World Modem NET Page 21 of 64 2005 Copeland Communications, Inc. World Modem NET Datasheet Rev 1.0 Basic AT Command Set (Command Defau" />
參數資料
型號: CC-24K2N-CS5
廠商: Copeland Communications Inc
文件頁數: 14/64頁
文件大小: 0K
描述: MODEM WORLD NET 2400BAUD 5V
標準包裝: 30
數據格式: V.21,V.22,V.23,Bell 103
波特率: 2.4k
電源電壓: 4.2 V ~ 7 V
安裝類型: 表面貼裝
封裝/外殼: 模塊
包裝: 散裝
配用: 539-1002-ND - KIT EVALUATION WORLD MODEM II
Data Sheet
World Modem NET
Page 21 of 64
2005 Copeland Communications, Inc.
World Modem NET Datasheet Rev 1.0
Basic AT Command Set (Command Defaults in Bold) (Continued)
Command
Action
+IFC Options
Specifies the flow control to be implemented.
+IFC = A
A
Specifies the flow control method used by the host to control data from the modem.
0 None
1 Local XON/OFF flow control. Does not pass XON/XOFF character to the remot modem.
2 Hardware flow control (RTS).
B
Specifies the flow control method used by the modem to control data from the host.
0 None
1 Local XON/OFF flow control. Does not pass XON/XOFF character to the remot modem.
+IFC = A,B
2 Hardware flow control (CTS).
+ITF Options
Transmit flow control threshold.
+ITF = A
A
Threshold above which the modem will generate a flow off signal.
+ITF = A,B
< 0 to 511> bytes
B
Threshold below which the modem will generate a flow on signal
< 0 to 511> bytes
C
Polling interval for <EM><BNUM> indicator
+ITF = A,B,C
0 to 300 in 10 msec units.
Modulation reporting control.
X
Mode
0
Disabled
1
Enabled
If enabled, the intermediate result code is transmitted at the point during connect negotiation. The
format of this result code is asw follows:
+MCR: <carrier> e.g. +MCR: V32B
+MR = X
+MRR: <rate> e.g. +MRR: 14400
+MS Options
Modulation Selection.
+MS = A
A
Preferred modem carrier
+MS = A,B
V21
ITU-T V.21
+MS = A,B,C
V22
ITU-T V.22
+MS = A,B,C,D
V.22B
ITU-T V.22bis
+MS = A,B,C,D,E
V32
ITU-T V.32 (default for CC-14.4K2)
V.32B
ITU-T V.32bis
V34
ITU-T V.34 (default for CC-33K2)
V90
ITU-T V.90 (default for CC-56K2)
B
Automatic modulation negotiation
0
Disabled
1
Enabled
C,D Min rate/Min rx rate are optional numeric values that specify the lowest value at which the
DCE ma establish a connection. If unspecified (set to zero), the are determined by the carrier and
automode settings.
+MS =
A,B,C,D,E,F
E,F Max rate/Max rx rate are optional numeric values which specify the highest values which
specify the highest value at which the DCE may establish a connection. If unspecified (set to 0),
they are determined by the carrier and automode settings.
相關PDF資料
PDF描述
CC-92K2-IS MODEM 56KBAUD V.90 SERIAL 3.3V
CC-MX-LB69-ZM CONNECTCORE I.MX51 MODULE
CD22M3494MQZ96 IC CROSSPOINT SWITCH 16X8 44PLCC
CD4052BPWRE4 IC MUX/DEMUX DUAL 4X1 16TSSOP
CENGLH79520-10-403HC CARD ENGINE 32MB SDRAM
相關代理商/技術參數
參數描述
CC2-4K7KB24 制造商:TT Electronics / Welwyn 功能描述:RESISTOR 4K7 2W 10%
CC24MC24M26240033UM-02E 制造商:GRAND-TEK TECHNOLOGY 功能描述:IEEE488 1M PIG-BACK
CC24MC24M26240066UM-02E 制造商:GRAND-TEK TECHNOLOGY 功能描述:IEEE488 2M PIG-BACK
CC24MC24M26240131UM-02E 制造商:GRAND-TEK TECHNOLOGY 功能描述:IEEE488 4M PIG-BACK
CC24U3258 制造商:Black Box Corporation 功能描述:CLIMATECAB A/C SIDE PANEL FOR RM5005A-R3