- 您現在的位置：買賣IC網 > PDF目錄10901 > CC-2404K2N-CS5 (Copeland Communications Inc)MODEM 2400BAUD SERIAL 5V PDF資料下載
參數資料
| 型號： | CC-2404K2N-CS5 |
| 廠商： | Copeland Communications Inc |
| 文件頁數： | 4/64頁 |
| 文件大?。?/td> | 0K |
| 描述： | MODEM 2400BAUD SERIAL 5V |
| 標準包裝： | 30 |
| 數據格式： | V.21，V.22，V.23，Bell 103 |
| 波特率： | 2.4k |
| 電源電壓： | 4.2 V ~ 7 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 模塊 |
| 包裝： | 散裝 |
| 其它名稱： | 539-1011 CC-2400K2N-CS5 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
Data Sheet
World Modem NET
Page 12 of 64
2005 Copeland Communications, Inc.
World Modem NET Datasheet Rev 1.0
Reset – A hardware reset is provided to reset the modem controller on power-up or to force the modem back
to its default settings. This active low signal has an on-board pull up. Leave this pin unconnected if hardware
reset is not needed.
Network Interface
The World Modem NET contains an integrated, self contained Internet engine.
This engine accepts
commands via the serial interface and manages an internet communication session though the modem side.
The Network controller may be used to manipulate TCP/IP and UDP/IP sockets, as well and retrieve Web
server contents over HTTP 1.1. Optional firmware versions are available to sent textual email messages and
use FTP or serve as an Internet to serial router.
The Internet engine is controlled by AT+i commands.
These commands are only available on the serial
interface.
The World Modem NET enters Internet Mode after receiving a command that requires the interface (such as
sending an email or opening a socket). The controller will automatically attempt to initiate a connection and
carry out the requested task. While in this mode, AT+i commands can be used to monitor and control the
process as needed.
The World Modem NET enters Serial Network Mode extends the local asynchronous serial link to a TCP or
UDP socket across the Internet. The primary purpose is to allow simple devices to interact over a network in a
similar fashion as it would normally over a serial channel. The World Modem NET contains a number of
parameters to define the configuration of this interface. These include configuration as a Server or Client.
Reset
The World Modem NET may be reset by either asserting the -RESET signal or via the serial link. To reset
the controller via the serial link, a ‘BREAK’ must be asserted. A ‘BREAK’ signal is issued by transmitting a
LOW (zero) for a period that is longer than 23 bits at the current baud rate. Once a ‘BREAK’ is seen it takes
four seconds to complete the reset cycle.
The World Modem NET also includes an internal Watchdog. When enabled, the watchdog will physically
reset the circuit if a fault is detected. Sending an AT+iWDR forces the watchdog to initiate a reset.
Power
The module is powered by an external 3.3 VDC source. Pins 57 and 61 are tied together internally on 3.3V
models and either or both connected to an external 3.3V supply.
On 5V models, Pin 61 ONLY can be
connected to 5V. Pin 57 may still be used if a 3.3V power supply is required and 5V models are what is
available. There is no on-board regulation of the power supply. The system needs to supply approximately 50
mA of current.
The power pin(s) should be decoupled with a good quality 0.01 F ceramic capacitor and a 1F electrolytic or
tantalum capacitor.
WARNING: ONLY connect one (1) of the power supply pins to either 3.3V or
5V on 5V models.
Connecting both pins 57 and 61 to different power
supplies WILL damage the modem and/or the system it is installed in.
See CCI Common Socket Interface Specification for more details.
相關PDF資料 |
PDF描述 |
|---|---|
| SI3015-BS | IC ISOMODEM LINE-SIDE DAA 16SOIC |
| PIC16C54T-XTE/SO | IC MCU OTP 512X12 18SOIC |
| PIC16C54T-RC/SS | IC MCU OTP 512X12 20SSOP |
| VE-262-IX-F2 | CONVERTER MOD DC/DC 15V 75W |
| PIC16C54T-RC/SO | IC MCU OTP 512X12 18SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CC2406020N | 制造商:POWEREX 制造商全稱:Powerex Power Semiconductors 功能描述:Super Fast Recovery Dual Diode Modules 20 Amperes/300-600 Volts |
| CC240610 | 功能描述:DIODE MOD FST-REC DUAL 600V 100A RoHS:否 類別:半導體模塊 >> 二極管，整流器 系列:- 標準包裝:10 系列:- 電壓 - 在 If 時為正向 (Vf)（最大）:1.45V @ 30A 電流 - 在 Vr 時反向漏電:15µA @ 400V 電流 - 平均整流 (Io)（每個二極管）:30A 電壓 - (Vr)（最大）:400V 反向恢復時間(trr):65ns 二極管類型:標準 速度:快速恢復 = 200mA（Io） 二極管配置:2 個獨立式 安裝類型:底座安裝 封裝/外殼:ISOTOP 供應商設備封裝:ISOTOP? 包裝:管件 |
| CC240650 | 功能描述:DIODE MOD FST-REC DUAL 600V 50A RoHS:否 類別:半導體模塊 >> 二極管，整流器 系列:- 標準包裝:10 系列:- 電壓 - 在 If 時為正向 (Vf)（最大）:1.45V @ 30A 電流 - 在 Vr 時反向漏電:15µA @ 400V 電流 - 平均整流 (Io)（每個二極管）:30A 電壓 - (Vr)（最大）:400V 反向恢復時間(trr):65ns 二極管類型:標準 速度:快速恢復 = 200mA（Io） 二極管配置:2 個獨立式 安裝類型:底座安裝 封裝/外殼:ISOTOP 供應商設備封裝:ISOTOP? 包裝:管件 |
| CC2406500N | 功能描述:DIODE MOD FST-REC DUAL 600V 50A RoHS:否 類別:半導體模塊 >> 二極管，整流器 系列:- 標準包裝:10 系列:- 電壓 - 在 If 時為正向 (Vf)（最大）:1.45V @ 30A 電流 - 在 Vr 時反向漏電:15µA @ 400V 電流 - 平均整流 (Io)（每個二極管）:30A 電壓 - (Vr)（最大）:400V 反向恢復時間(trr):65ns 二極管類型:標準 速度:快速恢復 = 200mA（Io） 二極管配置:2 個獨立式 安裝類型:底座安裝 封裝/外殼:ISOTOP 供應商設備封裝:ISOTOP? 包裝:管件 |
| CC2410-000 | 功能描述:BOOT MOLDED STRAIGHT RoHS:是 類別:線纜，導線 - 管理 >> 熱收縮套，帽蓋 系列:* 標準包裝:1,000 系列:* 其它名稱:TC-CAPS-4005-8TC-CAPS-4005-8-ND |
發布緊急采購，3分鐘左右您將得到回復。