參數資料
型號: C8051F018R
廠商: Silicon Laboratories Inc
文件頁數: 59/154頁
文件大小: 0K
描述: IC 8051 MCU 16K FLASH 64TQFP
標準包裝: 1
系列: C8051F018
核心處理器: 8051
芯體尺寸: 8-位
速度: 25MHz
連通性: SMBus(2 線/I²C),SPI,UART/USART
外圍設備: 欠壓檢測/復位,POR,PWM,溫度傳感器,WDT
輸入/輸出數: 32
程序存儲器容量: 16KB(16K x 8)
程序存儲器類型: 閃存
RAM 容量: 1.25K x 8
電壓 - 電源 (Vcc/Vdd): 2.8 V ~ 3.6 V
數據轉換器: A/D 8x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 64-TQFP
包裝: 剪切帶 (CT)
其它名稱: 336-1048-1
C8051F018
C8051F019
Figure 19.3. FLASHCON: JTAG Flash Control Register
Reset Value
WRMD3
WRMD2
WRMD1
WRMD0
RDMD3
RDMD2
RDMD1
RDMD0
00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
This register determines how the Flash interface logic will respond to reads and writes to the
FLASHDAT Register.
Bits7-4: WRMD3-0: Write Mode Select Bits.
The Write Mode Select Bits control how the interface logic responds to writes to the
FLASHDAT Register per the following values:
0000: A FLASHDAT write replaces the data in the FLASHDAT register, but is otherwise
ignored.
0001: A FLASHDAT write initiates a write of FLASHDAT into the memory location
addressed by the FLASHADR register. FLASHADR is incremented by one when
complete.
0010: A FLASHDAT write initiates an erasure (sets all bytes to 0xFF) of the Flash page
containing the address in FLASHADR. FLASHDAT must be 0xA5 for the erase to
occur. FLASHADR is not affected. If FLASHADR = 0x7DFE – 0x7DFF, the entire
user space will be erased (i.e. entire Flash memory except for Reserved area 0x7E00 –
0x7FFF).
(All other values for WRMD3-0 are reserved.)
Bits3-0: RDMD3-0: Read Mode Select Bits.
The Read Mode Select Bits control how the interface logic responds to reads to the
FLASHDAT Register per the following values:
0000: A FLASHDAT read provides the data in the FASHDAT register, but is otherwise
ignored.
0001: A FLASHDAT read initiates a read of the byte addressed by the FLASHADR register
if no operation is currently active. This mode is used for block reads.
0010: A FLASHDAT read initiates a read of the byte addressed by FLASHADR only if no
operation is active and any data from a previous read has already been read from
FLASHDAT. This mode allows single bytes to be read (or the last byte of a block)
without initiating an extra read.
(All other values for RDMD3-0 are reserved.)
Figure 19.4. FLASHADR: JTAG Flash Address Register
Reset Value
0x0000
Bit15
Bit0
This register holds the address for all JTAG Flash read, write, and erase operations. This register
autoincrements after each read or write, regardless of whether the operation succeeded or failed.
Bits15-0: Flash Operation 16-bit Address.
151
Rev. 1.2
相關PDF資料
PDF描述
C8051F206R IC 8051 MCU 8K FLASH 48TQFP
1996771-1 CONN PIN CONTACT GOLD
C8051F023R IC 8051 MCU 64K FLASH 64TQFP
533082-1 CONN PIN GUIDE .375 UNPLATED
2-592404-1 CONN PIN SIZE 20 GOLD CRIMP
相關代理商/技術參數
參數描述
C8051F019 功能描述:8位微控制器 -MCU 16KB 10ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F019-GQ 功能描述:8位微控制器 -MCU 16KB 10ADC 48P MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F019-GQR 功能描述:8位微控制器 -MCU 16KB 10ADC 48Pin MCU Tape and Reel RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F019R 功能描述:8位微控制器 -MCU C+-10Bit/48Pin RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F020 功能描述:8位微控制器 -MCU 16KB 12ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT