參數資料
    型號: BU-65145-460Q
    英文描述: Controller Miscellaneous - Datasheet Reference
    中文描述: 控制器雜項-數據表參考
    文件頁數: 19/24頁
    文件大?。?/td> 219K
    代理商: BU-65145-460Q
    4
    ERROR FLAGS
    Four error flags are ouput to the subsystem to provide informa-
    tion on the condition of the BUS-65142.
    The
    (Message Error) line goes LOW if any of the fol-
    lowing error conditions exist:
    format error
    word count error
    invalid word
    sync error
    RT to RT address error
    T/R bit error.
    The
    (Remote Terminal Failure) line goes LOW
    whenever the results of a continuous wraparound self-test
    shows a discrepancy, or a transmitter watchdog timeout
    has occurred.
    The
    (Handshake Failure) line goes LOW whenev-
    er the system dows not issue a
    in response to a
    before timing-out.
    The
    (RT Address Error) line goes LOW
    whenever the sum of the 5 address lines and parity lines
    show a parity error (the terminal will not respond to com-
    mands while this error condition exists).
    ERR
    RTADR
    DTREQ
    DTGRT
    HSFAIL
    RTFAIL
    ME
    STATUS REGISTER
    Six inputs to the BUS-65142 allow the subsystem host CPU to
    control bits in the RTU status word. The Illegal Command input
    may be used to set the Message Error bit in the Status Word and
    suppress the transmission of data to the bus controller. This line
    allows illegalization of any combination of commands. The
    latched Command Word may be connected to the address pins
    of an optional external PROM, which would drive the Illegal
    Command line LOW when it identifies a command programmed
    as illegal.
    STATUS REGISTER BIT ASSIGNMENTS
    The
    (Subsystem Request) line is used to set the
    Status Word service request bit.
    The
    (Accept Dynamic Bus Control) line is used to
    set the Status Word bus control bit.
    The
    (RT Flag Line) is used to set the Status Word
    terminal flag bit.
    The
    (Busy) line is used to set the Status Word busy
    bit, and inhibit subsystem requests for data.
    The
    (SubSystem Flag) line is used to set the
    Status Word subsytem (fault) flag.
    SSFLAG
    BUSY
    RTFLAG
    ADBC
    SRQ
    相關PDF資料
    PDF描述
    BU-65145-460S Controller Miscellaneous - Datasheet Reference
    BU-65145-460W Controller Miscellaneous - Datasheet Reference
    BU-65145-460Y Controller Miscellaneous - Datasheet Reference
    BU-65145-460Z Controller Miscellaneous - Datasheet Reference
    BU-65145-470 Controller Miscellaneous - Datasheet Reference
    相關代理商/技術參數
    參數描述
    BU65170G0-100 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Interface IC
    BU65170G0-110 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Interface IC
    BU65170G0-120 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Interface IC
    BU65170G0-200 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Interface IC
    BU65170G0-300 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Interface IC