參數資料
型號: CAT3616HV4
英文描述: 6-Channel Charge Pump LED Driver with EZDimTM
中文描述: 6通道電荷泵式LED驅動器與EZDimTM
文件頁數: 10/14頁
文件大小: 508K
代理商: CAT3616HV4
CAT3616
Doc. No. 5018 Rev. A
10
2006 Catalyst Semiconductor, Inc.
Characteristics subject to change without notice
LED CURRENT SETTING
The LED current is controlled by toggling the input
signals ENM
and ENS
. ENM
controls the four LED
channels MAIN1 to MAIN4. ENS
lines SUB1 and SUB2. ENM
and ENS
way. The chip must first be enabled by setting the
enable input EN high. On the first ENM
transition from high to low, the LED current in the
associated LEDs is set to the full scale 31mA. On
each consecutive falling edge of ENM
LED current is decreased by 1mA. On the 32
nd
pulse,
the LED channel is turned off and the current drops to
0mA. One additional ENM
or ENS
current to 31mA, as shown on Figure 1.
controls the two LED
work the same
or ENS
or ENS
, the
pulse resets the full
Consecutive pulses should be separated by 300ns or
more. Pulsing frequencies from 5kHz up to 1MHz are
supported during dimming operations. When the EN is
held low for 1.5ms or more, the CAT3616 enters the
shutdown mode and draws “zero” current. When the
enable EN input is low, toggling ENM
effect.
or ENS
has no
Unused LED channels can be disabled independently
by connecting the corresponding main or sub LED pin
to VOUT.
Protection Mode
If an LED becomes open-circuit, the output voltage
VOUT is internally limited to about 5.5V. This is to
prevent the output pin from exceeding its absolute
maximum rating.
The driver enters a thermal shutdown mode as soon as
the die temperature exceeds about +165oC. When the
device temperature drops down by about 20oC, the device
resumes normal operation.
External Components
The driver requires a total of four external 1
μ
F
ceramic capacitors: two for decoupling input and
output, and two for the charge pump. Both capacitor
types X5R and X7R are recommended for the LED
driver application. In the 1.5x charge pump mode, the
input current ripple is kept very low by design, and an
input bypass capacitor of 1
μ
F is sufficient. In 1x mode,
the device operating in linear mode does not introduce
switching noise back onto the supply.
Recommended Layout
In 1.5x charge pump mode, the driver switches
internally at a high frequency of 1MHz. It is
recommended to minimize trace length to all four
capacitors. A ground plane should cover the area
under the driver IC as well as the bypass capacitors.
Short connection to ground on capacitors Cin and
Cout can be implemented with the use of multiple via.
A copper area matching the TDFN exposed pad
(GND) must be connected to the ground plane
underneath. The use of multiple via improves the
package heat dissipation.
相關PDF資料
PDF描述
CAT3616HV4-T2 6-Channel Charge Pump LED Driver with EZDimTM
CAT3626HS4-T2 6-Channel LED Driver with I2C Interface
CAT3626HV4-T2 6-Channel LED Driver with I2C Interface
CAT3636_07 6-Channel Quad-ModeTM Fractional LED Driver in TQFN3x3
CAT3636HV3-T2 6-Channel Quad-ModeTM Fractional LED Driver in TQFN3x3
相關代理商/技術參數
參數描述
CAT3616HV4-GT2 功能描述:LED照明驅動器 LED Driver,Charge pump,6 ch RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N
CAT3616HV4-T2 功能描述:LED照明驅動器 LED Driver,Charge pump,6 ch RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N
CAT3626 制造商:CATALYST 制造商全稱:Catalyst Semiconductor 功能描述:6-Channel LED Driver with I2C⑩ Interface
CAT3626_08 制造商:CATALYST 制造商全稱:Catalyst Semiconductor 功能描述:6-Channel LED Driver with I2C⑩ Interface
CAT3626AEVB 功能描述:BOARD EVALUATION DPP CAT3626A RoHS:是 類別:編程器,開發系統 >> 評估板 - LED 驅動器 系列:* 標準包裝:1 系列:PowerWise® 電流 - 輸出 / 通道:20mA 輸出及類型:1,非隔離 輸出電壓:17V 特點:可調光 輸入電壓:2.7 ~ 5.5 V 已供物品:板 已用 IC / 零件:LM3508 相關產品:LM3508TLX-ND - IC LED DRVR WHT BCKLGT 9USMDLM3508TLDKR-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLCT-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLTR-ND - IC LED DRVR WHT BCKLGT 9MICROSMD