- 您現在的位置：買賣IC網 > PDF目錄366673 > CAT1162P-30TE13 CONNECTOR ACCESSORY PDF資料下載
參數資料
| 型號： | CAT1162P-30TE13 |
| 英文描述： | CONNECTOR ACCESSORY |
| 中文描述： | 連接器附件 |
| 文件頁數： | 9/12頁 |
| 文件大小： | 69K |
| 代理商： | CAT1162P-30TE13 |
9
CAT1161/2
Doc No. 3002, Rev. D
Acknowledge Polling
Disabling of the inputs can be used to take advantage of
the typical write cycle time. Once the stop condition is
issued to indicate the end of the host
’
s write opration, the
CAT1161/2 initiates the internal write cycle. ACK polling
can be initiated immediately. This involves issuing the
start condition followed by the slave address for a write
operation. If the CAT1161/2 is still busy with the write
operation, no ACK will be returned. If a write operation
has completed, an ACK will be returned and the host can
then proceed with the next read or write operation.
WRITE PROTECTION
The Write Protection feature allows the user to protect
against inadvertent memory array programming. If the
WP pin is tied to V
CC
, the entire memory array is
protected and becomes read only. The CAT1161/2 will
accept both slave and byte addresses, but the memory
location accessed is protected from programming by the
device
’
s failure to send an acknowledge after the first
byte of data is received.
Read Operations
The READ operation for the CAT1161/2 is initiated in the
same manner as the write operation with one exception,
that R/
W
bit is set to one. Three different READ operations
are possible: Immediate/Current Address READ,
Selective/Random READ and Sequential READ.
SCL
SDA
8TH BIT
STOP
NO ACK
DATA OUT
8
9
SLAVE
ADDRESS
S
A
C
K
DATA
N
O
A
C
K
S
T
O
P
P
BUS ACTIVITY:
MASTER
SDA LINE
S
T
A
R
T
Figure 9. Immediate Address Read Timing
相關PDF資料 |
PDF描述 |
|---|---|
| CAT1161PI-42TE13 | Supervisory Circuits with I2C Serial CMOS EEPROM, Precision Reset Controller and Watchdog Timer |
| CAT1162 | Miniature, 1W Isolated Regulated DC/DC Converters 10-PDIP |
| CAT1162PI-30TE13 | Miniature, 1W Isolated Regulated DC/DC Converters 12-SOP |
| CAT1162PI-42TE13 | Supervisory Circuits with I2C Serial CMOS EEPROM, Precision Reset Controller and Watchdog Timer |
| CAT1161P-30TE13 | Supervisory Circuits with I2C Serial CMOS EEPROM, Precision Reset Controller and Watchdog Timer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CAT1162P-45 | 功能描述:監控電路 16K I2C Mem w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| CAT1162PI-25 | 功能描述:監控電路 16K I2C Mem w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| CAT1162PI-28 | 功能描述:監控電路 16K I2C Mem w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| CAT1162PI-30 | 功能描述:監控電路 16K I2C Mem w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| CAT1162PI-42 | 功能描述:監控電路 16K I2C Mem w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。