- 您現在的位置：買賣IC網 > PDF目錄379727 > CA3140E (INTERSIL CORP) 4.5MHz, BiMOS Operational Amplifier with MOSFET Input/Bipolar Output PDF資料下載
參數資料
| 型號： | CA3140E |
| 廠商： | INTERSIL CORP |
| 元件分類： | 運動控制電子 |
| 英文描述： | 4.5MHz, BiMOS Operational Amplifier with MOSFET Input/Bipolar Output |
| 中文描述： | OP-AMP, 15000 uV OFFSET-MAX, 4.5 MHz BAND WIDTH, PDIP8 |
| 封裝： | PLASTIC, MS-001-BA, DIP-8 |
| 文件頁數： | 6/19頁 |
| 文件大?。?/td> | 1042K |
| 代理商： | CA3140E |
6
Output Circuit Considerations
Excellent interfacing with TTL circuitry is easily achieved
with a single 6.2V zener diode connected to Terminal 8 as
shown in Figure 1. This connection assures that the
maximum output signal swing will not go more positive than
the zener voltage minus two base-to-emitter voltage drops
within the CA3140. These voltages are independent of the
operating supply voltage.
Figure 2 shows output current sinking capabilities of the
CA3140 at various supply voltages. Output voltage swing to
the negative supply rail permits this device to operate both
power transistors and thyristors directly without the need for
level shifting circuitry usually associated with the 741 series
of operational amplifiers.
Figure 4 shows some typical configurations. Note that a
series resistor, R
L
, is used in both cases to limit the drive
available to the driven device. Moreover, it is recommended
that a series diode and shunt diode be used at the thyristor
input to prevent large negative transient surges that can
appear at the gate of thyristors, from damaging the
integrated circuit.
Offset Voltage Nulling
The input offset voltage can be nulled by connecting a 10k
potentiometer between Terminals 1 and 5 and returning its
wiper arm to terminal 4, see Figure 3A. This technique,
however, gives more adjustment range than required and
therefore, a considerable portion of the potentiometer
rotation is not fully utilized. Typical values of series resistors
(R) that may be placed at either end of the potentiometer,
see Figure 3B, to optimize its utilization range are given in
the Electrical Specifications table.
An alternate system is shown in Figure 3C. This circuit uses
only one additional resistor of approximately the value
shown in the table. For potentiometers, in which the
resistance does not drop to 0
at either end of rotation, a
value of resistance 10% lower than the values shown in the
table should be used.
Low Voltage Operation
Operation at total supply voltages as low as 4V is possible
with the CA3140. A current regulator based upon the PMOS
threshold voltage maintains reasonable constant operating
current and hence consistent performance down to these
lower voltages.
The low voltage limitation occurs when the upper extreme of
the input common mode voltage range extends down to the
voltage at Terminal 4. This limit is reached at a total supply
voltage just below 4V. The output voltage range also begins to
extend down to the negative supply rail, but is slightly higher
than that of the input. Figure 8 shows these characteristics and
shows that with 2V dual supplies, the lower extreme of the input
common mode voltage range is below ground potential.
3
2
4
CA3140
8
6
7
V+
5V TO 36V
6.2V
≈
5V
LOGIC
SUPPLY
5V
TYPICAL
TTL GATE
FIGURE 1. ZENER CLAMPING DIODE CONNECTED TO
TERMINALS 8 AND 4 TO LIMIT CA3140 OUTPUT
SWING TO TTL LEVELS
1
0.01
0.1
LOAD (SINKING) CURRENT (mA)
1.0
10
10
100
1000
O
1
,
1
)
S
SUPPLY VOLTAGE (V-) = 0V
T
A
= 25
C
SUPPLY VOLTAGE (V+) = +5V
+15V
+30V
FIGURE 2. VOLTAGE ACROSS OUTPUT TRANSISTORS (Q
15
AND Q
16
) vs LOAD CURRENT
FIGURE 3A. BASIC
FIGURE 3B. IMPROVED RESOLUTION
FIGURE 3C. SIMPLER IMPROVED RESOLUTION
FIGURE 3. THREE OFFSET VOLTAGE NULLING METHODS
3
2
4
CA3140
7
6
V+
5
1
V-
10k
3
2
4
CA3140
7
6
V+
5
1
V-
10k
R
R
3
2
4
CA3140
7
6
V+
5
1
V-
10k
R
CA3140, CA3140A
相關PDF資料 |
PDF描述 |
|---|---|
| CA3140M | 4.5MHz, BiMOS Operational Amplifier with MOSFET Input/Bipolar Output |
| CA3140M96 | 4.5MHz, BiMOS Operational Amplifier with MOSFET Input/Bipolar Output |
| CA3140T | 4.5MHz, BiMOS Operational Amplifier with MOSFET Input/Bipolar Output |
| CA3140 | 4.5MHz, BiMOS Operational Amplifier with MOSFET Input/Bipolar Output(4.5MHz BiCMOS運算放大器（MOSFET輸入，Bipolar輸出）) |
| CA3141E | High-Voltage Diode Array For Commercial, Industrial and Military Applications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CA3140E | 制造商:Intersil Corporation 功能描述:IC OP-AMP SINGLE 8PDIP |
| CA3140E/TEST/ABB | 制造商:Intersil Corporation 功能描述:- Rail/Tube |
| CA3140ES2357 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| CA3140EX | 制造商:Rochester Electronics LLC 功能描述:BIMOS OP AMP MOSFET IN/BIP OUT BURN-IN 8 PDIP COM - Bulk |
| CA3140EZ | 功能描述:運算放大器 - 運放 W/ANNEAL OPAMP 4.5MH ZLWBIAS0.04NA8PDIPML RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。