- 您現在的位置：買賣IC網 > PDF目錄373035 > CARD_74LVC1GX04 (NXP Semiconductors N.V.) One chip crystal oscillator driver PDF資料下載
參數資料
| 型號： | CARD_74LVC1GX04 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | One chip crystal oscillator driver |
| 中文描述： | 一個芯片晶體振蕩器驅動程序 |
| 文件頁數： | 2/2頁 |
| 文件大?。?/td> | 97K |
| 代理商： | CARD_74LVC1GX04 |
In designing a crystal oscillator,the values of C
1
and C
2
as shown in the
reference design are dependent on the selected crystal. R
1
is critical to the
start up performance and drive level to the crystal. Because the system load
is isolated by the internal buffer in the 74LVC1GX04,these calculations can
be done once for many different system loads. For the reference design as
shown,the crystal load capacitance (C
L
) should be equal to the capacitance
C
1
and C
2
in parallel in addition to any stray capacitance (C
s
)
C
1
and C
2
should be equal and the designer can use the following formula
to calculate the value:
C
L
= (C
1
*C
2
) / (C
1
+C
2
) +C
s
Where:
C
L
is the load capacitance as specified by the crystal manufacturer,C
s
is the
stray capacitance of the circuit which is equal to the input capacitance of the
74LVC1GX04 of 5 pF. The feedback resistor (R
f
) provides negative feedback
and sets a bias point for the un-buffered inverter. This value is not critical
and is typically 1 Meg.
The starting value for R
1
should be equal to the reactance of C
2
at the
crystal frequency. (R
1
= X
C2
)
This will result in an input to the crystal of 50% of the rail to rail output
of X2. Usually this keeps the drive level into the crystal within the drive
specifications of the crystal but the designer should verify this. Overdriving
the crystal can cause damage.
After the calculations are performed for a particular crystal,the oscillator
circuit should be tested. The following simple checks will verify the
prototype design of a crystal controlled oscillator:
Test the oscillator over worse case conditions of min-max operating
voltage and temperature.You can also simulate worse case crystal
variations by adding series and parallel resistors.
Insure that the circuit does not oscillate when the crystal is removed.
Check the frequency stability over a supply range slightly greater than
which is likely to occur during normal operation.
Check that the start up time is within system requirements.
74LVC1GX04
One chip crystal oscillator driver
w w w. s e m i c o n d u c t o r s . p h i l i p s . c o m
Philips Semiconductors
Philips Semiconductors is a worldwide company with over 100 sales offices
in more than 50 countries.For a complete up-to-date list of our sales offices
please e-mail sales.addresses@www.semiconductors.philips.com.
A complete list will be sent to you automatically. You can also visit our
website http://www.semiconductors.philips.com/sales
Koninklijke Philips Electronics N.V. 2003
All rights reserved.Reproduction in whole or in part is prohibited without the prior written consent
of the copyright owner.The information presented in this document does not form part of any quo-
tation or contract,is believed to be accurate and reliable and may be changed without notice.No lia-
bility will be accepted by the publisher for any consequence of its use.Publication thereof does not
convey nor imply any license under patent- or other industrial or intellectual property rights.
Date of release: August 2003
document order number:9397 750 11958
Published in U.S.A.
www.semiconductors.philips.com/logic
Packages
Part Number
74LVC1GX04GW -40o to +125o C
74LVC1GX04GV
Temp. Range Pins Package Material
6
-40o to +125o C
6
Code
SOT363
SOT457
Marking
VX
VX4
SC-88
SC-74
plastic
plastic
Ordering information
Evaluation Board reference design schematic
C3
0.1
μ
F
C2
22P
CL
22P
R1
330
RL
500
CL
50P
V
CC
U1A
U1B
Rf
74LVC1G04GW
X1
Citizen
HCM49
74LVC1G04GW
1M
6
4
1
1
3
TP1
Test Point A
TP2
Test Point B
TesTP3
相關PDF資料 |
PDF描述 |
|---|---|
| CAT102 | Precision, Adjustable Shunt Regulator (600mV Reference) |
| CAT102EUK-TE7 | Precision, Adjustable Shunt Regulator (600mV Reference) |
| CAT24WC257PI-1.8TE13 | XTAL CER SMT 7X5 2PAD |
| CAT24WC257KI-1.8TE13 | 256K-Bit I2C Serial CMOS EEPROM |
| CAT24WC257KI3TE13 | 256K-Bit I2C Serial CMOS EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CARD-H2 | 功能描述:ISO TRANSPONDER CARD HITAG 2 RoHS:是 類別:RF/IF 和 RFID >> RFID 發射應答器，標簽 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:1 系列:iButton® RF 型:讀/寫 頻率:13.56MHz 特點:ISO14443-B 封裝/外殼:遙控鑰匙 供應商設備封裝:遙控鑰匙 包裝:散裝 |
| CARD-MIF1K | 制造商:RF Solutions LTD 功能描述:CARD SMART RFID MIFARE ISO |
| CARD-MIF4K | 功能描述:ISO TRANSPONDER CARD MIFARE 4K RoHS:是 類別:RF/IF 和 RFID >> RFID 發射應答器，標簽 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:1 系列:iButton® RF 型:讀/寫 頻率:13.56MHz 特點:ISO14443-B 封裝/外殼:遙控鑰匙 供應商設備封裝:遙控鑰匙 包裝:散裝 |
| CARD-MIFARE4K | 制造商:RF MONOLITHICS 功能描述:MIFARE TAG CREDITCARD 4K 制造商:RF Monolithics (RFM) 功能描述:MIFARE TAG CREDITCARD 4K |
| CARD-MIFARE-4K | 制造商:RF Solutions LTD 功能描述:SMART CARD RFID MIFARE 制造商:RF Solutions LTD 功能描述:SMART CARD, RFID, MIFARE 制造商:RF Solutions LTD 功能描述:SMART CARD, RFID, MIFARE, SVHC:No SVHC (20-Jun-2013) 制造商:RF Solutions LTD 功能描述:CARD, SMART, RFID, MIFARE, ISO, , ROHS COMPLIANT: YES |
發布緊急采購，3分鐘左右您將得到回復。