頁數： | 24/26頁 |
| 文件大?。?/td> | 1079K |
| 代理商： | BQ4285Q |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁
Periodic Interrupt
The mux output used to drive the SQW output also drives
the interrupt-generation circuitry. If the periodic interrupt
event is enabled by writinga1tothe periodic interrupt
enable bit (PIE) in register C, an interrupt request is gen-
erated once every 122
s to 500ms. The period between in-
terrupts is selected by the same bits in register A that se-
lect the square wave frequency (see Table 3).
Alarm Interrupt
During each update cycle, the RTC compares the hours,
minutes, and seconds bytes with the three corresponding
alarm bytes. If a match of all bytes is found, the alarm
interrupt event flag bit, AF in register C, is set to 1. If
the alarm event is enabled, an interrupt request is gen-
erated.
An alarm byte may be removed from the comparison by
setting it to a “don’t care” state. An alarm byte is set to a
“don’t care” state by writinga1toeachofits two most-
significant bits. A “don’t care” state may be used to select
the frequency of alarm interrupt events as follows:
s
If none of the three alarm bytes is “don’t care,” the
frequency is once per day, when hours, minutes, and
seconds match.
s
If only the hour alarm byte is “don’t care,” the frequency
is once per hour, when minutes and seconds match.
s
If only the hour and minute alarm bytes are “don’t care,”
the frequency is once per minute, when seconds match.
s
If the hour, minute, and second alarm bytes are
“don’t care,” the frequency is once per second.
Update Cycle Interrupt
The update cycle ended flag bit (UF) in register C is set
toa1atthe end of an update cycle. If the update inter-
rupt enable bit (UIE) of register B is 1, and the update
transfer inhibit bit (UTI) in register B is 0, then an in-
terrupt request is generated at the end of each update
cycle.
Accessing RTC bytes
Time and calendar bytes read during an update cycle
may be in error. Three methods to access the time and
calendar bytes without ambiguity are:
s
Enable the update interrupt event to generate
interrupt requests at the end of the update cycle.
The interrupt handler has a maximum of 999ms to
access the clock bytes before the next update cycle
begins (see Figure 3).
s
Poll the update-in-progress bit (UIP) in register A. If
UIP = 0, the polling routine has a minimum of tBUC
time to access the clock bytes (see Figure 3).
s
Use the periodic interrupt event to generate
interrupt requests every tPI time, such that UIP = 1
always occurs between the periodic interrupts. The
interrupt handler will have a minimum of tPI/2 +
tBUC time to access the clock bytes (see Figure 3).
Oscillator Control
When power is first applied to the bq4285 and VCC is
above VPFD, the internal oscillator and frequency divider
are turned on by writing a 010 pattern to bits 4 through
6 of register A. A pattern of 11X turns the oscillator on
but keeps the frequency divider disabled.
Any other
pattern to these bits keeps the oscillator off.
7
Figure 3. Update-Ended/Periodic Interrupt Relationship
Jan. 1999 D
bq4285
相關PDF資料 |
PDF描述 |
|---|---|
| BRN1-09P-TA1 | 9 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, SOLDER, PLUG |
| BRN1-09P-TA2 | 9 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, SOLDER, PLUG |
| BRN1-09P-TA3 | 9 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, SOLDER, PLUG |
| BRN1-09P-TA4 | 9 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, SOLDER, PLUG |
| BRN1-09P-TB1 | 9 CONTACT(S), MALE, D NANOMINIATURE CONNECTOR, SOLDER, PLUG |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BQ4285Q- | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Real-Time Clock RTC With NVRAM Control |
| BQ4285S- | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Real-Time Clock RTC With NVRAM Control |
| BQ4285S-SB2 | 功能描述:實時時鐘 RTC IC: 114x8 NVSRAM & NVSRAM Control RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| BQ4285S-SB2G4 | 功能描述:實時時鐘 RTC IC: 114x8 NVSRAM & NVSRAM Control RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| BQ4285S-SB2TR | 功能描述:實時時鐘 RTC IC: 114x8 NVSRAM & NVSRAM Control RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。