- 您現在的位置：買賣IC網 > PDF目錄366719 > CAT25C32U20SE-1.8TE13 32K/64K-Bit SPI Serial CMOS EEPROM PDF資料下載
參數資料
| 型號： | CAT25C32U20SE-1.8TE13 |
| 英文描述： | 32K/64K-Bit SPI Serial CMOS EEPROM |
| 中文描述： | 32K/64K-Bit SPI串行EEPROM中的CMOS |
| 文件頁數： | 6/11頁 |
| 文件大小： | 82K |
| 代理商： | CAT25C32U20SE-1.8TE13 |
6
CAT25C32/64
Doc. No. 1001, Rev. G
Figure 2. WREN Instruction Timing
Figure 3. WRDI Instruction Timing
STATUS REGISTER
The Status Register indicates the status of the device.
The
RDY
(Ready) bit indicates whether the CAT25C32/
64 is busy with a write operation. When set to 1 a write
cycle is in progress and when set to 0 the device
indicates it is ready. This bit is read only.
The WEL (Write Enable) bit indicates the status of the
write enable latch . When set to 1, the device is in a
Write Enable state and when set to 0 the device is in a
Write Disable state. The WEL bit can only be set by the
WREN instruction and can be reset by the WRDI
instruction.
The BP0 and BP1 (Block Protect) bits indicate which
blocks are currently protected. These bits are set by the
user issuing the WRSR instruction. The user is allowed
to protect quarter of the memory, half of the memory or
the entire memory by setting these bits. Once protected
the user may only read from the protected portion of the
array. These bits are non-volatile.
Note: Dashed Line= mode (1, 1)
—
—
—
—
Note: Dashed Line= mode (1, 1)
—
—
—
—
SK
SI
CS
SO
0
0
0
0
0
1
1
0
HIGH IMPEDANCE
SK
SI
CS
SO
0
0
0
0
0
1
0
0
HIGH IMPEDANCE
The WPEN (Write Protect Enable) is an enable bit for the
WP
pin. The
WP
pin and WPEN bit in the status register
control the programmable hardware write protect feature.
Hardware write protection is enabled when
WP
is low and
WPEN bit is set to high. The user cannot write to the status
register (including the block protect bits and the WPEN
bit) and the block protected sections in the memory array
when the chip is hardware write protected. Only the
sections of the memory array that are not block protected
can be written. Hardware write protection is disabled
when either WP pin is high or the WPEN bit is zero.
DEVICE OPERATION
Write Enable and Disable
The CAT25C32/64 contains a write enable latch. This
latch must be set before any write operation. The device
powers up in a write disable state when V
cc
is applied.
WREN instruction will enable writes (set the latch) to
thedevice. WRDI instruction will disable writes (reset the
latch) to the device. Disabling writes will protect the
device against inadvertent writes.
相關PDF資料 |
PDF描述 |
|---|---|
| CAT25C32U20SETE13 | 32K/64K-Bit SPI Serial CMOS EEPROM |
| CAT25C32U20SI-1.8TE13 | 32K/64K-Bit SPI Serial CMOS EEPROM |
| CAT25C32U20SITE13 | 32K/64K-Bit SPI Serial CMOS EEPROM |
| CAT25C32U20STE13 | 32K/64K-Bit SPI Serial CMOS EEPROM |
| CAT25C32VS-1.8TE13 | 32K/64K-Bit SPI Serial CMOS EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CAT25C32V | 功能描述:電可擦除可編程只讀存儲器 (4kx8) 32K 2.5-6.0 RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| CAT25C32V-1.8 | 功能描述:電可擦除可編程只讀存儲器 (4kx8) 32K 1.8-6.0 RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| CAT25C32V-1.8-TE13 | 制造商:ON Semiconductor 功能描述:EEPROM Serial-SPI 32K-Bit 4K x 8 2.5V/3.3V/5V 8-Pin SOIC N T/R |
| CAT25C32VA | 功能描述:電可擦除可編程只讀存儲器 (4kx8) 32K 2.5-6.0 RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| CAT25C32VI | 功能描述:電可擦除可編程只讀存儲器 (4kx8) 32K 2.5-6.0 RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
發布緊急采購，3分鐘左右您將得到回復。